2004 SUBARU OUTBACK exhaust system

8-34
Driving tips
F: Front
The tongue load can be adjusted by proper distribution
of the load in the trailer. Never load the trailer with
more weight in the back than in the front; approximate-
ly 60 percent of the trailer load should be in the front
and approximately 40 percent in the rear. Also, distrib-
ute the load as evenly as possible on both the left and
right sides.
Be sure that all cargo is firmly secured to prevent a
change in weight distribution while driving. „
Trailer hitches
Never drill the frame or under-body of your ve-
hicle to install a commercial trailer hitch. If you
do, dangerous exhaust gas, water or mud may
enter the passenger compartment through the
drilled hole. Exhaust gas contains carbon mon-
oxide, a colorless and odorless gas which is
dangerous, or even lethal, if inhaled. Also, drill-
ing the frame or under-body of your vehicle
could cause deterioration of strength of your
vehicle and cause corrosion around the drilled
hole.
yDo not modify the vehicle exhaust system,
brake system, or other systems when installing
a hitch or other trailer towing equipment. y Do not use axle-mounted hitches as they can
cause damage to the axle housing, wheel bear-
ings, wheels or tires.
Choose a proper hitch for your vehicle and trailer.
F
60% 40% 50%
50%
HS8021BB

10-2
Appearance care
Appearance careExterior care „
Washing
yWhen washing the vehicle, the brakes may
get wet. As a result, the brake stopping dis-
tance will be longer. To dry the brakes, drive the
vehicle at a safe speed while lightly pressing
the brake pedal to heat up the brakes.y Do not wash the engine compartment and ar-
eas adjacent to it. If water enters the engine air
intake, electrical parts or the power steering flu-
id reservoir, it will cause engine trouble or
faulty power steering respectively.
The best way to preserve your vehicle’s beauty is fre-
quent washing. Wash the vehicle at least once a
month to avoid contamination by road grime.
Wash dirt off with a wet sponge and plenty of luke-
warm or cold water. Do not wash the vehicle with hot
water and in direct sunlight.
Salt, chemicals, insects, tar, soot and bird droppings
should be washed off by using a light detergent, as re- quired. If you use a light detergent, make certain that
it is a neutral detergent. Do not use strong soap or
chemical detergents. All cleaning agents should be
promptly flushed from the surface and not allowed to
dry there. Rinse the vehicle thoroughly with plenty of
lukewarm water. Wipe the remaining water off with a
chamois or soft cloth.
NOTE y
Before having your vehicle washed in an auto-
matic car wash, retract the pillar mounted antenna
to prevent it from being damaged.y When having your vehicle washed in an auto-
matic car wash, make sure beforehand that the car
wash is of suitable type. Automatic car wash
brushes or other equipment may damage the rear
wiper and rear/roof spoiler (if equipped). T Washing the underbody
Chemicals, salts and gravel used for deicing road sur-
faces are extremely corrosive, accelerating the corro-
sion of underbody components, such as the exhaust
system, fuel and brake lines, brake cables, floor pan
and fenders, and suspension.
Thoroughly flush the underbody and inside of the
fenders with lukewarm or cold water at frequent inter-
vals to reduce the harmful effects of such agents.

10-6
Appearance care
proper ventilation. „
To help prevent corrosion
Wash the vehicle regularly to prevent corrosion of the
body and suspension components. Also, wash the ve-
hicle promptly after driving on any of the following sur- faces: y roads that have been salted to prevent them from
freezing in winter y mud, sand, or gravel
y coastal roads
After the winter has ended, it is recommended that the
underbody be given a very thorough washing.
Before the beginning of winter, check the condition of
underbody components, such as the exhaust system,
fuel and brake lines, brake cables, suspension, steer-
ing system, floor pan, and fenders. If any of them are
found to be rusted, they should be given an appropri-
ate rust prevention treatment or should be replaced.
Contact your SUBARU dealer to perform this kind of
maintenance and treatment if you need assistance.
Repair chips and scratches in the paint as soon as you find them.
Check the interior of the vehicle for water and dirt ac- cumulation under the floor mats because that could
cause corrosion. Occasionally check under the mats
to make sure the area is dry.
Keep your garage dry. Do not park your vehicle in a
damp, poorly ventilated garage. In such a garage, cor-
rosion can be caused by dampness. If you wash the
vehicle in the garage or put the vehicle into the garage
when wet or covered with snow, that can cause damp-ness.
If your vehicle is operated in cold weather and/or in ar-
eas where road salts and other corrosive materials are
used, the door hinges and locks, trunk lid lock, and
hood latch should be inspected and lubricated period-
ically.

14-4
Index
Disc brake pad wear warning indicators
............7-31
Dome light ............................................................ 6-2, 11-76
Door locks ....................................................................... 2-3
Door open warning lights .........................................3-15
Drive belts ....................................................................... 11-26
Driving Drinking ..................................................................... 7
Drugs .......................................................................... 7
Foreign countries .................................................. 8-6
Car/Mobile phone .................................................. 8
Pets ............................................................................. 9
Tips ............................................. 7-14, 7-19, 7-28, 8-6
Tired or sleepy ........................................................ 8
Snowy and icy roads ............................................ 8-12
E
Electrical system .......................................................... 12-3
Emergency Locking Retractor (ELR) ..................1-19
Engine
Compartment overview .......................................11-8
Coolant ...................................................................... 11-18
Exhaust gas (Carbon monoxide) ....................6, 8-3
Hood ........................................................................... 11-5
Oil ................................................................................. 11-11
Overheating ............................................................. 9-19
Starting ...................................................................... 7-10
Stopping .................................................................... 7-12Exterior care
................................................................... 10-2
F
Flat tires ............................................................................ 9-5
Floor mat .......................................................................... 6-21
Fluid level
Automatic transmission .......................................11-28
Brake ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. .. 1 1 -3 6
Clutch .......................................................................... 11-38
Power steering ........................................................ 11-35
Fog light switch ............................................................. 3-24
Folding down the rear seat .......................................1-14
Front Differential gear oil ................................................. 11-30
Fog light ..................................................................... 11-69
Seatbelt pretensioners ........................................1-34
Seats ........................................................................... 1-2
Turn signal light, parking light and
marker light ............................................................ 11-69
Front-wheel drive warning light ..............................3-15
Fuel .................................................................................... 7-2
Economy hints ......................................................... 8-2
Filler lid and cap ..................................................... 7-4
Gauge ......................................................................... 3-8
Requirements .......................................................... 7-2
Fuses ................................................................................. 11-59
Fuses and circuits ........................................................ 12-6