2004 SATURN L-SERIES clock

Filling Your Tank
{CAUTION:
Fuel vapor burns violently and a fuel re can
cause bad injuries. To help avoid injuries to
you and others, read and follow all the
instructions on the pump island. Turn off your
engine when you are refueling. Do not smoke
if you are near fuel or refueling your vehicle.
Keep sparks, ames and smoking materials
away from fuel. Do not leave the fuel pump
unattended when refueling your vehicle — this
is against the law in some places. Keep
children away from the fuel pump; never let
children pump fuel.The fuel ller cap is
located behind a hinged
door on the passenger’s
side of your vehicle. It
is tethered to the door to
prevent loss while
refueling. Make sure that
water, snow, and dirt
are kept away from the
ller cap and ller
pipe nozzle.
To remove the fuel cap, turn it slowly to the left
(counterclockwise). It will require about 1/2 of a turn to
remove the cap. The fuel cap has a spring in it; if
you let go of the cap too soon, it will spring back to the
right (clockwise).
{CAUTION:
If you get fuel on yourself and then something
ignites it, you could be badly burned. Fuel can
spray out on you if you open the fuel cap too
quickly.
CAUTION: (Continued)
5-8
ProCarManuals.com

CAUTION: (Continued)
This spray can happen if your tank is nearly full,
and is more likely in hot weather. Open the fuel
cap slowly and wait for any “hiss” noise to stop.
Then unscrew the cap all the way.
Be careful not to spill fuel. Clean fuel from painted
surfaces as soon as possible. SeeCleaning the Outside
of Your Vehicle on page 5-85.
When you put the fuel cap back on, turn it to the right
(clockwise) about 1/4 of a turn until you hear three
clicks. Make sure you fully install the cap. The diagnostic
system can determine if the fuel cap has been left off
or improperly installed. This would allow fuel to
evaporate into the atmosphere and may cause the
malfunction indicator lamp to come on. SeeMalfunction
Indicator Lamp on page 3-34.
Notice:If you need a new fuel cap, be sure to get the
right type. Your dealer can get one for you. If you get
the wrong type, it may not t properly. This may
cause your malfunction indicator lamp to light and
may damage your fuel tank and emissions system.
SeeMalfunction Indicator Lamp on page 3-34.
Filling a Portable Fuel Container
{CAUTION:
Never ll a portable fuel container while it is in
your vehicle. Static electricity discharge from
the container can ignite the gasoline vapor.
You can be badly burned and your vehicle
damaged if this occurs. To help avoid injury to
you and others:
Dispense gasoline only into approved
containers.
Do not ll a container while it is inside a
vehicle, in a vehicle’s trunk, pickup bed or
on any surface other than the ground.
Bring the ll nozzle in contact with the
inside of the ll opening before operating
the nozzle. Contact should be maintained
until the lling is complete.
Do not smoke while pumping gasoline.
5-9
ProCarManuals.com

1. You can remove the coolant surge tank pressure
cap when the cooling system, including the coolant
surge tank pressure cap and upper radiator
hose, is no longer hot. Turn the pressure cap slowly
counterclockwise (left) about one-quarter of a
turn. If you hear a hiss, wait for that to stop. This
will allow any pressure still left to be vented out the
discharge hose.
2. Then keep turning the pressure cap slowly, and
remove it.
3. Fill the coolant surge tank with the proper
DEX-COOL
®coolant mixture, to the COLD line.4. With the coolant surge tank pressure cap off, start
the engine and let it run until you can feel the upper
radiator hose getting hot. Watch out for the
engine cooling fans.
By this time, the coolant level inside the coolant
surge tank may be lower. If the level is lower, add
more of the proper DEX-COOL
®coolant mixture
to the coolant surge tank until the level reaches the
COLD line.
5. Then replace the pressure cap. Be sure the
pressure cap is hand-tight.
5-33
ProCarManuals.com

5. Push headlamp housing lever up to disengage
headlamp housing from headlamp housing
pocket.
6. Turn the bulb socket being replaced
counterclockwise one–quarter of a turn while
pressing the socket in rmly. Pull the socket
rearward until the bulb clears the headlamp housing,
and lift it up to access the bulb.7. Disconnect the wire connector from the bulb by
lifting the lock tab and pulling it away from the
plastic base.
8. Remove the bulb assembly and replace it with the
appropriate bulb.
5-48
ProCarManuals.com

Fog Lamps
1. Reach up from underneath the front body panel
and turn the bulb socket counterclockwise one–
quarter of a turn while pressing the socket in rmly.
Pull the socket rearward until the bulb clears the
fog lamp housing.
2. Disconnect the wire connector from the bulb by
lifting the lock tab and pulling it away from the
plastic base.
3. Remove the bulb assembly and replace it with the
appropriate bulb.
Center High-Mounted Stoplamp
(CHMSL) (Sedan)
1. Remove the center high mounted stop lamp cover
by pulling down on the cover edges.
2. Turn the bulb socket being replaced
counterclockwise one–quarter of a turn and remove
the bulb.
3. Replace it with the appropriate bulb.
5-49
ProCarManuals.com

Center High-Mounted Stoplamp
(CHMSL) (Wagon)
1. Open the liftgate.
2. Remove the center high mounted stop lamp cover
by pulling down on the cover edges.
3. Turn the bulb socket being replaced
counterclockwise one–quarter of a turn and remove
the bulb.
4. Replace it with the appropriate bulb.
Taillamps, Turn Signal, Stoplamps
and Back-up Lamps (Sedan)
1. Open the trunk.
2. Pull back with interior trim.
5-50
ProCarManuals.com

3. Remove fasteners from backside of taillamp
housing.4. Remove taillamp housing from body of vehicle.
5. Turn the bulb socket being replaced
counterclockwise one–quarter of a turn while
pressing the socket in rmly. Pull the socket
rearward until the bulb clears the taillamp housing.
6. Replace it with the appropriate bulb.
5-51
ProCarManuals.com

Taillamps, Turn Signal, Stoplamps
and Back-up Lamps (Wagon)
1. Open the liftgate.
2. Remove the interior access trim panel.
3. Turn the bulb socket being replaced
counterclockwise one–quarter of a turn while
pressing the socket in rmly. Pull the socket
rearward until the bulb clears the taillamp housing.
4. Replace it with the appropriate bulb.
Replacement Bulbs
Exterior Lamp Bulb Number
Headlamps —
High Beam 9005 HB39441732
Low Beam 9006 HB49441733
Front Park/Turn Lamps 34571999381
Front Side Markert Lamps W5W12092811
Stop/Taillamps P21/5W21019520
Rear Turn Lamps P21W21019521
Back-up Lamps P21W21019520
CHMSL PC16825085970
Fog Lamps 880L12450143
5-52
ProCarManuals.com