2004 MERCEDES-BENZ S600 brake pads

260 OperationDriving instructionsBrakesTo help prevent brake disk corrosion after
driving on wet road surfaces (particularly
salted roads), it is advisable to brake the
vehicle with considerable force prior to
parking. The heat generated serves to dry
the brakes.
If your brake system is normally only sub-
jected to moderate loads, you should occa-
sionally test the effectiveness of the
brakes by applying above-normal braking
pressure at higher speeds. This will also
enhance the grip of the brake pads.If the parking brake is released and the
brake warning lamp in the instrument clus-
ter stays on, the brake fluid level in the res-
ervoir is too low.
Brake pad wear or a leak in the system may
be the reason for low brake fluid in the res-
ervoir.
Have the brake system inspected immedi-
ately. Contact an authorized
Mercedes-Benz Center.
All checks and service work on the brake
system should be carried out by qualified
technicians only. Contact an authorized
Mercedes-Benz Center.
Only install brake pads and brake fluid
recommended by Mercedes-Benz.Warning!
G
After driving in heavy rain for some time
without applying the brakes or through wa-
ter deep enough to wet brake components,
the first braking action may be somewhat
reduced and increased pedal pressure may
be necessary to obtain expected braking ef-
fect. Maintain a safe distance from vehicles
in front.
Resting your foot on the brake pedal will
cause excessive and premature wear of the
brake pads.
It can also result in the brakes overheating,
thereby significantly reducing their effec-
tiveness. It may not be possible to stop the
vehicle in sufficient time to avoid an acci-
dent.
!Be very careful not to endanger other
road users when you apply the brakes.
Refer to the description of the Brake
Assist System (BAS) (
page 78).

261 Operation
Driving instructions
After hard braking, it is advisable to drive
on for some time, rather than immediately
parking, so that the air stream can cool
down the brakes faster.
Driving off
Apply the brakes to test them briefly after
driving off. Perform this procedure only
when the road is clear of other traffic.
Warm up the engine smoothly. Do not
place full load on the engine until the oper-
ating temperature has been reached.
When starting off on a slippery surface, do
not allow a drive wheel to spin for an ex-
tended period with the ESP switched off.
Doing so may cause serious damage to the
drive train which is not covered by the
Mercedes-Benz Limited Warranty.
Parking
Warning!
G
If other than recommended brake pads are
installed, or other than recommended brake
fluid is used, the braking properties of the
vehicle can be degraded to an extent that
safe braking is substantially impaired. This
could result in an accident.!When driving down long and steep
grades, relieve the load on the brakes
by shifting into a lower gear to use the
engine’s braking power. This helps pre-
vent overheating of the brakes and re-
duces brake pad wear.
!Simultaneously depressing the acceler-
ator pedal and applying the brake re-
duces engine performance and causes
premature brake and drivetrain wear.
Warning!
G
Do not park this vehicle in areas where com-
bustible materials such as grass, hay or
leaves can come into contact with the hot
exhaust system, as these materials could be
ignited and cause a vehicle fire.
To reduce the risk of personal injury as a re-
sult of inadvertent vehicle movement, be-
fore turning off the engine and leaving the
vehicle always:

Keep right foot on brake pedal.


Firmly depress parking brake pedal.


Move the gear selector lever to
positionP.


Slowly release brake pedal.


When parked on an incline, turn front
wheel towards the road curb.


321 Practical hints
What to do if …?
Display symbol
Display message
Possible cause
Possible solution
2
BRAKE PAD WEAR
VISIT WORKSHOP!
The brake pads have reached their wear
limit.

Have the brake pads replaced as soon as
possible.
;(USA only)3(Canada only)
BRAKE FLUID
VISIT WORKSHOP!
There is insufficient brake fluid in the res-
ervoir.

Risk of accident! Stop the vehicle and no-
tify an authorized Mercedes-Benz Center.
Do not add brake fluid! This will not solve
the problem.
;(USA only)!(Canada only)
PARK. BRAKE
RELEASE BRAKE!
You are driving with the parking brake en-
gaged.

Release the parking brake (
page 45).
Warning!
G
Driving with this message displayed can re-
sult in an accident. Have your brake system
checked immediately. Don’t add brake fluid
before checking the brake system. Overfill-
ing the brake fluid reservoir can result in
spilling brake fluid on hot engine parts and
the brake fluid catching fire. You can be se-
riously burned.
!If you find that the brake fluid in the
brake fluid reservoir has fallen to the
minimum mark or below, have the
brake system checked for brake pad
thickness and leaks.
!Brake pad thickness must be visually
checked by a qualified technician at the
intervals specified in the Service Book-
let.

409 Index
Automatic lighting control
Activating 129
Deactivating 130
Automatic locking when driving 106
Automatic transmission 164
Accelerator position 170
Comfortable program mode 170
Deactivating steering wheel gearshift
control 173
Emergency operation
(Limp Home Mode) 173
Fluid level 278
Gear ranges 166
Gear selector lever position 167
Gear shifting malfunctions 173
Kickdown 170
One-touch gearshifting 165
Program mode selector switch 170
Selector lever position 164
Starting the engine 43
Steering wheel gearshift control
(Speedshift) S 55 AMG 168
Transmission fluid 278
Winter program mode 171
Auxiliary fuse box 374B
BabySmart
TM
Airbag deactivation system 71
Compatible child seats 71, 401
Self-test 71
BabySmart
TM airbag deactivation
system 401
Backrest supports
Lumbar region 113
Shoulder region 112
Backup lamps 354, 358
Bulbs 354
BAS 78, 401
Messages in display 315
Batteries, SmartKey
Changing 350
Check lamp 90, 91
Replacing 349
Battery discharged
Jump starting 369
Battery, SmartKey with KEYLESS-GO*
Changing 351
Check lamp 95Battery, vehicle 280, 366
Charging 367
Disconnecting 367
Reconnecting 368
Reinstalling 367
Removing 367
Bi-Xenon headlamps 401
Block heater (Canada only) 293
Blocking
Rear window operation 74
Brake assist system (BAS) 401
Brake fluid 270, 394
Brake lamp bulbs 354
Brake lamp, high mounted 354
Brake pads
Message in display 321
Brakes 260
Warning lamp 305
Break-in period 258
Bulbs, replacing 353
Additional turn signals 353
Backup lamps 354
Brake lamps 354

420 IndexM
Main 390
Main Dimensions 390
Maintenance 12, 294
Malfunction
Displaying 150
Malfunction memory 150
Calling up 150
Manual headlamp mode 125
Manual operations
Fuel filler flap 351
Interior lighting control 130
Locking the vehicle 349
Sliding/pop-up roof 352
Unlocking the driver’s door 348
Unlocking the trunk lid 349
Massage function 113
MAXCOOL
Maximum cooling 186
Mechanical key 348
Memory function 121, 403
Recalling positions from
memory 122
Storing exterior rear view mirror
parking positions 122Storing key dependent settings 122
Menus 136
AUDIO 139
Distronic* 147, 209
In control system 137, 138
Malfunction memory 150
NAVI 147
Settings menu 151
Standard display 139
Submenus 136
TEL* 144
Trip computer 148
Microphone
Hands-free microphone 27
Miles/kilometers in speedometer
Setting 154
Mirrors
Activating exterior rear view mirror
parking position 175
Adjusting 38
Automatic antiglare for rear view
mirror 174
Exterior rear view mirror 38
Exterior rear view mirror parking
position 162Interior rear view mirror 38
Storing exterior rear view mirror
parking position 122
MON 270
MON (Motor Octane Number) 404
Mph or km/h in speedometer 154
Multicontour backrest* 112
Multifunction display 134, 404
Selecting language 155
Standard display 138
Multifunction display messages
ABC 313, 318
ABS 314
BAS 315
Brake fluid 321
Brake pads 321
Check engine 306
Coolant 323
Coolant level 322
Distronic* 315
Doors 325
Engine 306
Engine oil level 326