Page 412 of 464

412 Technical dataFuels, coolants, lubricants, etc.Engine oils
Engine oils are specifically tested for their
suitability in our engines. Therefore, only
use engine oils approved by
Mercedes-Benz. Information on approved
engine oils is available in the Factory Ap-
proved Service Products pamphlet, or at
your authorized Mercedes-Benz Center.Please follow FSS recommendations for
scheduled oil changes. Failure to do so
could result in engine damage not covered
by the Mercedes-Benz Limited Warranty.
Engine oil additives
Do not blend oil additives with engine oil.
They may damage the engine.
Damage or malfunctions resulting from
blending oil additives are not covered by
the Mercedes-Benz Limited Warranty.Air conditioning refrigerant
R-134a (HFC) refrigerant and special PAG
lubricating oil are used in the air condition-
ing system.Never use R-12 (CFC) or mineral-based lu-
bricating oil. Otherwise damage to the
system will occur.
Brake fluid
During vehicle operation, the boiling point
of the brake fluid is continuously reduced
through the absorption of moisture from
the atmosphere. Under extremely strenu-
ous operating conditions, this moisture
content can lead to the formation of bub-
bles in the system, thus reducing the sys-
tem’s efficiency.
Therefore, the brake fluid must be re-
placed every two years, preferably in the
spring.
Only brake fluid approved by
Mercedes-Benz is recommended. Your au-
thorized Mercedes-Benz Center will pro-
vide you with additional information.
!Always check the oil filler cap
(page 291) for important information
pertaining to the engine oil needing to
meet a specific Mercedes-Benz specifi-
cation (e.g. MB 229.5). If such informa-
tion is printed on the oil filler cap, only
use an engine oil from the list of ap-
proved engine oils in the Factory Ap-
proved Service Products pamphlet that
meets the specification indicated on
the oil filler cap.
Using engine oils of other specification
may cause the FSS to incorrectly deter-
mine the next service interval and will
result in engine damage not covered by
the Mercedes-Benz Limited Warranty.
Page 414 of 464

414 Technical dataFuels, coolants, lubricants, etc.Damage or malfunctions resulting from
poor fuel quality or from blending specific
fuel additives are not covered by the
Mercedes-Benz Limited Warranty.Coolants
The engine coolant is a mixture of water
and anticorrosion / antifreeze, which
provides:
Corrosion protection
Freeze protection
Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -22°F (-30°C) and corro-
sion protection.If the antifreeze mixture is effective
to -22°F (-30°C), the boiling point of the
coolant in the pressurized cooling system
is reached at approximately 266°F
(130°C).
The coolant solution must be used year
round to provide the necessary corrosion
protection and increase boil-over protec-
tion. Refer to Service Booklet for replace-
ment interval.
Coolant system design and coolant used
stipulate the replacement interval. The
replacement interval published in the
Service Booklet is only applicable if
MB 325.0 anticorrosion/antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification (see Facto-
ry Approved Service Products pamphlet)
are used to renew the coolant concentra-
tion or bring it back up to the proper level.To provide important corrosion protection,
the solution must be at least 45% anticor-
rosion/antifreeze (equivalent to freeze
protection to approx. -22°F [-30°C]). If you
use a solution that is more than 55% anti-
corrosion/antifreeze (freeze protection to
approx. -49°F [-45°C]), the engine temper-
ature will increase due to the lower heat
transfer capability of the solution. There-
fore, do not use more than this amount of
anticorrosion/antifreeze.
If the coolant level is low, water and MB
Anticorrosion /Antifreeze should be used
to bring it up to the proper level (have cool-
ing system checked for signs of leakage).
Please make sure the mixture is in accor-
dance with label instructions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality, con-
sult your authorized Mercedes-Benz
Center.
Page 434 of 464

434 Index
Residual heat 182
Seat ventilation* 113
Steering wheel gearshift control
(CLK 55 AMG) 165
Tow-away alarm 85
Deceleration
With Distronic* 232
Deep water see Standing water
Defogging
Windshield 176
Defrosting 177
Delayed switch-off
Interior lighting 148
Dialing
A number (telephone) 155
Difficulties
While driving see
Problems while driving
With starting 45
Digital speedometer 134
Direction of rotation (tires) 297
Discharged battery
Jump starting 388
Disconnecting
Vehicle battery 386Display
Selecting 143, 144
Display elements
Audio system 184
Displays
Digital speedometer 134
Distronic* 231
Messages 290, 320
Selecting 143
Service indicator 302
Showing malfunctions 138
Distance
Decreasing in Distronic* 237
Increasing in Distronic* 237
Setting in Distronic* 236
Warning function 237
Distance to empty (range)
Calling up 152
Distance warning function* 237
Activating 238
Deactivating 238
Distance warning lamp 237
Intermittent warning sound 237
Symbol in multifunction display 137Distronic* 229, 420
Activated 233
Activating 234
Calling up settings 137, 232
Cleaning system sensor 308
Cruise control lever 233
Deactivated 233
Deactivating 236
Deceleration 232
Decreasing distance 237
Decreasing time interval 236
Displays in the speedometer dial 231
Distance warning function 237
Distance warning lamp 316
Driving hints 238
Fine adjustment 235
Increasing distance 237
Increasing time interval 236
Intermittent signal tone 231
Menu 232
Messages in display 323
Sensor cover 308
Setting a higher speed 234
Setting a lower speed 235
Setting following distance 236
Page 448 of 464

448 IndexSeat heating* 114
Switching on/off rapid heating
with seat ventilation* 115
Switching on/off rapid heating
without seat ventilation* 114
Switching on/off seat heating
with seat ventilation* 115
Switching on/off seat heating
without seat ventilation* 114
with seat ventilation* 115
without seat ventilation* 114
Seat ventilation* 113
Switching off 113
Switching on 113
Seats 109
Adjusting 34
Easy entry/exit feature 109
Multicontour seat* 112
Seat heating* 114
Seat ventilation* 113
Selecting
Display 143
Selecting display 144Selector lever
Lock 44
Message in display 325
Self-test
BabySmart
TM
airbag deactivation system 72
Tele Aid* 258
Service
Calling up the service indicator 303
Major service (Service B) 302
Minor service (Service A) 302
Overdue 302
Spare parts 398
Types 302
When due 302
Service (maintenance) 302
Service and Warranty Booklet
Loss of 399
Service and warranty information 10
Service indicator 302
Calling up 303
Clearing 302, 303
Service life (tires) 297
Service System see FSSSetting
Convenience functions 141, 149
Cruise control 227
Daytime running
lamp mode 145, 146
Distronic* time interval 236
Following distance in Distronic* 236
Higher speed in cruise control 228
Higher speed in Distronic* 234
Hours (clock) 144
Individual vehicle settings 139
Interior lighting
delayed switch-off 148
Key-dependent memory 151
Lamps and lighting
(control system) 145
Language, multifunction display 143
Locator lighting 146
Lower speed in cruise control 228
Lower speed in Distronic* 235
Miles/kilometers
in speedometer 142
Minutes (clock) 145
Parking position for exterior
rear view mirrors 151