2004 MERCEDES-BENZ CLK COUPE lights

339
Practical advice
Tr ou bleshooting Aux
iliaryheatin g* Problem Pos
sible caus e/consequ ence Suggested solutions
The auxiliary heating is not
working. The fuel tank is only a quarter full. 6
Refuel at the nearest filling station. The battery check lamp on the auxiliary
heating remote control lights up in orange. The remote control batterie
sare nearly
dis charge d. 6
Change the remote control batte ries
(= page 356). The battery check lamp on the auxiliary
heating remot
e control flashes in oran ge. The remote control batteries are dis-
charg
ed. 6
Change the remote contro lbatte ries
(= page 356). 209en_d2.boo Seite
339 Dienstag, 25. Mai 2004 7:26 19

358 Practical advice
Changing bulbs Be
fore changing a bulb
! Only fit 12V bulbs of the same type as
before and of the correct wattage.
! Switch off the lights before changing a
bulbto avoid a short-cir cuit. !
Only hold bulbs with a clean, lint-free
cloth.
! Do not work with wet or greasy fingers.
! If the new bulb sti lldoes not light up,
visit a qualified specialist workshop,
e.g. a Merce des-Benz Service Centre.
! Have theLEDs and bulbs spec ifiedbe-
low replaced at a qualified specialist
workshop, e.g. a Mercedes-Benz Serv-
ice Centre. These are the:
! additional turn sign als in the exteri-
or mirrors
! third brake lamp
! front fog lamp bulbs
! xenon bulbs*
i Have the headlamp setting checked
regularly. G
Risk of inju ry Bulbs and lamps can be
come very hot. You
should therefore allow them to cool down
before you cha nge them.
Kee p bulbs out ofthe reach of children.
Never use abulb which has been dropped.
Such a bulb may explode and injure you.
H7 bulbs are pressurised and may explode
when they ar echanged. You should there-
fore wear eye protection and gloves when
you are changin gthem. G
Risk of injury Xe
non bulbs carry ahigh voltage. Do not re-
move the cover of the xenon bulb. Do not
change the xenon bulbs yourself. You should
hav e them chan gedat a qualified speci alist
workshop whic hhas th e necessary special-
ist knowledge and tools to carry out the
work requ ired. Mercedes-Benz recommends
that you use a Mercedes-Benz Service Cen-
tre for this purpose. In parti cular, work rele-
va nt to safety or onsafety-relate dsystems
must be carried out at a quali fied specialist
wor kshop. 209en_d2.boo Seite
358 Dienstag, 25. Mai 2004 7:26 19

359
Practical advice
Changing bulbs
Left headlamp, mirro rim age ofright
1 Housing cover for dipped-beam
headlamp /xenon headl amp
2 Housing cover for main-beam hea d-
lamp 3
Bulb holder for turn signal
4 Bulbholder for dipped-beam headlamp
5 Bulbholder for main-beam headlamp
6 Side lamps and parking lamps Changing the front turn signal lamps
6
Switch off the lights.
6 Open the bonnet ( =pa ge 244).
6 Turn bulb holder 3anti-clockwise
along with the bulb and remove the
holder.
6 Press the bulb in, turn it ant i-clockwise
and remove it from the holder. Ch
angi ngthe fron t bulb s P 82.10-2905-31 G
Risk of injury Vehicles with bi-xenon bulbs*:
Do not remove housing cover
1for the xe-
non bulb. Xenonbulbscarry ahigh vo lta ge.
Do not cha nge the xenon bulbs yourself. You
should have them changed at a qualified
specialist workshop which has the neces-
sary specialist knowledge and tools to carry
out the work required. Mercede s-Benz rec-
omm ends that you use a Merc edes-Benz
Service Centre for this purpose. In particu-
la r, work relevant to safety or on safety-
related systems must be carried out at a
qu alified specialist workshop. P 82.10-2906-31
==209en_d2.boo Seite
359 Dienstag, 25. Mai 2004 7:26 19

360 Practical advice
Changing bulbs
6
Press the new bulb into the hol der and
screw it in clo ckwise.
6 Place the bulb holder in the lamp and
turn itclockwise.
Ch anging the dipped-beam or main- beam hea
dlamps
6 Switch off the lights.
6 Open the bonnet ( =pa ge 244).
6 Turn appropr iate ho using cover 1or
2 anti- cloc kw ise and remove it.
6 Turn bulb holder 4or5 anti-clock-
wi se along with the bul band remove
the hol der.
6 Pull the bulb out of the bulb holder by
the base plate (not the glass bulb). 6
Insert the new bulb so that the base
plate:
!fits in the recess on the bulb holder
and
! lies level on the bulb holder
6 Place the bulb hol der in the lamp and
turn it clockwise.
6 Refit the appropriate housing cover
and turn it clockwise. Cha
nging the sid eand parking lamps
6 Switch off the lights.
6 Open the bonnet (= page 244).
6 Turn housing cover 2anti-clockwise
and rem ove it.
6 Remove bulb holder 6along with the
bulb. 6
Turn the bulb gently anti-clockwise and
remove it from the holder.
6 Insert the new bulb into the holder and
turn it clockwise.
6 Replac ethe housing cover and let the
tabs lock into place.
6 Refit the appropriate housing cover
and turn it clockwise.
6 Replac ethe bulb holder. 209en_d2.boo Seite
360 Dienstag, 25. Mai 2004 7:26 19

361
Practical advice
Changing bulbs Tail
lamp cl uster
Left bul bholder, mirror image of right
1 Brake lam ps
2 Turn signals
3 Reversing lamps
4 Side lamps
5 Rear fogl amp/ tail lamps 6
Switch off the lig hts.
6 Open the boot lid ( =page 84).
6 Roll the trim located in the area of the
appropriate tail lamp cluster to the
side.
6 Squeeze the reta ining clips and remove
the bul bholder along with the bulb.
6 Turn the bulb anti-clockwise and
remove it from the hol der.
6 Insert the new bulb into the holder and
turn it clockwise.
6 Replace the bulb holder. Make sure
that you hear the bul bhol der engage in
the retaining clips.
6 Roll the tri mback again. 1
Screws
6 Switch off the lights.
6 Undo the two screws and remove the
lamp unit.
6 Change the bulb and refit the la mpunit.
6 Screw the two screws back in. Ch
anging the rear bulbs P 82.10-2907-31 neu Licence plate
lighti ng P 82.10-2913-31209en
_d2.boo Seite 361 Dienstag, 25. Mai 2004 7:26 19

380 Practical advice
Jump-starting
6
Connect positive terminal 1to posi-
ti ve conta ct2 on your vehicle using
the jump lead. Start with the donor bat-
ter y.
6 Run the donor vehicle's engine at idling
speed.
6 Connect negative terminal 4of the
donor battery to negative contact 3of
your vehicle using the jump lead. Start
wi th the donor battery.
6 Start the engine.
6 You can now switch electrical consum-
ers back on. Do not under any circum-
stances switch on the lights. 6
First undo the jump leads from nega-
tive terminals 3and 4of the batter-
ies, and then from positi veterminals
1 and 2.
6 Have the battery checked at aqualified
specialist workshop, e.g. a Mercedes-
Benz Service Centre. 209en_d2.boo Seite
380 Dienstag, 25. Mai 2004 7:26 19

420 Technical terms
CAN system
(C ontroller A re
a N etwork)
Us es vehicle or environmental factors
to control certain functions of your ve-
hicle, such as central locking or the
wi ndscreen wipers, and transmits this
information to the ->operating system.
Th is system works through the inter-
connection of all the electronic sys-
tems in the vehicle.
CDI (C ommon Rail D ir
ec t I njection)
Diesel injection technology, inwhich all
cylinder shave a common feed line.
Fine injection nozzles al lowv ery pre-
cise dosage s,which reduces diesel
consumption.
Centring pin Threade dmetal pin. Tool for precise
positioning of the wheel on the wheel
hub when changing a tyre. Chassis number
Number determined by the manufac-
turerand affixed to the body, by which
each vehicle can be clearly identified.
Child seat rec ognition
Special child seats are available for ve-
hicles with automatic child seat recog-
nition on the front-passenger seat. If
you have fitted a child seat of this kind
to the front-passenger seat, the front-
passenger airbag is automatically disa-
bled (thePASSENGER AIRBAG OFF/7
warning lamp on the centre console
lights up).
Cockpit All the instruments, switches, buttons
and warning and indicator lamps within
the driver's reach, which are necessary
for monitoring and controlling the vehi-
cle. COMAN
DAPS*
(Co ckpit
Man agement and D ata
System)
Informat ion and operating centre for
various vehicle functions such as the
radio, DVD player, navigation system
with map display and other items of op-
tional equipment, e.g. DVD changer*,
Dolby Surround System*, TV tuner*,
telephone*.
Control unit Electronic component of the engine
electronics; controls engine and trans-
mission functions, e.g. ->automatic
transmission or ->ESP.
Cr uise co ntrol
System which enables a vehicle speed
set by the driver to be maintained auto-
matically. 209en_d2.boo Seite
420 Dienstag, 25. Mai 2004 7:26 19

436 Index
Explanation .. . . . . . . .. . . . . . . ..423
Key . . . . . . . .. . . . . . . .. . . . . . . ...80
Locking . . . . ..... . . ..... . . . ...82
Locking the veh icle . . . .... . . . . ..44
Loss of key . . ..... . . ..... . . . ..338
Malfunc tion .. . . . . . . .. . . . . 337, 338
Op ening . . . . ..... . . ..... . . . ...23
Starting the engine . . . . ..... . . . ..37
Kickdown . . . ..... . . . . 142,145, 147
Explanation .. . . . . . . .. . . . . . . ..423 L
Lap-shoulder seat belt .. . . . . ..4 7, 49
Licence plate lighti ng . ..... . . . ..357
Changing . . . ..... . . ..... . . . ..361
Display messag e.. . . . .... . . . ..301
Light sensor Display messag e.. . . . .... . . . ..302
Explanation .. . . . . . . .. . . . . . . ..423
Light switch . ..... . . . ..... . . . ..100
Lighting .. . . . .... . . . ..... . . . ..100
Changing the bulbs . . . ..... . . . .357
Dis play (display message) ... . . . .299
Ex ter ior.. . . . .... . . . ..... . . . ..357
Inte rior .. . . . .... . . . ..... . . . ..104
Setting (operating system) . . . . . . .122 Lights
Changing the bulbs . . . . . . .. . . . .357
Switc hingon . . . . . . . . . . . . .. . . . .. 39
Loadi ngguidelines . . . .. . . .. . . . .221
Locator lighting . . .. . . . . . . .. . . . .104
Locking From the inside
(central locking switch) . . . . ...... 89
Set ting autom atic
(o perating system) . . . . . . . . . . . . .125
Locking button Boot (KE YLES S GO) . . . . . . .. . . . .. 83
Locking mechanism Automatic . . . . . . .. . . . . . . .. . . . .. 88
Luggage net Front-passenger footwell . . . . . . . .221 M
Main fuse box . . . ..... . . . ..... .386
Main-beam he adlamps .. . . . . . . . .357
Chang ing. . .. . . . . . . . . . . .. . . . .360
Displ aymessag e.. . . . . . . .. . . . .300
Switching on .. . . . .... . . . ...40, 102
Malfunction memory . . .. . . . . . . . .116 Malfunctions
Messages in the mul ti-function
di splay .. . . . . .... . . . . .... . . . .116
Manu algearshift program ... . . . .143
CL K55 AM G . . .... . . . . .... . . . .145
Man ual transmission . . .... . . . . .137
Maximum speed Technical data . . . . . . . .. . . 395–397
Tr ailer towing . .... . . . . .... . . . .263
Memory function ... . . . . .... . . . . .97
Ex planation . . . .... . . . . .... . . . .424
Menu Au dio ... . . . . .... . . . . .... . . . .113
Di stronic . . . . . .... . . . . .... . . . .115
Ma lfunction memor y. . . .... . . . .116
Na vigat ion . . . .... . . . . .... . . . .114
Ov erview . . . . . .... . . . . .... . . . .110
Se ttings . . . . . .... . . . . .... . . . .116
St andard display ... . . . . .... . . . .112
Su bmenus in the Settings menu . .117
Te lep hone . . . . .... . . . . .... . . . .133
Tr ip computer . .... . . . . .... . . . .131
Mercedes-Benz Specificati ons
for Service Products sheet ... . . . .414 209en_d2.boo Seite
436 Dienstag, 25. Mai 2004 7:26 19