2004 MERCEDES-BENZ CLK COUPE engine

35
Getting started
Driving
6 Click bel ttongue 1into buckle 3.
6 Pull up on the shoulder belt to tighten
the belt across your lap if necessary.
!Do no tdepress the accelerator pedal when
st arting the engine.
i If you depress the brake pedal when starting
the engine, the pedal tra vel is longer than usual
and the pedal resistance is lo w.
If you depress the brake pedal after starting the
en gine, the pedal travel and resistance return to
normal. G
Riskof injury You could injure
yours elfin an accident if
you use seat belts which:
! aredamaged
! have been subjected to a loadin an acci-
dent
! have been modified
These seat belts can then nolong er function
or protect as intended.
Do not pass the seat belt strap over sharp
edges .It could tear.
Ma ke sure that th eseat belt isnot caught in
the door or seat adjustmen tmechanism. It
coul dbe damaged. G
Risk of injury Check the seat
belts regularly for damage.
You should never modify the seat belts your-
self. They might not function properly any
more.
Always have seat belts which are damaged
or have been subjected to a load in an
ac cident replaced ata qualifi edspecialist
workshop, which has the necessary special-
is t knowledge and tools to carry out the
required work. Mercede s-Benz recom mends
that you usea Merced es-Benz Service Cen-
tre for this purpose. In particular ,work rele-
vant to safety or on safety-related systems
must be carried out at a qualified specialist
workshop. Starting the engine
G
Risk of poisoning Never run
the engine wh enthe vehicle is in
an enclo sedsp ace. The exhaust fume scon-
tain poisonous carbon monoxide. Breathing
in exhaust fumes constitu tes a health haz-
ar dand could lead to unconscio usness and
death. 209en_d2.boo Seite
35Diens tag, 25 .Mai 2004 7:26 19

36 Getting started
DrivingManual transmission
Gearshift
pattern
6 Before starting the engine, make sure
that:
! the parking brake is engaged
(
= pag e43) to prevent the vehicle
rolling away
! the transm ission is in neutral
You will find further information about the
6-speed manual transmission in the
"Controls in deta il" section (
=page 137). Automatic
tran smission*
Gearshift pattern
P Park position
R Reverse gear
N Neutral
D Drive position
6 Before starting the engine, make sure
that:
!the parking brake is engaged
(=
page 43) to prevent the vehicle
rolling away
! the selector lever is inposition P i
Youcan also start the engine when the
selector lever is in position N.
You will find further information about the
automatic transmission in the "Controls in
detail" section ( =page 138). Starting the engine
i
Vehicle swith automatic transmission*:
You may also use the touch-start function. Turn
th ekey to position 3and rel ease itagain imme-
diatel y.The engine thenstarts aut omatical ly.
Petrol engine
6 Turn the key to position 3(= page 23)
in theignition lock and re leas eit aga in
as soon as the engine is running. P 26.60-2223-31 P 27.00-2180-31209en_d2.boo Seite
36Diens tag, 25 .Mai 2004 7:26 19

37
Getting started
Driving
Diesel engine
6 Turn the key to position 2in the igni-
tion lock.
The q preglow indica torla mp in the
ins trument clus terlights up.
6 As soon as the qpreglow indicator
lamp has gone out, turn the key in the
ignition lock to position 3and release it
as soon as the engine isrunning.
i Ifth e engine is already at operating temper-
ature, you can star tit without preglow. Starting the engine with KEYLESS GO*
You may start your
vehicle with no key in
the ignition lock using the KEYLESS GO
button on the selector lever. Yo
u can start the vehicle with no key in the
ignition lock using the KEYLESS GO button
on the selector lever, as long as the
KE YLE SSGO keyis in the vehicle.
1 KEYLESS GO button Petro
lengine
6 Depress thebr ake pedal.
6 Press KEYLESS GO button 1once.
The engine starts automatically.
Diese lengine
6 Depress thebr ake pedal.
6 Pres s KEYLESS GO button 1once.
The glow plugs are activated and the
engine starts automatically.
If the engine is already at operating tem-
perature, you can start it without preglow:
6 Pres s and hold KEYLESS GO button 1
until the engine is runn ing. G
Risk of accident Your vehicle can be started at any time if the
KEYLESS GO key is inside the vehicle. For
this reason, children should never be left
unsup
ervised in the vehi cle. They cou ldacci-
de ntally start the vehicle.
Ta ke the KEYLESS GO key with you, even if
you are only leaving th evehicle for ashort
time. P 82.00-
2271-31 neu 209en_d2.boo Seite
37Diens tag, 25 .Mai 2004 7:26 19

38 Getting started
Driving
6
Pull away immediately towa rm the
engine up qui ckly.
6 Do not run the eng ine at full speed until
it has reached operating temperature.
1 Release handle 6
Depress the brake pedal and keep it in
this position.
6 Release the parking brake. To do this,
pull release handle 1.
The 3 indicator lamp in the instru-
ment cluster goes out. !
Only select reverse gear when the vehicle is
stationary, otherwis eyou could damage the
transmission.
Do no tdrive at high engine speeds ifthe engine
is cold. This protects the engine.
i Thevehicle locks itsel fcentrally once you
have pulled away. The locking knobs in the do ors
drop do wn.
You can open the doors from the inside at any
time.
You may also switch off the automatic door lock-
ing fu nctio n (=
page 88) ( =page 125). 6-speed manual transmission
6
Depress the brake pedal and keep itin
this position.
6 Release the parking brake.
6 Depress the clutc hpe dal. After a cold start
Parking brake
P 42.20-2198-31 neu G
Riskofaccident Never leave children unsupervised in the
vehi
cle. They could release the parking
brake. This could lead to a serious or fatal
accident. Pulling away209en_d2.boo Seite
38Diens tag, 25 .Mai 2004 7:26 19

39
Getting started
Driving
6 Select either first or reverse gear.
6 Slowly release the clutch pedal and
carefully depress the accelerator.
! Change gear in good time. Make sure that
the enginespe eddoes notreach thered area in
the rev cou nter. There is otherwise a danger of
engine dam age.
Do not allow the wheels tospin, ifpossible. You
could otherwise damage the dri vetrain. Automatic
transmission*
i You can only move the selector lever tothe
re quired position by depressing the brake pedal.
Only then isthe selector lever lock disabled.
6 Depress the brake pedal and keep it in
this posi tion.
The selector lever lock is released.
6 Release the parking brake.
6 Move the selector lever to position D
or R.
i Wait for the shi ftprocess to complete
before pulling away.
6 Release the brake pedal.
6 Carefully depress the accelerator
pe dal.
i After a cold start, the automatic transmi s-
sion will shift at a higher engine spe ed. This helps
th e catalytic converter toreach its operati ng
te mperature more quickly. Dipped-
beam headlamps
The light switch is located on the dash-
board between the steering wheel and the
driver's door.
Light switch
1 Lights off
2 Dipped-beam headlamps on G
Risk of accident Do not shift down unle
ss the current driving
sp eed is within the permiss ible range for the
gear to be selected.
Do not change down for additio nal engine
braking ona slippery road surface. The drive
wheels could then lose their grip and the
vehi cle could skid. Youc ould lose control of
the vehicle and cause an acc iden t. Switching on the headlamps
P 82.10-2889-31 neu209en_d2.
boo Seite 39Diens tag, 25 .Mai 2004 7:26 19

42 Getting started
Drivingi
Vehicles with a rain sensor*:
The winds cree nw iper s are aut omatically
sw itched to intermittent wipe when the vehicle is
station ary.
The intermitt ent wipe stops as soon asyou open
the driver's or passenger door. Thi sprotects per-
sons get ting intoor out of the vehicle from being
sprayed. Intermittent wipe continu eswhe nyou:
! turn the com bination switch to IIor III
or when the engine isrunning and you:
! close the doors again
! move the selector lever toDor R(vehicles
with automatic tra nsmission*) Single wipe
6
Briefly push the combination sw itch up
to the pressure point in the direc tion of
arrow 1.
The windscreen wipers wipe once with-
out washer fluid.
Wi ping the windscreen using washer fluid
6
Push the combination swi tch beyond
the pressure point in the direction of
arrow 1.
The windscreen wipers wipe with
washer fluid.
i Wipe wit hwasher fluid, even ifit is rai ning.
This will help to prevent smears on the wind-
screen. Intermittent wipe
i
Vehicle swith a rain sensor*:
The rain sensor controls the windscreen wipers
au tomatically ,dependi ngon how wet the wind-
screen is.
6 Turn the com bination switch to I.
A wiper sweep takes place and subsequent
wipe intervals depend on how wetth e wind-
scree nis. 209en_d2.boo Seite
42Diens tag, 25 .Mai 2004 7:26 19

43
Getting started
Parking and locking
You have now completed your first trip.
You have stop ped your vehicle and have
parked properly. End your trip as follows.
i When yo u close a door, thewindows on the
same sid eclose.
On steep slopes, turn the front wheels towards
the kerbside. 1Parkin g brake
6 Depress parking brake 1firml y.
The 3 indicator lamp in the instru-
ment cluster rema ins lit while the
engine is running.
i On st eep slope s,turn the front whe els
to wards the kerbside. Vehicles with manua
l transmission
6 Select either first or reverse gear.
6 Turn the key to position 0in the igni-
ti on lock(
=page 23) and remove it.
The immobiliser isactivated.
6 Press the release button on the seat
belt (
=page 34). Parking and
locking G
Risk of accident On
ly remove the key from th eignition lock
when the vehic leis st ationary. You cannot
steer the vehicle with the key removed.
Never leave children unsupervised in the
vehicle. They could release the parking
brake. This could lead toaser ious or fatal
accid ent. G
Risk of entrapment As you close the doors,
make sure that
nobody has their fin gers in between the
door or the side window and the vehicle. Park
ing brake P 42.20-2199-31 neu Stopp
ingthe engine l 209en_d2.
boo Seite 43Diens tag, 25 .Mai 2004 7:26 19

44 Getting started
Parkin
gand lock ing Vehicles with automati
ctransmission*
6 Move the selector lever to P.
With the key 6 Turn the key to position 0in the igni-
tion loc k(
=pag e23)and remove it.
The immobiliser isactivated.
i You can only remove the key when the
selector lever isin position P.
6 Press the release button on the seat
belt (=
page 34).
With KEYLESS GO* 6 Press the KEYLESS GO button on the
selector lever.
The engine isswitched off and all the
lights in the in strument cluster go out.
The on-board electron ics have status 1
( = page 23).
6 Press the release button on the seat
belt (=
page 34). 6
Get out of the vehicle and close the
doors. Locking with the remote contr
ol
6 Press the ‹locking button on the
remote control ( =page 22 ).
The locking knobs in the doors drop
down. The turn signals flash three
time s/light up briefly. Locking with
KEYLESS GO*
1 Locking button on the door handle
6 After getting out ofthe vehicle, press
locking button 1on the door handle.
The locking knobs in the doors drop
down. The turn signals flash three
times.
The immobiliser is act ivated.
i When the door is ope ned,the on-board elec-
tronics have status 0, the sam eas the key having
bee n removed.
You will find further information about
locking in the "Controls in detail" section
( = page 78). Closing
G
Risk of injury Make sure that nobody can become trapped
as you close the doo
rs.
P80.20-2343-31209en_d2.boo Seite
44Diens tag, 25 .Mai 2004 7:26 19