2004 MERCEDES-BENZ CLK CABRIOLET reset

132 Controls in detail
Operating systemi
If you turn the key to position 0in the ig ni-
tion lock or remove it, all the val uesar ere set
after appro ximately four hours.
The val uesarenot rese t ifyou turn th ekey back
to position 1or 2during th istime .
Resetting con sumption statistics
Press and hol dthe reset button on the left
in the instrument cluster ( =page 12) until
the consumption statist ics have been
reset to "0".
Consumption statistics since the last reset
6
Press the ÿorè button repeat-
edly until you see theAfter startmes-
sage in the display.
6 Pres s the j ork button repeat-
edly until you see the
After resetmes-
sage in the display. 1
Long total distance recorder
2 Time elapsed since last reset
3 Average speed since last reset
4 Average fuel consumption since last
reset
5 Distance driven since last res et
Resetting consumption statistics
Press and hold the reset button on the left
in the instrument cluster (
=page 12) until
the consumption statistics have been
re set to "0". Calling
uptherange
6 Press the ÿorè button repeat-
edly unt ilyou see the
After startmes-
sage in the display.
6 Press the jork button repea t-
edl yuntil the
Range:message appears
in the display.
You will see in the display the approximate
dist ance which can becovered bythe
tank's contents.
P54.30-5232-31 P54.30-5233-31209en_d2.boo Seite
132 Dienstag, 25. Mai 2004 7:26 19

134 Controls in detail
Operating systemAccepting a call
You may
accept a call at anytime provided
your telephone is ready to receive calls.
You will see the following message inthe
display:
Audio system dis play
COM AND* system display 6
Press the íbutton.
You have accepted the call. You will
see the call duration in the dis play.
i If you do not wish to acc ept the call, press
the ì button. Endin
g a call
6 Press the ìbutton.
You have finished the call. The display
now show sthe operational readiness
symbol again.
Dialling a number from the telephone book
You may select and dial a number from the
telephone book at any time provided your
telephone is ready to receive calls.
6
Press the ÿorè button repea t-
edly until you see theTELmenu with
the operat ional readiness symbol in the
display.
6 Press the jork button. The operating system reads the tele-
phone book stored on the SIM card or
in the telephone. This could take up to
30 seconds. If there is:
! an audio system instal led, the
PROCESSINGmes sage appe arsin
the display
! a COMAND* system installed, the
PLEASE WAITmessage appears in
the display
6 Press the jork button repea t-
edl yuntil the name you are looki ng for
appears in the display.
The stored names are displayed alpha-
betically from A to Z, or Z to A.
Example of COMAND* system display 1 Name from the telephone book
2 Memory preset number
P54.30-5236-31 P54.30-5237-31
P54.30-5245-31209en_d2.boo Seite
134 Dienstag, 25. Mai 2004 7:26 19

135
Controls in detail
Operating system i
Ifyou press the jork button for
mo rethan one sec ond,the op erating syst em
scrolls through the names rapidly. Releasing the
button stops the rapid scroll.
If you do not wish to make a call, press the ì
button.
6 Press the íbutton.
The operating system dials the appro-
priate telephone number. If ther eis:
! an audio system installed, theDIALINGmessage appears in the
display
! a COMAND* system installed, the
CONNECTING CALLmessage appears
in the display If a connection is mad
e,you will see the
name of the person you are calling and the
call duration in the display.
Example ofaudio system display
If no connection is made, the operating
system stores the dialled number in the
red ialmemor y. Red
ialling
The operating system sto res the last tele-
phone numbers whi chwere dialled. This
means that you do not have to search
through the entire telephone book.
6 Pres s the ÿ orè button repeat-
edly until you see the
TELmenu with
the operational readiness symbol in the
display.
6 Press the íbutton.
You will see the first number in the
redial memory in the display.
Ex am ple of COM AND* system display
1 Number or name store din the redial
mem ory
2 Memo ry preset number
P54.30-5238-31 P54.30-5246-31
==209en_d2.boo Seite
135 Dienstag, 25. Mai 2004 7:26 19

136 Controls in detail
Operating system
6
Press the jork button repeat-
edly until the number you are looking
for is shown inthe display.
i Ifyou do not wish to make a call, press
the ì button.
6 Press the íbutton.
Th e operating system dials the appro-
pri ate telephone number.
If a connection ismade, you will see the
call dur ationa nd:
! the name in the display, if it is stored in
the telephone book
or
! the number of the person you are call-
ing Memory
preset number
The last numbers dialled are always
stored. The numbe rofst ored numbers
depends on the type of telephone you are
using.
Most recently dial led numbe r:
! Audio system displ ay:L1
! COMAND* system display:
LO
Numbers dialled previously:
!Audio system disp lay:
L2toLn
! COMAND* system display:
L1toLn 209en_d2.boo Seite
136 Dienstag, 25. Mai 2004 7:26 19

180 Controls in detail
Open-air
Clo sing all side windows
6 Pullthe soft top switch twice. Pull it
brie fly the first tim eand then pull and
hold until the side windows have
reached the desired hei ght. Resetting the side windows
The side windows must be reset if the bat-
tery was disconnected or discharged.
i Each side window must be reset separately.
6 Switch on the ignition.
6 Pull switch 1,2 ,3 or4 up until the
wi ndow is closed and hold the switch in
this posit ion for approximately one sec-
ond.
!Onlyopen the sliding /tilting sunroof if itis
free of snow and ice, otherwise malfunctions
may occur.
Do no tallow sharp-edged objects to protrude
th ro ugh the sliding /tilting sunroof. You could
otherwise damage the seals. i
From the outside it is also possible to:
! open the side windows usingth e summer
opening feature ( =page 183)
! closethe side windows using the conve n-
ience closing feature (
=page 184)
Opening and closing the sliding /tilti ng sunroof
The switch is located on the overhead con-
trol panel.
Sliding
/tilting sun roof operation
1 To open
2 To close
3 To raise at the rear
4 Tolower at the rear Sliding
/tilti ng sunroof* (Coup é) G
Risk of injury Make sure that nobody can become trapped
when closing the slidin
g/tilting sunroof. If
danger threatens, release the switch and
press the opening switch.
The sliding /tilting sunr oofglas s coul d break
in an accident.
If the vehicle overturns in an accident, there
is a risk of you being thrown through the
open sunroof ifyo u are not wearing your
seat belt correctly. For this reason, always
fast en your seat belt to reduce the ris kof
injury.
Remove the key from th eignition lock and
take it with you, even if you are only leavi ng
the vehicle for a short time. P77.20-2431-31209en
_d2.boo Seite 180 Dienstag, 25. Mai 2004 7:26 19

183
Controls in detail
Open-air Resetting the sliding
/tilting sunroof
The slidin g/tilting sunroof mus tbe reset
if:
! the battery was disconnected or dis-
charged
! the sliding /tilti ng sunroof was closed
manual ly(emergency operation)
(= page 343)
! the sliding /tilti ng sunroof can only be
opened with a jerk
! there was a mal function
6 Switch on the ignition.
6 Press the switch ( =pa ge 181) in the
direction of arrow 3unti lthe sliding /
tilting sunroof is fully raised at the rear. 6
Keep the switch pressed for approxi-
mately one secon dafter the sunroof is
raised.
6 Check that the slidin g/tilting sunroof
can (automatically) be fully opened
aga in (
=pa ge 180).
If you cannot (aut omatically) open the
sliding /tilti ng sunroof fully:
6 Reset the slidin g/tilting sunroof.
In warm weather, you may wish to ventilate
the vehicle before driv ing off. To do this,
the remote control can be used to simulta-
neously open:
! the slidin g/tilting sunroof* and
! the side windows
i Thesumm er opening feature can onl ybe
ac tivat edusing the remote control. 6
Point the tip of the remote control at
the driver's door handle.
6 Pres s the Πbutton on the remote
co ntro l to unlock thevehicle an dke ep
it pressed until the side windows and
the sliding /tilting sunroof* have
moved to the required position. Summer opening feature P8
0.00-2054 -31 209en_d2.boo Seite
183 Dienstag, 25. Mai 2004 7:26 19

197
Controls in detail
Driving systems
Distronic assists you when driving on
motorways or high-speed ma jor roads.
! If a slower vehicle is detected ahead,
Distronic causes your vehicle to brake
and maintain a preset distance from
the vehicle infront.
! If there is no vehicle in front, Distronic
ope rates in the same way as cruise
control* ( =page 197). Distronic*
G
Risk ofinjury Do not place your foot und
erthe brake
pedal, as it coul dbecome trapped. Distronic
may apply the brakes to prevent the vehicle
fro mexceeding the setsp eed. When this
happens, Distronic depresses the brake
pedal. G
Risk of accident Distronic cannot take account
ofroad and
tra ffic conditions.
Always pay attent ion to road and traffic con-
di tions, even when Distronic is activated.
Distronic is onlyan aid desig ned to assist
you when driving. You are respon sible for
maintaining a suffi cient distanc efro mother
vehicles, for driv ing at anappropriate speed
an d for bra king in good time.
Do not activate Distronic:
! if road and traffic conditi onsdonot per-
mit a constant driving speed to be main-
tained (e.g .dense traffic or winding
ro ad s). You could otherwise causean
accident
! on slippery road surfaces. The drive
whe elsmay lose their grip when braking
or acceleratin gand the vehicle could
skid
! when visibility is bad, e.g. infog, heavy
rain or snow G
Risk of accident Deactivate Distronic:
!
when chan ging fro mthe outside lan eto
the inside lane if vehicles on the outside
la ne are travelling more slowly
! when driving in a filter lane or mot orway
exit
! when dri ving incomplex road and traffic
co nd ition s,such as throu ghmotorway
roadworks
Otherwise, Dis tronic ma intains the stored
speed.
Distronic do esnot react:
! toas tationary obstacle, e.g. in a traffic
jam, or to a vehicle which has bro ken
do wn
! toan oncoming vehic lein the same lane
Distronic causes your vehicle to brake at a
maximum of 2 m/s2
. This is approximately
20% of the maximum braking force of your
vehicle. If this deceleration isinsufficient,
you will have to use the brake pedal to avoid
a collision. 209en_d2.boo Seite
197 Dienstag, 25. Mai 2004 7:26 19

265
Operation
Service
ASSYST, the A ctive S ervice Syst em, tells
you when the next service is due.
Approximately one month before the next
service is due ,one of the following mes-
sages will appear in the multi-function dis-
play while you are driving or the ignition is
switched on:Se rvice A in.. days
Se rvice A in.. km
Se rvice A due now!
TheService AorService Bmessages pro-
vi de information about the type of service
which is due. i
Thetime between individual services de-
pends on your sty leof driving. Amoderate style
of driving atmedium engine speeds and avoidi ng
short trips increase this time.
The service indicator is cleared automati-
cally after 30 seconds. You can also clear
it yourself.
6 Press the reset button on the left-hand
side of the instrument cluster
(
= page 12). If you have missed the service due date,
the following messages appear in the
multi-function display:
Service
A exceededby.. days
Service A exceededby.. km
A signal also sounds.
A qual ified specialist workshop, e.g. a
Mercedes-Benz Serv ice Centre, will reset
the service indicator after the service work
has been carr ied out.
i You could be in breach of rele vant regula-
tions by failing tohave the spe cified service
carried out. Service
P54.30-5239-31 Clearing the service indicator Missi
ngthe service due date 209en_d2.boo Seite
265 Dienstag, 25. Mai 2004 7:26 19