2004 MERCEDES-BENZ CL55AMG remote start

242 Controls in detailUseful featuresStep 11:
Press, hold for two seconds and re-
lease same button a second time to
complete the training process.
Some garage door openers (or other rolling
code equipped devices) may require you to
perform this procedure a third time to
complete the training.
Step 12:

Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3
or4).
Step 13:

To program the remaining two buttons,
repeat the steps above starting with
step 3.Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:Step 4:

Continue to press and hold the inte-
grated signal transmitter button (2,
3 or4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp1 will flash slowly and
then rapidly after several seconds.

Proceed with programming step 5 and
step 6 to complete.


243 Controls in detail
Useful features
Operation of integrated remote control
Switch on ignition.

Select and press the appropriate inte-
grated signal transmitter button (2,
3 or4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.Erasing the integrated remote control
memory

Switch on ignition.

Simultaneously hold down the signal
transmitter buttons 2and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp flashes rapidly1. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.Reprogramming a single integrated sig-
nal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:

Press and hold the desired signal trans-
mitter button (2, 3 or4). Do not re-
lease the button.

The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
iIf you sell your vehicle, erase the codes
of all three channels.

396 IndexDoor handle 28
Door unlock
With Tele Aid 237
Doors
Message in display 309
Opening from inside vehicle 96
Opening from outside 89
Downhill driving
Cruise control 196
Downshifting 158, 162, 165
Drink holder see Cup holder 224
Drinking and driving 247
Driving
Abroad 254
General instructions 42, 247
Hydroplaning 251
In winter 252
Problems 52
Safety systems 77
Through standing water 253
With Distronic* 207
Driving abroad 254
Driving instructions 247
Driving off 249Driving safety systems
ABS 77
BAS 78
ESP 79
Driving systems 195
ABC 210
Cruise control 195
Distronic* 198
Driving safety systems 77
Parktronic* 214
Vehicle level control 211
E
Easy-entry/exit feature 107
Activating 154
Electrical fuses 356
Electrical system 370
Electrically folding exterior rear view
mirrors 169
Electronic Stability Program see ESP 79,
384
Emergency calls
Initiating an emergency call 233
With Tele Aid 232
Emergency engine shut-down 358Emergency operation (Limp Home
Mode) 166
Emergency operations
Closing sliding/pop-up roof 335
Locking the vehicle 332
Opening sliding/pop-up roof 335
Remote door unlock 237
Unlocking the trunk lid 332
Unlocking the vehicle 331
Emergency tensioning device see
ETD 68, 384
Emission control 255
Ending
A call (telephone) 140
Engine 364
Compartment 260
Message in display 294
Starting 45
Starting with KEYLESS-GO* 46
Starting with the key 45
Turning off with the key 55
Engine cleaning 286
Engine compartment 260
Fuse box in 357
Hood 260

399 Index
Height adjustment
Head restraints 36
Steering wheel 39
Height adjustments
Vehicle level 211
High beam flasher 49, 123
High beam headlamps
Messages in display 315
Replacing bulbs 336
Switching on 123
High mounted brake lamp 337
Hood 260
Closing 261
Message in display 312
Opening 260
Hydroplaning 251
I
Identification labels
Certification label 362
Emission control label 362
Engine number 362
Information label, California version
Vacuum line routing for emission
control system 362VIN (vehicle identification
number) 362
VIN, visible 362
Ignition 31
Immobilizer 82
Activating 82
Deactivating 82
Indicator lamps see Lamps, indicator and
warning
Infant and child restraint systems 69
Installing 73
LATCH child seat mounts 74
Information
About service and warranty 10
Button for Tele Aid 235
Inside rear view mirror
Antiglare 167
Installing
Infant and child restraint systems 73
Wiper blades 342
Instrument cluster 21, 22, 126, 385
Cleaning 289
Coolant temperature gauge 127
Illumination 126Multifunction display 129
Outside temperature indicator 128
Selecting language 149
Instruments and controls see Cockpit 20
Integrated remote control
Canadian programming 242
Erasing memory 243
Hand-held transmitter 240
Operating 243
Rolling code programming 241
Interior illumination
Delayed switch-off 152
Interior lighting 124
Activating automatic control 124
Deactivating automatic control 125
Manual operation 125
Interior rear view mirror
Adjusting 40
J
Jump starting 351

400 IndexK
Key, mechanical 331
Key, SmartKey
Battery check lamp 89
Changing the batteries 333
Checking the batteries 91
Factory setting 89
Global locking 89
Global unlocking 89
Loss of 91
Positions in starter switch 31
Remote controls 88, 92
Restoring to factory setting 90
Selective setting 89
Starting the engine 45
Turning off the engine 55
Unlocking with 30
Key,SmartKey with KEYLESS-GO*
Changing the battery 334
Key-dependency memory
Settings 154
KEYLESS-GO start/stop button* 33
KEYLESS-GO* 385
Activating ignition with 33
Closing sliding/pop-up roof 194Closing windows 189
Locking the vehicle 95
Messages in display 313
Starting the engine 46
Turning off engine 56
Unlocking with 32
Keys 88
Kickdown 163, 385
Kilometers/miles in speedometer 148
Km/h or mph in speedometer 148
L
Lamp bulbs, exterior 336
Lamps, exterior
Front 336
Light sensor 315
Messages in display 315
Rear 337
Lamps, indicator and warning
ABS 292
Battery (SmartKey) 89, 94
Brakes 293
CHECK ENGINE 294
Coolant 306
Distronic*DTR* 200
Engine diagnostics 294
ESP 81, 295
Fuel reserve 296
Instrument cluster 296
PASSENGER AIRBAG OFF 71, 298
Seat belts 296
Service indicator 282
SRS 61
Tow-away alarm 84
Turn signals 23
Language
Multifunction display 149
Setting 149
LATCH child seat anchors 74
LATCH child seat mounts 74
Layout of poly-V-belt drive 363
Leather upholstery
Cleaning 290
Lever
For cruise control 202
License plate lamps
Replacing bulbs 337, 340
Light alloy wheels
Cleaning 289