2004 MERCEDES-BENZ CL500 clock

340 Practical hintsReplacing bulbsReplacing bulbs for rear lamps
Tail lamp assemblies
1Backup lamp (black socket)
2Turn signal lamp (white socket)
3Tail, standing and parking lamp (red
socket)
4Driver’s side: tail, parking and rear fog
lamp
Passenger’s side: tail and parking lamp
(red socket)

Switch off lights.

Open trunk.

Turn lock counterclockwise and move
the trim to the side.

Turn bulb socket counterclockwise and
pull out.

Gently twist bulb counterclockwise and
pull out of bulb holder.

Insert new bulb into the holder and turn
it clockwise.

Reinstall bulb socket.
The bulb socket should audibly click.

Replace trim and secure with lock. License plate lamp
1Screws

Switch off the lights.

Loosen both screws1 and remove
lamp.

Replace the tubular lamp and reinstall
it.

Retighten the screws.

345 Practical hints
Flat tire
1Jack support tube cover
Move cover1 toward rear by pressing
at point indicated by arrow.

Remove cover1 carefully to avoid
damage to the locking tabs.1Jack arm
2Jack support tube hole
3Crank

Insert jack arm1 fully into tube
hole2 up to the stop.

Keeping jack in this position, turn
crank3 clockwise until the jack base
meets the ground. Make sure the jack
is vertical (plumb line).

Continue to turn the crank until the tire
is a maximum of 1.2 in (3 cm) from the
ground.
Warning!
G
Insert the jack arm fully into the jack sup-
port tube hole up to the stop. Otherwise the
vehicle may fall from the jack and cause per-
sonal injury or damage to the vehicle.
Warning!
G
The jack is intended only for lifting the vehi-
cle briefly for wheel changes. It is not suited
for performing maintenance work under the
vehicle.

Never start the engine when the vehicle
is raised.


Never lie down under the raised vehicle.

347 Practical hints
Flat tire
Lowering the vehicle
Lower vehicle by turning crank coun-
terclockwise until vehicle is resting ful-
ly on its own weight.

Remove the jack.
1-5 Wheel bolts

Tighten the five wheel bolts evenly, fol-
lowing the diagonal sequence illustrat-
ed (1 to5), until all bolts are tight.
Observe a tightening torque of
110 lb-ft (150 Nm).

Before storing the jack in the trunk, it
should be fully collapsed, with handle
folded in.

Place the wheel bolt wrench, alignment
bolt and jack back in the vehicle tool kit
in the trunk and close the covering lid.Replacing jack support tube cover

Slide tongue of cover under the upper
edge of the tube opening.

Applying even pressure, press cover
until it snaps into place. Be careful not
to damage the locking tabs or clamp
the plastic retaining strap.
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
110 lb-ft (150 Nm).
!You can also screw the faulty wheel
down into the spare wheel well in the
trunk.
Do not activate the tire inflation pres-
sure monitor until the depressurized
tire is no longer in the vehicle.

350 Practical hintsBatteryReconnecting the battery
Turn off all electrical consumers.

Connect the positive lead and fasten its
cover 4.

Connect negative lead3.Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12-volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.!Never invert the terminal connections.!The battery, its filler caps and the vent
tube must always be securely installed
when the vehicle is in operation.
iThe following procedures must be car-
ried out following any interruption of
battery power (e.g. due to reconnect-
ing):

Set the clock (see COMAND opera-
tor’s manual).


Resynchronize the ESP
(page 303).


Resynchronize side windows
(page 190).


Resynchronize sliding/pop-up roof
(page 194).

355 Practical hints
Towing the vehicle
Installing towing eye bolt
1Cover on right side of front bumper
2Cover on right side of rear bumperRemoving cover

Press mark on cover in direction of ar-
row.

Lift cover off to reveal threaded hole for
towing eye bolt.
Installing towing eye bolt

Take towing eye bolt and wheel wrench
out of trunk (
page 329).

Screw towing eye bolt clockwise into
its stop and tighten with wheel wrench.
Removing towing eye bolt

Loosen towing eye bolt counterclock-
wise with wheel wrench.

Unscrew towing eye bolt.

Store towing eye bolt and wheel
wrench in trunk.
Installing cover

Fit cover and snap into place.
!When towing the vehicle with all wheels
on the ground, please note the follow-
ing:
With the automatic central locking acti-
vated and the SmartKey in starter
switch position2, or KEYLESS-GO*
start/stop button in position2, the ve-
hicle doors lock if the left front wheel
as well as the right rear wheel are turn-
ing at vehicle speeds of approx. 9 mph
(15 km / h) or more.
Switch off the tow-away alarm
(page 84).
To prevent the vehicle door locks from
locking, deactivate the automatic cen-
tral locking (
page 153).
Towing of the vehicle should only be
done using the properly installed tow-
ing eye bolt. Never attach tow cable,
tow rope or tow rod to the vehicle chas-
sis, frame or suspension parts.

393 Index
Child safety switch see Blocking of rear
window operation 75
Cigarette lighter 228
CL 55 AMG Kompressor
MANUAL shift program mode 164
Cleaning
Cup holder 289
Distronic* system sensor cover 287
Gear selector lever 289
Hard plastic trim items 289
Headlamps 170
Headliner and shelf below rear
window 289
Instrument cluster 289
Leather upholstery 290
Light alloy wheels 289
Nubuck leather upholstery 290
Parktronic* system sensor 287
Plastic and rubber parts 290
Seat belts 289
Steering wheel 289
Upholstery 290
Windows 288Windshield 51
Wiper blades 287
Wood trims 290
Clock 23
Closing
Cup holder 226
Glove box 221
Hood 261
Power window with
KEYLESS-GO* 189
Power window with SmartKey 188
Side windows 187, 188
Sliding/pop-up roof 191, 335
With SmartKey 193
Sliding/pop-up roof with
KEYLESS-GO* 194
Trunk 98
Windows 186
Closing sliding/pop-up roof
In an emergency 335
Cockpit 20, 383
Cockpit management and data system
(COMAND) 384COMAND 384
COMAND see separate operating instruc-
tions
Combination switch 123
High beam flasher 49, 123
Turn signals 49
Windshield wipers 50
Consumer information 380
Control and operation of radio
transmitters 254
Control system 129, 384
AUDIO menu 134
Checking oil level 262
Convenience submenu 154
Display digital speedometer 134
Distronic* menu 142
Functions 131, 133
Instrument cluster submenu 148
Lighting submenu 149
Malfunction memory menu 144
Menus 132, 133
Multifunction display 129
Multifunction steering wheel 130

395 Index
Limiting opening height of
trunk lid 153
Rear window defroster 182
Residual heat 184
Seat heater 113, 114
Seat ventilation* 115
Tow-away alarm 84
Deactivating steering wheel gearshift
control 166
Deceleration
With Distronic* 201
Deep water see Standing water 253
Defrosting 179
Delayed switch-off
Interior illumination 152
Dialing
A number (telephone) 140
Difficulties
While driving see Problems while
driving 52
Digital clock 23
Digital speedometer 134
Direction of rotation (tires) 271
Discharged battery
Jump starting 351Disconnecting
Vehicle battery 349
Displays
Digital speedometer 134
Distronic* 200
Messages 263, 299
Service indicator 282
Showing malfunctions 145
Distance
Decreasing in Distronic* 206
Increasing in Distronic* 206
Setting in Distronic* 205
Warning function 206
Distance to empty (range)
Calling up 143
Distance warning function* 206
Activating 207
Deactivating 207
Distronic* warning lamp 206
Intermittent warning sound 206
Symbol in multifunction display 142
Distronic* 198, 384
Activated 202
Activating 203
Calling up settings 142, 201Cleaning system sensor 287
Cruise control lever 202
Deactivated 202
Deactivating 205
Deceleration 201
Decreasing distance 206
Decreasing time interval 205
Displays in the speedometer dial 200
Distance warning function 206
Driving hints 207
Fine adjustment 204
Increasing distance 206
Increasing time interval 205
Intermittent signal tone 200
Menu 201
Messages in display 302
Resetting stored speed 204
Sensor cover 287
Setting a higher speed 203
Setting a lower speed 204
Setting following distance 205
Setting the current speed 203
Warning and indicator lamps 200
Door control panel 19, 28

407 Index
Setting
Convenience functions 154
Cruise control 196
Daytime running lamp mode 150
Digital clock 23
Distronic* time interval 205
Exterior rear view mirror parking
position 156
Following distance in Distronic* 205
Higher speed in cruise control 197
Higher speed in Distronic* 203
Individual vehicle settings 145
Interior illumination delayed
switch-off 152
Lamps and lighting (control
system) 149
Language, multifunction display 149
Locator lighting 150
Lower speed in cruise control 197
Lower speed in Distronic* 204
Miles/kilometers in
speedometer 148
Parking position for exterior rear view
mirrors 156
Slower speed in cruise control 197SmartKey dependent memory 154
Speed in cruise control 197
Speed in Distronic* 203
Speedometer display mode 148
Suspension tuning 210
Temperature (interior) 176
Temperature indicator 148
Units
Speedometer 148
Temperature 148
Vehicle level control 211
Settings
Calling up Distronic* 142, 201
Convenience functions 154
Factory, SmartKey 89
Individual (SmartKey) 154
Lighting (control system) 149
Menus and submenus 131
Resetting all (control system) 146
Resetting in the submenu 146
Selective 89, 94
Settings menu
Functions in 145
Individual vehicle settings 145
Submenus 146Shift lock 387
Shifting
Gear selector lever positions 160
Into optimal gear range (automatic
transmission) 158
Shoulder support
Seat adjustment 111
Side impact airbags 65
Side marker lamps
Replacing bulbs 336, 337, 339
Side windows
Automatic closing 188
Automatic opening 187
Cleaning 288
Closing 186, 187
Closing fully (Express-close) 188
Closing with KEYLESS-GO* 189
Closing with SmartKey 188
Opening 186, 187
Opening fully (Express-open) 187
Opening with SmartKey 188
Stopping 188
Simultaneous wiping and washing
Windshield wipers 51
Single wipe 51