Page 150 of 400

150 Controls in detailGood visibility
Activating exterior rear view mirror
parking position*
Follow these steps to activate the mirror
parking position so that the
passenger-side exterior rear view mirror
will be turned downward to the stored
position.
Make sure you have stored a parking
position for the passenger-side exterior
rear view mirror (
page 101).
Make sure the
MIRROR SETTING WHEN
PARKING
function in the
CONVENIENCE
submenu of the control system is
switched to
ON (page 136).
Switch on ignition (if not already on).
Press button2 for the passenger-side
exterior rear view mirror.
Place the gear selector lever in reverse
gearR.
The passenger-side exterior rear view
mirror will be turned downward to the
stored position.
1Driver’s side exterior rear view mirror
button
2Passenger-side exterior rear view
mirror button
Warning!
G
In the case of an accident liquid electrolyte
may escape from the mirror housing if the
mirror glass breaks.
Electrolyte has an irritating effect. Do not
allow the liquid to come into contact with
eyes, skin, clothing, or respiratory system.
In case it does, immediately flush affected
area with water, and seek medical help if
necessary.Warning!
G
Exercise care when using the passen-
ger-side exterior rear view mirror. The mirror
surface is convex (outwardly curved surface
for a wider field of view). Objects in mirror
are closer than they appear. Check your
interior rear view mirror or glance over your
shoulder before changing lanes.
!Electrolyte drops coming into contact
with the vehicle paint finish can be
completely removed only while in the
liquid state by applying plenty of water.
Page 153 of 400

153 Controls in detail
Good visibility
Rear window defroster
The rear window defroster uses a large
amount of power. To keep the battery
drain to a minimum, switch off the
defroster as soon as the rear window is
clear. The defroster is automatically
deactivated after approximately
6 to 17 minutes of operation depending on
the outside temperature.
Activating
Climate control:
Press buttonF (
page 155).
Automatic climate control*:
Press buttonF (page 163).
The indicator lamp on the button
comes on.Deactivating
Press buttonF again.
The indicator lamp on the button goes
out.Warning!
G
Any accumulation of snow and ice should be
removed from the rear window before
driving. Visibility could otherwise be
impaired, endangering you and others.
!If the rear window defroster switches
off too soon and the indicator lamp
starts flashing, this means that too
many electrical consumers are
operating simultaneously and there is
insufficient voltage in the battery. The
system responds automatically by
deactivating the rear window defroster.
As soon as the battery has sufficient
voltage, the rear window defroster
automatically turns itself back on.
Page 158 of 400

158 Controls in detailClimate controlDefrosting
Activating
Press buttonP (
page 155).
The indicator lamp on the button
comes on.
or
Switch off air recirculation, if selected.
Press buttonO (
page 155).
The indicator lamp on the button goes
out.
Close center air vents (
page 155).
Open left and right side air vents
(page 155) and adjust side air vents
upwards.Deactivating
Press buttonP (
page 155).
The indicator lamp on the button goes
out. Defrosting is turned off.
Air recirculation mode
Switch to air recirculation mode to prevent
unpleasant odors from entering the vehicle
from the outside. This setting cuts off the
intake of outside air and recirculates the
air in the passenger compartment.Activating
Press buttonO (
page 155).
The indicator lamp on the button
comes on.
iThese settings should only be selected
for a short time.
Warning!
G
When the outside temperature is
below 41°F (5°C), only switch to air
recirculation mode for short periods to
prevent window fogging.
iIf you keep buttonO pressed the
side windows and sliding/pop-up roof*
will close.Warning!
G
Never operate the side windows and the
sliding/pop-up roof* if there is the
possibility of anyone being harmed by the
closing procedure.
In the event that the closing procedure
causes potential danger, the closing of the
side windows can be immediately halted by
pressing or pulling the respective window
switch. The closing of the sliding/pop-up
roof* can be immediately halted by moving
the sliding/pop-up roof* switch in the
overhead control panel in any direction.
Page 165 of 400

165 Controls in detail
Automatic climate control*
Setting the temperature
Use temperature controls1 ande for
the left side or6 and7 for the right side
(page 163) to separately adjust the air
temperature on each side of the passenger
compartment. You should raise or lower
the temperature setting in small incre-
ments, preferably starting at 72°F (22°C).Increasing
Push temperature control1
and/or6.
The automatic climate control system
will correspondingly adjust the interior
air temperature.
Decreasing
Push temperature control7
and/ore.
The automatic climate control system
will correspondingly adjust the interior
air temperature.
Adding outside air
Turn thumbwheel3 in dashboard
(page 163) to increase airflow of
outside air through air vents for center,
left and right sides and rear passenger
compartment.
iSevere conditions (e.g. strong air
pollution) may require replacement of
the filter before its scheduled interval.
A clogged filter will reduce the air
volume to the interior.
If the vehicle interior is hot, ventilate
the interior before driving off.
Keep the air intake grille in front of the
windshield free of snow and debris.
Do not obstruct air flow by placing
objects on the air flow-through exhaust
slots below the rear window.
iWhen operating the climate control
system in automatic mode, you will
only rarely need to adjust the tempera-
ture, air volume and air distribution.
Page 168 of 400

168 Controls in detailAutomatic climate control*
Deactivating
Press buttonO (
page 163).
The indicator lamp on the button goes
out.The air recirculation mode is deactivated
automatically:
after five minutes if the outside
temperature is below
approximately 41°F (5°C)
after five minutes if the air conditioning
is turned off
after 30 minutes if the outside
temperature is above
approximately 41°F (5°C)
At outside temperatures above 79°F
(26°C) the system will not automatically
switch back to outside air. A quantity of
outside air is added after approximately
30 minutes.
iIf you keep buttonO pressed, the
side windows and the sliding/pop-up
roof* will close.Warning!
G
Never operate the side windows and the
sliding/pop-up roof* if there is the
possibility of anyone being harmed by the
closing procedure.
In the event that the closing procedure
causes potential danger, the closing of the
side windows can be immediately halted by
pressing or pulling the respective window
switch. The closing of the sliding/pop-up
roof* can be immediately halted by moving
the sliding/pop-up roof* switch in the
overhead control panel in any direction.
The closing of the side windows and
sliding/pop-up roof* can be reversed by
again pressing and holding theO button.
iThe air recirculation mode is activated
automatically:
at high outside temperatures
if the concentration of carbon mon-
oxide and nitrogen oxide in the out-
side air increases, for example in a
tunnel (charcoal filter activated)
Please note that the charcoal filter
must be activated (
page 169) for
the air recirculation mode to be
activated automatically.
If you have turned off the air
conditioning (
page 170) or the out-
side temperature is below 41°F (5°C),
the air recirculation mode will not
switch on automatically.
iIf you keep buttonO pressed, the
side windows and the sliding/pop-up
roof* will return to their previous
position.
Page 169 of 400

169 Controls in detail
Automatic climate control*
Charcoal filter
An activated charcoal filter markedly
reduces bad odors and removes pollutants
from air entering the passenger compart-
ment.
Activating
Press buttone (
page 163).
The indicator lamp on the button
comes on.
The system switches automatically to the
air recirculation mode if the carbon
monoxide (CO) or nitrogen oxide (NO
X)
concentration of the outside air increases
beyond a predetermined level.Deactivating
Press buttone (
page 163).
The indicator lamp on the button goes
out.
The automatic air recirculation mode does
not function if theAC
OFF
mode is selected
or if the outside temperature has fallen
below 41°F (5°C).
The activated charcoal filter should be
switched off when windows fog up on the
inside, or if the passenger compartment
needs to be quickly heated or cooled
down.
iIf you keep buttone pressed, the
side windows and the sliding/pop-up
roof* will close.
Warning!
G
Never operate the side windows and the
sliding/pop-up roof* if there is the
possibility of anyone being harmed by the
closing procedure.
In the event that the closing procedure
causes potential danger, the closing of the
side windows can be immediately halted by
pressing or pulling the respective window
switch. The closing of the sliding/pop-up
roof* can be immediately halted by moving
the sliding/pop-up roof* switch in the
overhead control panel in any direction.
The closing of the side windows and
sliding/pop-up roof* can be reversed by
again pressing and holding thee button.
iIf you keep buttone pressed, the
side windows and the sliding/pop-up
roof* will return to their previous
position.
Page 180 of 400
180 Controls in detailAudio systemDirect frequency input
Select the desired frequency band.
Press“ button.
Enter desired frequency using
buttons4 toM.Manual tuning
Select the desired frequency band.
Press and hold either thed or
cbutton until the desired
frequency is reached.
Step-by-step station tuning takes place
in ascending or descending order of
frequency. The first three tuning steps
will take place without muting. After-
wards, the radio will be muted and
highspeed tuning will take place until
the button is released.Automatic seek tuning
Select the desired frequency band.
Press either thef or ebutton.
The radio will tune to the next higher or
next lower receivable frequency.
iYou can only enter frequencies within
the respective waveband.
If a button is not pressed within four
seconds, the radio will return to the
station last tuned to.
Page 185 of 400

185 Controls in detail
Audio system
Program type (PTY) mode
In PTY mode, you can tune in and select
channels of a specific program type.
Calling up PTY mode
Start SAT radio mode.
Press the
PTY
key.
The name of the channel currently
being received is shown.
Leaving PTY mode
Press the
CH
key.
The number of the channel currently
being received is shown.Selecting channel category
Pressd or cbutton.
The individual program types are se-
lected.
Tuning in a PTY channel
Once you have selected a program type,
you can tune in channels broadcasting a
program that corresponds to the selected
program type.
Pressf or ebutton.
The radio will tune to the next highest
or lowest channel broadcasting this
type of program.Program Descriptive Text (PDT)
In PDT mode, you can call up additional in-
formation on the channel, the current track
and the performing artist(s).
Press the
TXT
key.
The station category appears on the
display.
Press the
TXT
key again within four
seconds.
The title of the current track appears.
Press the
TXT
key again within four
seconds.
The name of the musician(s) of the cur-
rent track appear on the display.