Page 239 of 256

Use the recommended cold inflation pressure for optimum tire
performance and wear. Under-inflation or over-inflation may cause
uneven treadwear patterns.
NOTE:If you are driving the vehicle at its maximum weight load, make
sure the tire inflation pressure is correct for the weight load on the tires.
WARNING: Under-inflation is the most common cause of tire
failures and may result in severe tire cracking, tread separation
or(blowout(, with unexpected loss of vehicle control and
increased risk of injury. Under-inflation increases sidewall
flexing and rolling resistance, resulting in heat buildup and
internal damage to the tire. It also may result in unnecessary
tire stress, irregular wear, loss of vehicle control and accidents.
A tire can lose up to half of its air pressure and not appear to
be flat!
When weather temperature changes occur, tire inflation pressures also
change. A 10 degree temperature change causes a corresponding drop of
7 kPa (1 psi) in inflation pressure. Check your tire pressures frequently
and adjust them to the proper pressure which can be found on the tire
label or certification label.
If checking tire pressure when the tire is hot, (i.e. driven more than 1.6
km [1mile]), never ªbleedº or reduce air pressure. The tires are hot from
driving and it is normal for pressures to increase above recommended
cold pressures. A hot tire at or below recommended cold inflation
pressure could be significantly under-inflated.
To check the pressure in your tire(s):
1. Make sure the tires are cool, meaning they are not hot from driving
even a mile.
Note:If you have to drive a distance to get air for your tire(s), check
and record the tire pressure first and add the appropriate air pressure
when you get to the pump. It is normal for tires to heat up and the air
pressure inside to go up as you drive. Never ªbleedº or reduce air
pressure when tires are hot.
2. Remove the cap from the valve on one tire, then firmly press the tire
gauge onto the valve.
3. Add air to reach the recommended air pressure
Note:If you overfill the tire, release air by pushing on the metal stem in
the center of the valve. Then recheck the pressure with your tire gauge.
Maintenance and Specifications
239
Page 240 of 256

4. Replace the valve cap.
5. Repeat this procedure for each tire, including the spare.
Note:Some spare tires require higher inflation pressure than the other
tires.
6. Visually inspect the tires to make sure there are no nails or other
objects embedded that could poke a hole in the tire and cause an air
leak.
7. Check the sidewalls to make sure there are no gouges, cuts, bulges
or other irregularities.
Tire and wheel alignment
A bad jolt from hitting a curb or pothole can cause the front end of your
vehicle to become misaligned or damage to your tires. If your vehicle
seems to pull to one side, vibrate or shake when you're driving, the
wheels may be out of alignment. Have a qualified technician at a Mazda
dealer check the wheel alignment periodically.
Wheel misalignment in the front or the rear can cause uneven and rapid
treadwear of your tires and should be corrected by a qualified technician
at a Mazda dealer. Front wheel drive (FWD) vehicles, and those with
independent front suspension require alignment of all four wheels.
The tire should also be balanced periodically. An unbalanced tire and
wheel assembly may result in irregular tire wear.
NOTE:When it is time to replace front tires with new ones, this is an
ideal time to perform an alignment. New tires should be balanced at the
time they are installed.
Tire rotation
Rotating your tires at the recommended interval (as indicated in the
Scheduled maintenancesection of theMaintenance and
Specificationschapter) will help your tires wear more evenly providing
better tire performance and longer tire life. Unless otherwise specified,
rotate the tires approximately every 8,000 km (5,000 miles).
Maintenance and Specifications
240
Page 242 of 256

Sometimes irregular tire wear can be corrected by rotating the tires.
Note:If your tires show uneven wear ask a qualified technician at a
Mazda dealership to check for and correct any wheel misalignment, tire
imbalance or mechanical problem involved before tire rotation.
Note:After having your tires rotated, inflation pressure must be checked
and adjusted to the vehicle requirements.
Tire wear
Measure and inspect the tire tread on all your tires periodically.
Advanced and unusual tire wear can reduce the ability of tread to grip
the road in adverse (wet, snowy, etc.) conditions. Visually check your
tires for uneven wear, looking for high and low areas or unusually
smooth areas. Also check for signs of tire damage.
When the tread is worn down to 4
mm (1/16th of an inch), tires must
be replaced to prevent your vehicle
from skidding and hydroplaning.
Built-in treadwear indicators, or
ªwear barsº, which look like narrow
strips of smooth rubber across the
tread will appear on the tire when
the tread is worn down to 4mm (1/16th of an inch). When you see these
ªwear barsº, the tire is worn out and should be replaced.
Inspect your tires frequently for any of the following conditions and
replace them if one or more of the following conditions exist:
²Fabric showing through the tire rubber
²Bulges in the tread or sidewalls
²Cracks or cuts on the sidewalls
²Cracks in the tread groove
²Impact damage resulting from use
²Separation in the tread
²Separation in the sidewall
²Severe abrasion on the sidewall
If your vehicle has a leak in the exhaust system, a road tire or the spare
tire may be exposed to hot exhaust temperatures requiring the tire to be
replaced.
Maintenance and Specifications
242
Page 255 of 256

Radio reception .....................42±43
Rear window defroster ...............47
Relays ........................................158
Remote entry system
arming and disarming the
anti-theft system ......................73
illuminated entry ......................74
locking/unlocking doors ...........70
replacing the batteries .............73
Roof rack .....................................69
S
Safety Belt Maintenance ............99
Safety belts
(see Safety restraints) .........90±95
Safety defects, reporting ..........189
Safety restraints ....................90±95
extension assembly ..................96
for adults .............................91±94
for children .............................110
lap belt ......................................97
safety belt maintenance ...........99
warning light and chime ....97±98
Safety seats for children ..........113
Seat belts
(see Safety restraints) ...............90
Seats ............................................80
child safety seats ....................113
heated ........................................83
SecuriLock passive anti-theft
system ..........................................75
Servicing your vehicle ..............201
Spare tire
(see Changing the Tire) ...........165
Spark plugs, specifications .......247Special notice
ambulance conversions ..............5
Specification chart,
lubricants ...................................246
Speed control ..............................63
Starting your vehicle ........121±123
jump starting ..........................171
Steering wheel
tilting .........................................58
T
Tilt steering wheel ......................58
Tires ...................................232±233
alignment ................................240
care ..........................................238
changing ..................165±166, 171
checking the pressure ............238
label .........................................238
rotating ....................................240
safety practices .......................243
sidewall information ...............234
snow tires and chains ............243
spare tire .................................165
terminology .............................233
tire grades ...............................233
treadwear ........................232, 242
Towing .......................................151
recreational towing .................156
trailer towing ..........................151
wrecker ....................................177
Transaxle
fluid, checking and adding
(manual) .................................230
manual operation ....................135
Transmission
automatic operation ...............129
brake-shift interlock (BSI) ....129
fluid, checking and adding
(automatic) .............................228
Index
255
Page:
< prev 1-8 9-16 17-24