2004 MAZDA MODEL RX 8 change time

4
Safety Information
Read this owner's manual for your Navigation System carefully before using the system.
They contain instructions about how to use the system in a safe and effective manner.
Mazda assumes no responsibility for any problems resulting from failure to observe the instructions
given in this manual.
This manual uses pictographs to show you how to use the product safely and to alert you to potential
dangers resulting from improper connections and operation. The meanings of the pictographs are
explained below. It is important that you fully understand the meanings of the pictographs in order to
use this manual and the system properly.
Do not keep your eyes fixed on the monitor screen or operate the system
while driving.
Do not change the settings and destination locations while driving. Minimize the time
spent on viewing the monitor screen and listening to the voice guidance while driving.
Operating the system will distract the driver from looking ahead of the vehicle and can
cause accidents. Always stop the vehicle in a safe location and use the parking brake
before operating the system.
Always obey local traffic regulations.Your guided route may include roads that are not open to vehicles or are closed due to
traffic regulations. Comply with the local traffic regulations and take another route.
Do not use the unit when it is out of order.If the unit is out of order (no image, no sound) or in an abnormal state (has foreign
matter in it, is exposed to water, is smoking, or smells), then turn it off immediately and
consult with an Authorized Mazda Dealer. Using the unit in out-of-order condition
may lead to accidents, fires, or electric shocks.
Use the proper power supply.This product is designed for operation with a negative grounded 12 V DC battery
system.
Warnings
Before Use
3
Warning
This label intends to alert you to the presence of important
operating instructions. Failure to heed the instructions may
result in severe injury or death.
Warning
WWarning
D
Do
be
A
In
co
N
Do
pr
Warnings

e 28)
19)
page 21)
page 24)
uto reroutes inactivated.

Do not start driving until the opening screen and warning screen close.

The vehicle position indicator may disappear temporarily after the speed is increased
depending on the vehicle model. This is a normal phenomenon indicating that the system
is calculating the distance correction. The mobile navigation system uses GPS data for distance correction. It must be properly
calibrated for accurate operation. Perform calibration in any of the following circumstances:
1. When using the navigation system for the very first time after installing the system.
2. When the navigation system is transferred to another vehicle.
3. When the tire pressure is changed, tires are rotated, the spare tire is used, tire size, or
wheel diameter is changed.
4. When deleting the position correction learning results.
Notes
Before Use
14
Make sure the GPS reception indicator is illuminated on the map screen.
GPS reception indicator Drive the vehicle in an open area for approximately 30-minutes at a speed over 20 kph
(12.5 MPH) while receiving GPS signals.
Notes
15
Before UseSystem Operation Verification
Automatic distance correction check

Resetting automatic distance correction

Changing the Map Orientation/Scale
Do not keep your eyes fixed on the monitor screen or operate the system while drivingDo not change the settings and destination locations while driving. Minimize the time spent viewing
the monitor screen and listening to the voice guidance while driving. Operating the system will
distract the driver from looking ahead of the vehicle and may cause an accident. Always stop the
vehicle in a safe location and use the parking brake before operating the system.
Warning
1
Open the pop up menu(while in current position map)
2Select or
pressand
Before Use
18North Up :Geographic north is up.
Head Up :The direction you are
heading is up.
Map
orientation
Map scale
1
The map can be displayed in
twelve steps with scales from
to .
19
ZOOM OUT: Enlarges the map.
ZOOM IN: Reduces the map.
(more detail.)
ENTER
ENTER
ENTER
ZOOM
ZOOM

nformation about
[Select
on.
earch
ENTERER
21
3
Character entry or selection
( page 22)
Search method
4
Select the
house
number
.
Enter the name of
the city where your
target intersection is.
Enter the
name of a
street that is
part of the
intersection.Enter the
other street
name that
makes up the
intersection.
This is the route that
reaches the destination
in the shortest time.
(The 20 closest destinations to the current
position appear (within a radius of about 30 mile.).)
Select a destination from the list of recent destinations.
Select a destination from the list of Marked points
(Up to 100 points).
This route reduces theuse of highways (if thereare highways on the way).
You can designate a
destination on the map.
(Move the crosshair
cursor to the destination.)
The following menus will be
displayed when is
pressed on the map display.
[Marked Point]
[Destination]
[Nearest POI]
Enter the
Zipcode.*2
Enter/Select the
city name.*1
Enter/Select the
street name.
Enter/Select
the street
name. Select the
city name.
Select a
desired
destination
from the list.
Marks the destination
resulting from the search.
Enter the target name. Enter the target
city name.Enter the
target name.
Note
The results from the route
search are not always the
shortest routes. You cannot
always avoid the specified
highways even if the
highway is set to [Avoid
Highway].
For example, you will be
on the specified highway
when your vehicle is on the
highway or when your
destination exists on the
highway.

Do not change the settings and destination locations while driving. Minimize the time spent
viewing the monitor screen and listening to the voice guidance while driving. Operating the
system will distract the driver from looking ahead of the vehicle and may cause an accident. Always
stop the vehicle in a safe location before operating the system.

Route searches with the navigation system can include roads that you can not drive on and roads
that you are prohibited from driving on due to traffic regulations. Please comply with the traffic regulations.
Warnings
Move the crosshair
Select cursor to the destination and press .
(Up to 50 points including the latest starting point are in the system memory.)
Routing
20
*1 The memory stores up to 10 cities visited recently, and these city names can be selected.*2 Depending on the area,zipcode search may not be possible.
ENTER
( page 24)
ENTER
ENTERENTERENTERENTER

29
3
3
Select a marked
point from the listSelect an icon
Enter a name


Information about
the marked point
appears.
If the same point is stored in “Marking Your Current
Position”, then it is registered with one local name on the
list. If the same point is stored in different processes, for
example, as in “Marking Your Current Position” and
“Marking Any Point on the Map”, then two local names,
identical to each other, will be shown on the list.
Note
Stop your vehicle before doing the following operations:Do not change the settings and destination locations while driving.
Minimize the time spent viewing the monitor screen and listening
to the voice guidance while driving.
Operating the system will distract the driver from looking ahead of
the vehicle and may cause an accident. Always stop the vehicle in
a safe location and use the parking brake before operating the
system.Warning
Marking
28
ENTERENTER
ENTERENTER
d.
d with its
the map.
fLifz
fLifzLifz

Setu
1
Open th
screen
How to
QsL
Y
ME
ENT
ENT
30
Setup
2
Restoring
defaults
Map setting ( page 31)


On : Icons on a map.
Off : No icon on a map.

The setting is a variable to suit your preferences.
Route setting ( page 32)
System setting ( page 33)
( page 9)
Map area, Map disc (DVD) version and software
version appear.
You can check your route from the starting point to the
destination.
This function is available after route setup is performed.
You can change and delete marked points.
( page 28)
( page 28)
Change the vehicle position.
Change the vehicle direction.
: Rotation in a clockwise direction by 11.25°.
: Rotation in a counterclockwise direction
by 11.25°.
Stop your vehicle before the following operationsDo not change the settings and destination locations while driving. Minimize the time spent viewing the
monitor screen and listening to the voice guidance while driving. Operating the system will
distract the driver from looking ahead of the vehicle and may cause an accident.
Always stop the vehicle in a safe location and put the parking brake on before operating the system.
Warning
Open
[Setup Menu]
When the actual position of your
vehicle is different from the vehicle
position on a mapUser setting
29
: Default
1selectMENUENTERENTERENTER
ENTER
ENTER
ENTER
ENTER

33
Open the
[System Setup]
screenVolume control for voice guidance (5 levels)
Beep

On : Beep activated when pressing buttons in the
remote control.

Off : Beep inactivated when pressing buttons in the
remote control.

On : Initiates vocal guidance.
Off : Initiates no vocal guidance.
Language
Changeover meter/mile

Metric : Meters
English : Miles
Voice repetition
Clock
Adjust the volume control at the monitor as well.
: Default
How to exit
Daylight Saving Time(Summer Time)

On : Daylight saving time mode is enabled.
(The navigation internal clock gains 1 hour).

Off : Daylight saving time mode is disabled.
SetupSystem
User setting
32
1
2select3
selectMENUENTER
ENTER
ENTER
ENTERENTER
ENTER
ENTER
ENTER
nt go back
om it.
atically
proaching
ute
ation.
fLifz

If you are u
takes about
position.

The GPS sa
lower positi

There may
turning on t
GPS sign
In tunnels
This functio
disc, applies
and displays

Intelligent m
in vehicle p

Using a spa

Any differen
on the map
34
Precautions/System Performance
Second branching pointFirst branching point150m
100m
Route
In 700m left turn.Left turn ahead,
then right turn.
Voice guidance has the following functions:
When two intersections are close together,
the voice guidance may be late.
Roundabout.
Take the second
exit.
JPrfso/esAeSfOIneSo sIArsCHe rsoeVroPrAU
oPrsGeTCrsVSTOIfCrsEeAsoPrs rCefOsWI.snrsHIorM

The system voice announces the distance to an upcoming turn and the turning direction.aThis guidance function is automatic. Therefore, you do not have to set it, and it cannot
be disabled.
Intersection guidance
Voice Guidance

The navigation system is just a support system for the driver. The driver should always
pay attention to the traffic situation to safely make decisions. You may be unable at
times to arrive at your destination due to out-of-date information on a map disc. You
should be especially careful when selecting an urgent destination such as a hospital or
a police station.

Your route may sometimes include roads that are not open to vehicles or are closed
due to traffic regulations. Please comply with the local traffic regulations.

Do not change the settings and destination locations while driving. Minimize the time
spent viewing the monitor screen and listening to the voice guidance while driving.
Operating the system will distract the driver from looking ahead of the vehicle and may
cause an accident. Always stop the vehicle in a safe location and use the parking brake
before operating the system.
Warnings

The system vocally announces the distance to an upcoming highway
branching point or junction.
aThis guidance function can be set in the [Setup menu]. For details, see page 32.

The mobile navigation system calculates and indicates the vehicle position on the map by
multiplying the speed pulse emitted by the vehicle with a correction coefficient.
The speed pulse emitted varies with the type of vehicle and with differences in tire
pressure and wear.
A different correction coefficient might even be required for the same type of vehicle.

Using a spare tire in place of the regular one may cause vehicle position deviations.
Automatic Distance Correction
As necessary
33