2004 MAZDA MODEL 3 HATCHBACK coolant level

8-17
Maintenance and Care
Owner Maintenance
Form No. 8S18-EA-03I
To change coolant1. Remove the cooling system cap.
2. Only when the engine is cool, remove
the radiator drain plug and drain the
coolant into a suitable container.
Properly dispose of the used coolant.
3. Flush out the system with running
water.
4. Drain the system completely. Insert
and tighten the plug. Add as much
ethylene-glycol-based coolant mixture
and water as necessary to provide
freezing and corrosion protection.
5. In extremely cold climates, add the
mixture percentage recommended in
the coolant mixture percentage table.
6. Run the engine at idle with the cooling
system cap off. Slowly add additional
coolant if necessary.
7. At this point, wait until the engine
reaches normal operating temperature;
then depress the accelerator two or
three times. Add more coolant, if
necessary, until the system is full.
8. Install the cooling system cap. Inspect
all connections for leaks. Inspect the
level in the coolant reservoir one more
time.
Removing the Cooling System Cap:
Removing the cooling system cap
while the engine is running or hot is
dangerous. This might lead to cooling
system and engine damage and could
result in serious injury from escaping
hot coolant or steam. Turn off the
engine and wait until it’s cool. Even
then, be very careful when removing
the cap.
Wrap a thick cloth around the cap
and slowly turn it counterclockwise
about two and a half rotations.
Step back while the pressure escapes.
When you’re sure all the pressure has
escaped, turn the cap
counterclockwise — still using a cloth
— and remove the cap.
WARNINGLoosen
Loosen Tighten
Tighten
J48C_8S18-EA-03I_Edition1.book Page 17 Wednesday, August 6, 2003 8:51 AM

10-5
Specifications
Form No. 8S18-EA-03I

Capacities
(Approximate Quantities)

Check oil and fluid levels with dipsticks or reservoir gauges.

Dimensions
* With side protector
ItemUnit
L US qt Imp qt
Engine oilWith oil filter replacement 4.3 4.5 3.8
Without oil filter replacement 3.9 4.1 3.4
CoolantWith heater 7.5 7.9 6.6
Without heater 6.9 7.3 6.1
Manual transaxle oil 2.87 3.03 2.53
Automatic transaxle fluid 7.2 7.6 6.3
Fuel tank 5514.5
(US gal)12.1
(Imp gal)
ItemModel
4 Door 5 Door
Overall length(STD) 4,530 mm (178.3 in)—
(SAP) 4,540 mm (178.7 in) 4,485 mm (176.6 in)
Overall width
*1,755 mm (69.1 in) 1,755 mm (69.1 in)
Overall height 1,465 mm (57.7 in) 1,465 mm (57.7 in)
Front tread 1,530 mm (60.2 in) 1,530 mm (60.2 in)
Rear tread 1,515 mm (59.6 in) 1,515 mm (59.6 in)
Wheelbase 2,640 mm (103.9 in) 2,640 mm (103.9 in)
J48C_8S18-EA-03I_Edition1.book Page 5 Wednesday, August 6, 2003 8:51 AM

11-3
Index
Form No. 8S18-EA-03I
D
Dashboard Illumination ................... 5-30
Daytime Running Lights
.................. 5-47
Defroster
Rear window
............................. 5-52
Dimensions
...................................... 10-5
Door Locks
......................................... 3-7
Driving In Flooded Area
.................. 4-12
Driving Tips
....................................... 4-7
Automatic transaxle
.................. 5-16
Break-in period
........................... 4-7
Driving in flooded area
............. 4-12
Hazardous driving
....................... 4-8
Money-saving suggestions
.......... 4-7
Rocking the vehicle
.................... 4-9
Winter driving
............................. 4-9
E
Emergency Starting .......................... 7-15
Flooded engine
.......................... 7-15
Jump-starting
............................ 7-16
Push-starting
............................. 7-19
Emergency Towing
.......................... 7-20
Emission Control System
................... 4-3
Engine
Coolant
...................................... 8-15
Exhaust gas
................................. 4-5
Hood release
............................. 3-20
Oil
............................................. 8-13
Overheating
............................... 7-13
Starting
........................................ 5-3
Engine Compartment Overview
...... 8-12
Engine Coolant
Overheating
............................... 7-13
Engine Coolant Temperature
Gauge
............................................... 5-29
Exhaust Gas
....................................... 4-5
Exterior Care
.................................... 8-53
F
Flasher
Hazard warning
.........................5-53
Headlights
.................................5-44
Flat Tire
..............................................7-3
Changing
.....................................7-6
Spare tire and tool storage
...........7-3
Flexible Floor Board
........................6-45
Fluids
Classification
.............................10-4
Owner maintenance
...................8-10
Fog Lights
........................................5-48
Foot Brake
..........................................5-4
Front Seats
..........................................2-2
Fuel
Filler lid and cap
.......................3-19
Gauge
........................................5-29
Requirements
..............................4-2
Tank capacity
............................10-5
Fuses
.................................................8-46
Panel description
.......................8-48
Replacement
..............................8-46
G
Gauges ..............................................5-26
Glove Box
........................................6-42
H
Hazard Warning Flasher ...................5-53
Hazardous Driving
.............................4-8
Headlights
Control
......................................5-44
Flashing
.....................................5-46
High-low beam
..........................5-46
Leveling
....................................5-46
On reminder
..............................5-45
J48C_8S18-EA-03I_Edition1.book Page 3 Wednesday, August 6, 2003 8:51 AM