2004 JEEP GRAND CHEROKEE key

Brake Transmission Shift Interlock System (BTSI)
This vehicle is equipped with a brake transmission shift
interlock system (BTSI) that holds the gearshift lever in
the P (Park) position when the ignition switch is in an
unlocked position. To move the gear selector lever out of
the P (Park) position, the ignition switch must be turned
to the OFF, ON, or START position, the brake pedal and
the button on the front side of the shifter handle must be
depressed.
Electronically Controlled Five Speed Automatic
Transmission (4.7L Engine Only)
This electronically controlled transmission provides a
precise shift schedule. The transmission electronics are
self calibrating; therefore, the first few shifts on a new
vehicle may be somewhat abrupt. This is a normal
condition, and precision shifts will develop within a
couple hundred miles (kilometers).
Protect Mode - Electronically Controlled
Transmission (4.7L Engine Only)
This transmission is monitored electronically for abnor-
mal conditions. If an abnormal condition is detected, the
transmission's electronic controller will automatically
select direct gear (in the Drive position) or 2nd gear (in
the 2 or 1 position). This feature will allow the vehicle to
be driven to the dealer for service minimizing any
damage to the transmission. Some conditions that will
cause the transmission to use this alternate gear selection
are momentary and the transmission can be reset to the
normal shift program by performing the following:
²Stop the vehicle and shift into P (Park).
²Turn the ignition key to the OFF position and then
restart the engine.
²Shift into the desire shift range and resume driving.
180 STARTING AND OPERATING

NOTE:Even if the transmission can be reset, it is
recommend that you see your dealer at your earliest
possible convenience. Your dealer has the proper diag-
nostic equipment to determine if the problem could
recur. If the transmission is cannot be reset, dealer service
is required.
Gear Ranges
DO NOT race the engine when shifting from P (Park) or
N (Neutral) position into another gear range.
PÐPark
Supplements the parking brake by locking the transmis-
sion. The engine can be started in this range. Never use P
(Park) while the vehicle is in motion. Apply the parking
brake when leaving the vehicle in this range. Always
apply the parking brake first, then place the selector in P
(Park) position.
WARNING!
Unintended movement of a vehicle could injure
those in and near the vehicle. As with all vehicles,
you should never exit a vehicle while the engine is
running. Before exiting a vehicle, you should always
shift the vehicle into P (Park), remove the key from
the ignition, and apply the parking brake. Once the
key is removed from the ignition, the transmission
shift lever is locked in the P (Park) position, securing
the vehicle against unwanted movement. Further-
more, you should never leave children unattended
inside a vehicle.
The following indicators should be used to ensure that
you have engaged the transmission shift lever into the P
(Park) position:
STARTING AND OPERATING 181
5

WARNING!
²Leaving children unattended in a vehicle is dan-
gerous for a number of reasons. A child or others
could be injured. Children should be warned not
to touch the parking brake or the gear selector
lever. Don't leave the keys in the ignition. A child
could operate power windows, other controls, or
move the vehicle.
²Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build up
may cause serious injury or death.
To release the parking brake, pull up slightly, press the
center button, then lower the lever completely.Be sure the parking brake is fully disengaged before
driving. Failure to do so can lead to brake failure.
NOTE:Parking brake adjustment and maintenance
should be performed by your authorized dealer.
196 STARTING AND OPERATING

Shifting Into Neutral (N)
Use the following procedure to prepare your vehicle for
recreational towing.
CAUTION!
It is necessary to follow these steps to be certain that
the transfer case is fully in N (Neutral) before
recreational towing to prevent damage to internal
parts.
1. Depress brake pedal.
2. Shift transmission into N (Neutral).
3. Shift transfer case lever into N (Neutral).4. Start engine.
5. Shift transmission into D (Drive).
6. Release brake pedal and ensure that there is no vehicle
movement.
7. Shut the engine OFF and place the ignition key into
the unlocked OFF position.
8. Shift transmission into P (Park).
9. Apply parking brake.
10. Attach vehicle to the tow vehicle with tow bar.
11. Release parking brake.
232 STARTING AND OPERATING

NOTE:To start the vehicle following connection of a
booster battery, the Security Alarm System must first be
disabled by cycling a front door key cylinder or by using
the keyless entry transmitter.
WARNING!
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in vehicle,
observe the following warnings:
²Battery fluid is a corrosive acid solution and can burn
or even blind you. Don't allow battery fluid to contact
your eyes, skin, or clothing. Don't lean over a battery
when attaching clamps. If acid splashes in eyes or on
skin, flush the area immediately with large amounts of
water.
²Do not use a booster battery or any other booster
source that has a greater than 12±volt system, i.e., do
not use a 24±volt power source.
²Never attempt to jump start a discharged battery that
is frozen, because it could rupture or explode during
jump starting.
²Be sure your vehicle is not touching the jump start
vehicle.
²Observe all Battery Warnings in Section 7 of this
manual, while jump starting your vehicle.
WHAT TO DO IN EMERGENCIES 247
6

EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle's emissions control system.
Failure to pass could prevent vehicle registration.
For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle's OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off the
254 MAINTAINING YOUR VEHICLE

ignition key or start the engine. This means that your
vehicle's OBD system isnot readyand you shouldnot
proceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or start
the engine. This means that your vehicle's OBD system
isreadyand you can proceed to the I/M station.
If your OBD system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD
system to update. A recheck with the above test routine
may then indicate that the system is now ready.
Regardless of whether your vehicle's OBD system is
ready or not ready, if the MIL symbol is illuminated
during normal vehicle operation, you should have yourvehicle serviced before going to the I/M station. The I/M
station can fail your vehicle because the MIL symbol is on
with the engine running.
REPLACEMENT PARTS
Use of genuine Mopartparts for normal/scheduled
maintenance and repairs is highly recommended to in-
sure the designed performance. Damage or failures
caused by the use of non-Mopartparts for maintenance
and repairs will not be covered by the manufacturer's
warranty.
DEALER SERVICE
Your dealer has the qualified service personnel, special
tools and equipment to perform all service operations in
an expert manner. Service Manuals are available which
include detailed service information for your vehicle.
Refer to these manuals before attempting any procedure
yourself.
MAINTAINING YOUR VEHICLE 255
7

Torque Converter...................... 185
Auxiliary Electrical Outlet.................. 115
Auxiliary Power Outlet.................... 115
Battery............................... 264
Emergency Starting..................... 246
Keyless Transmitter Replacement............ 22
Saving Feature......................... 76
Belts, Drive............................ 261
Belts, Seat.............................. 27
Body Mechanism Lubrication............... 267
B-Pillar Location........................ 207
Brake System........................... 274
Anti-Lock.........................133,197
Hoses.............................. 274
Master Cylinder....................... 276
Parking............................. 194
Trailer Towing........................ 227
Warning Light........................ 134Brake/Transmission Interlock............... 180
Break-In Recommendations, New Vehicle........ 51
Bulb Replacement....................... 289
Calibration, Compass..................... 104
Capacities, Fluid........................ 291
Caps, Filler
Fuel................................ 224
Radiator............................ 272
Car Washes............................ 282
Carbon Monoxide Warning................. 51
Cargo Area Cover....................... 118
Cargo Area Features...................... 118
Cargo Compartment...................... 118
Light............................... 118
Luggage Carrier....................... 121
Cargo Light............................ 118
Cargo Tie-Downs........................ 119
Carpeting............................. 285
INDEX 329
10