2004 JEEP GRAND CHEROKEE seats

SEATS
WARNING!
Adjusting a seat while the vehicle is moving is
dangerous. The sudden movement of the seat could
cause you to lose control. The seat belt might not be
properly adjusted and you could be injured. Adjust
any seat only while the vehicle is parked.
Front Manual Seat Adjustment
Move the seat forward or rearward using the adjustment
bar. Lift up on the bar located on the front of the seat near
the floor. Position the seat and be sure the latch engages
fully.
Front Seat Adjustment Ð Recline
To adjust the seatback, lift the lever located on the
outboard side of the seat, lean back, and release the lever
at the desired position. To return the seatback, lift the
lever, lean forward, and release the lever.
WARNING!
Do not ride with the seatback reclined so that the
seat belt is no longer resting against your chest. In a
collision you could slide under the seat belt and be
seriously or even fatally injured. Use the recliner
only when the vehicle is parked.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 63
3

WARNING!
²It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision,
people riding in these areas are more likely to be
seriously injured or killed.
²Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts.
²Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
Head Restraints
Head restraints can reduce the risk of whiplash injury in
the event of impact from the rear. Adjustable head
restraints should be adjusted so that the upper edge is as
high as practical. The head restraints have a locking
button which must be pushed in to lower the headrestraint to all positions, except the full-down position.
To lower the head restraint to the full-down position, the
button does not have to be pushed in. The restraints may
be raised without pushing in the button.
64 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Heated Seats Ð If Equipped
This feature heats the driver's and passenger's front
seats. The controls for the heated seats are located on the
instrument panel below the heater/air conditioning con-
trols. After turning on the ignition you can choose from
HI, OFF, or LO heat settings.An indicator on the switch shows which setting has been
selected. To turn off the heated seats, position the switch
in the middle.
60/40 Split Rear Seat
Either side of the rear seat can be folded flat to allow for
extended cargo space and still maintain some rear seating
room.
NOTE:Be sure that the front seats are fully upright and
positioned forward. This will allow the rear seatback to
fold down easily.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 71
3

NOTE:When lifting up on the release handle, the
seatback will release easier if you do not pull forward on
the seatback; only lift up on the release handle until the
seatback disengages, then fold the seat forward.To restore the 60/40 rear seat to the upright
position perform the following steps:
Raise the seatback and lock it into place. If interference
from the cargo area prevents the seatback from fully
locking, you will have difficulty returning the seat cush-
ion to its proper position. Remove the headrests from the
cushion panel storage position and reinstall into the rear
seat back.
WARNING!
Be certain that the seatback is securely locked into
position. If the seatback in not securely locked into
position the seat will not provide the proper stability
for child seats and/or passengers. An improperly
latched seat could cause serious injury.
Rotate the seat cushion rearward until it is latched into
place.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 73
3

WARNING!
²Cargo tie-down hooks are not safe anchors for a
child seat tether strap. In a sudden stop or colli-
sion a hook could pull loose and allow the child
seat to come loose. A child could be badly injured.
Use only the anchors provided for child seat
tethers.
²The weight and position of cargo and passengers
can change the vehicle center of gravity and
vehicle handling. To avoid loss of control result-
ing in personal injury, follow these guidelines for
loading your vehicle:
²Do not carry loads which exceed the load limits
described on the label attached to the left door or left
door center pillar. Refer to ªVehicle Loadingº in Sec-
tion 5 for additional information on cargo weights.
²Always place cargo evenly on the cargo floor. Put
heavier objects as low and as far forward as possible.
²Place as much cargo as possible in front of the rear
axle. Too much weight or improperly placed weight
over or behind the rear axle can cause the rear of the
vehicle to sway.
²Do not pile luggage or cargo higher than the top of the
seatback. This could impair visibility or become a
dangerous projectile in a sudden stop or collision.
WARNING!
To help protect against personal injury, passengers
should not be seated in the rear cargo area. The rear
cargo space is intended for load carrying purposes
only, not for passengers, who should sit in seats and
use seat belts.
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Mode Selection
The mode selector (the right
rotary knob) can be set in any
of the following positions:
OFF
This position turns off the blower motor and outside air
will not pass through any outlets.
Recirculation
The recirculation feature can be selected with the
mode control knob. Outside air is normally
drawn into the vehicle in all of the other modes, such as
panel air, bi-level, floor, floor/defrost, and the defrost airdistribution outlets. Air flows through the outlets located
in the instrument panel. Use this mode to rapidly cool the
inside of the vehicle. The Recirculation mode can also be
used to temporarily block out outside odors, smoke, and
dust.
Panel
Air flows through the outlets located in the instru-
ment panel.
Bi-Level
Air flows both through the outlets located in the
instrument panel and those located on the floor.
Floor
Air flows through the floor outlets located under
the instrument panel and into the rear seating area
through vents under the front seats.
166 UNDERSTANDING YOUR INSTRUMENT PANEL

²Floor
Air flows through the floor outlets located under
the instrument panel and into the rear seating
area through vents under the front seats.
²Bi-Level
Air flows both through the outlets located in the
instrument panel and those located on the floor.
²Panel
Air flows through the outlets located in the in-
strument panel.
²OFF
This position turns off the entire system.
Depress the A/C button to turn on and off the air
conditioning during manual operation only. Conditioned
outside air is then directed through the outlets selected
on the mode control dial.When the outside air contains smoke, odors, high humid-
ity, or if rapid cooling is desired you may wish to
recirculate interior air by pressing the ªRecirculateº icon
button. The recirculation mode should only be used
temporarily. The light on the A/C and ªRecirculateº icon
buttons will illuminate when these buttons are selected.
You may use these features separately or with one
another. Push in on the buttons a second time to change
the functions.
NOTE:If the interior of the windows begins to fog,
press the ªRecirculateº icon button to return to outside
air. Some temp./humidity conditions will cause captured
interior air to condense on windows and hamper visibil-
ity. For this reason, the system will not allow ªRecircu-
lateº to be selected while in the defrost or defrost/floor
modes.
To provide you with maximum comfort in the automatic
mode, during cold start-ups the blower fan will remain
UNDERSTANDING YOUR INSTRUMENT PANEL 169
4

Interior Care
Use MopartFabric Cleaner to clean fabric upholstery
and carpeting.
Use MopartVinyl Cleaner to clean vinyl upholstery.
MopartVinyl Cleaner is specifically recommended for
interior vinyl trim.
Do not use silicon based cleaning products on leather
seats. They could cause cracking of the seat leather.
Leather Seat Care & Cleaning
Leather is best preserved by regular cleaning with a
damp soft cloth. Small particles of dirt can act as an
abrasive and damage the leather surface and should be
removed promptly with a damp cloth. Stubborn soils can
be removed easily with a soft cloth and MopartTotalClean. Care should be taken to avoid soaking the leather
with any liquid. Please do not use polishes, oils, cleaning
fluids, solvents, detergents, or ammonia based cleaners
to clean the leather. Application of a leather conditioner is
not required to maintain the original condition.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis
with any commercial household-type glass cleaner.
Never use an abrasive type cleaner. Use caution when
cleaning inside rear windows equipped with electric
defrosters. Do not use scrapers or other sharp instru-
ments which may scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or rag that you are using. Do not spray cleaner
directly on the mirror.
284 MAINTAINING YOUR VEHICLE