2004 ISUZU TF SERIES low beam

ELECTRICAL-BODY AND CHASSIS 8A-133


4. Keep the vehicle 2 1m apart from the screen 1.
5. Draw a horizontal line through point
A and Bon the screen
1.



6. Turn the headlight low beam on.
7. Adjust the CUTLINE 11.6 mm below the horizontal line
H.
8. Adjust the BENDING POINT to the vertical line
V.
NOTE:
Always adjust vertical adjustment first.

ELECTRICAL-BODY AND CHASSIS 8A-153

HEADLIGHT LEVELING SWITCH
Incorrect beam angle due to load change can be corrected.
A four position switch, 0-3, can alter the beam angle through
1.7 degrees on the long wheel base model and 2.17 degrees
on the short wheel base model.
825R300049

Inspection
Check to see if there is any continuity between the terminals of
the leveling switch.
Replace the switch when the result of inspection is found
abnormal.



Removal
Preparation:
Disconnect the battery ground cable.
1. Ventilation grille
2. Harness connector
3. Headlight leveling switch
To remove the switch, push the lock from the back side of
the cluster assembly.



Installation
To install, follow the removal steps in the reverse noting the
following point.
1. Push in the switch with your fingers until it locks securely.

8A-276 ELECTRICAL-BODY AND CHASSIS


Connector No. B-24
Terminal Connector place SOUTH
AFRICA SAUDI
ARABIA ISRAEL EC UK OTHER
1
SEDIMENTER
2
4LO
3
OIL PRESS
4
4WD
5
CHECK 4WD
6
GLOW
7
POWER DRIVE
8








9
SPEED (+)
10
4P OUTPUT
11
TACHO
12
STARTER
13
TEMP
14
FUEL
RR FOG


15
FRONT FOG






16
ABS CONT. (ABS)
17
CHECK ENGINE
18
AIR BAG
SEAT BELT 19
LOW COOLANT





CRUISE SET



20
BEAM (+)




21
TURN (LEFT)
22
BEAM (-)
BEAM (+)


23
FRONT FOG




24
3rd START (A/T)
25








26
POWER GND
27
SPEED (-)
28
GND UNIT
29
+B
30
IGN

HEATER AND AIR CONDITIONING 1-65
BLOWER UNIT ASSEMBLY
REMOVAL AND INSTALLATION



This illustration is based on RHD model
873R300002-X

Removal Steps
1. Control cable

2. Instrument panel assembly and cross
beam
3. Electronic thermostat connector

4. Evaporator or duct
5. Resistor connector
6. Blower motor connector
7. Blower unit assembly

Installation Steps
7. Blower unit assembly
6. Blower motor connector
5. Resistor connector
4. Evaporator or duct
3. Electronic thermostat connector

2. Instrument panel assembly and cross
beam
1. Control cable