2004 Hyundai Elantra turn signal bulb

1FEATURES OF YOUR HYUNDAI
54
B340A01A-AATCOMBINATION TURN SIGNAL,
HEADLIGHT AND HIGH-BEAM
SWITCH
Turn Signal Operation
Pulling down on the lever causes the turn
signals on the left side of the car to blink. Pushing
upwards on the lever causes the turn signals on
the right side of the car to blink. As the turn is
completed, the lever will automatically return to
the center position and turn off the turn signals
at the same time. If either turn signal indicator
light blinks more rapidly than usual, goes on but
does not blink, or does not go on at all, there is
a malfunction in the system. Check for a burned-
out fuse or bulb or see your Hyundai dealer.
B340B01A-AAT
Lane Change Signal
To indicate a lane change, move the lever up or
down to a point where it begins flashing.
The lever will automatically return to the center
position when released.
MULTI-FUNCTION LIGHT SWITCH
HXDFL352B340C03E-AAT
Headlight Switch
To operate the headlights, turn the barrel on the
end of the multi-function switch. The first posi-
tion turns on the parking lights, sidelights, tail
lights and instrument panel lights. The second
position turns on the headlights.
NOTE:The ignition must be in the "ON" position
to turn on the headlights.
HXDFL360

6DO-IT-YOURSELF MAINTENANCE
26REPLACEMENT OF LIGHT BULBS
G260A03A-AAT
Before attempting to replace a headlight bulb, be
sure the switch is turned to the "OFF" position.
The next paragraph shows how to reach the
headlight bulbs so they may be changed. Be
sure to replace the burned-out bulb with one of
the same number and wattage rating.
CAUTION:Keep the lamps out of contact with petro-
leum products, such as oil, gasoline, etc.
!
4. Using a socket wrench of the correct size,
remove the headlight assembly mounting
bolts.
5. Disconnect the power cord from the back of
the headlight. Replacement instructions:
1. Allow the bulb to cool. Wear eye protection.
2. Open the engine hood.
3. Always grasp the bulb by its plastic base,
avoid touching the glass.
G270A01A-AAT
HEADLIGHT AND FRONT TURN SIG-
NAL LIGHT
G270A01E
High beam
Low beam
Turn signal light
HXDFL1009
HXDFL1022

6DO-IT-YOURSELF MAINTENANCE
27
!WARNING:This halogen bulb contains gas under pres-
sure and if impacted could shatter, result-
ing in flying fragments. Always wear eye
protection when servicing the bulb. Protect
the bulb against abrasions or scratches
and against liquids when lighted. Turn the
bulb on only when installing in a headlight.
Replace the headlight if damaged or cracked.
Keep the bulb out of the reach of children
and dispose of the used bulb with care. 8. Remove the protective cap from the re-
placement bulb and install the new bulb by
matching the plastic base with the headlight
hole. Retighten the bulb spring and recon-
nect the power cord.
9. Use the protective cap and carton to prompt-
ly dispose of the old bulb.
10. Check for proper headlight aim.
(1) High beam
(2) Low beam
(3) Front turn signal light
7. Push the bulb spring to remove the headlight
bulb. 6. Turn the plastic cover counterclockwise
and remove it.
HXDFL1011 HXDFL1010
HXDFL1013-1
(1)(2)(3)
G270A03O

6DO-IT-YOURSELF MAINTENANCE
28
G270D01E-AAT
REAR COMBINATION LIGHT
(Stop / Tail Light, Back up light and Rear
Turn Signal Light)
4Door
1. Open the trunk lid.
2. Remove the cover on the inside of rear
luggage trim by unscrewing the hand.
HXDFL1014
3. Remove the mounting screws of the rear
combination light with a socket wrench.4. To replace the rear combination light, re-
move it from the bulb holder and install the
new bulb.
(1) Stop/Tail light
(2) Side marker light
(3) Rear turn signal light
(4) Back up light
5Door
(Luggage compartment)
1. Open the tail gate.
2. Remove the mounting screws of the rear
combination light with a phillips screwdriver.
HXDFL1016-AHXDFL1015
(1)
(2)
(3)
(4)
HXDFL334

6DO-IT-YOURSELF MAINTENANCE
29
HXDFL333 HXDFL342
5Door (Tail gate)
1. Open the tail gate.
HXDFL332
2. Remove the cover with a blade screwdriver.Back up light
3. To replace the rear combination light, re-
move it from the bulb holder and install the
new bulb.
HXDFL1017
3. To replace the rear combination light, re-
move it from the bulb holder and install the
new bulb.(2)
HXDFL335
Tail light
(1)(1) Stop/Tail light
(2) Rear turn signal light

6DO-IT-YOURSELF MAINTENANCE
33BULB WATTAGE
G280A03E-AAT
23 678
G280A03E-A
(High beam)(Low beam)4 DOOR 5 DOOR
Wattage
55/55
28/8
5
10
10
5 4 Door
515 Door
51Part Name
High Mounted Stop Light
Luggage Compartment Light
License Plate Light
Rear
Combination
Tail Light
Back-up Light Part Name
Head Light
Front Fog Light
Front Turn Signal Light
Side Marker Light
Interior
Front Door Edge Warning Light
No.
1
2
3
4
5
6Wattage
5
5
27
27/8
8
16
Map Light
Room Light
No.
7
8
9
10
11
12
4 Door
275 Door
2.6(LED)
1
1512 7
4
9 10
9
10 11
8
Turn Signal Light
Stop/Tail Light