2004 HONDA PILOT automatic transmission

This indicator monitors the
temperature of the automatic
transmission f luid. It comes on f or a
f ew seconds when you turn the
ignition switch to ON (II). If it comes
on while driving, it indicates the
transmission fluid temperature is too
high. Pull to the side of the road
when it is saf e, shif t to Park, and let
the engine idle until the light goes
out.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). If this
indicator comes on at any other time,
there is a problem in the 4WD
system. Have your vehicle checked
by a dealer.
If the indicator blinks while driving,
pull to the side of the road when it is
saf e, shif t to Park, and let the engine
idle until the indicator goes out.
Inst rument s and Cont rols
A/T Temperature
Indicator
VTM-4 Indicator
Instrument Panel
52
Continuing to drive with the VTM-4
indicator blinking may cause serious
damage to the 4WD system.
Continuing to drive with the A/T
Temperature indicator on may cause
serious damage to the transmission.

This section gives you tips on
starting the engine under various
conditions, and how to operate the
automatic transmission. It also
includes important inf ormation on
parking your vehicle, the braking
system, the VTM-4 System, and
f acts you need if you are planning to
tow a trailer.........................
Driving Guidelines .136
.......................
Starting the Engine .137
..............
Automatic Transmission . 138
..............................
VTM-4 System .142
..................................
Parking Tips .143
.............................
Braking System .144
...............
Anti-lock Brakes (ABS) . 145
...........................
Towing a Trailer .147
......................
Trailer Driving Tips .152
Towing Your Vehicle Behind a ................................
Motorhome .154
Of f -Highway Driving ..................................
Guidelines .155
Driving
Driving135

If the malf unction indicator lamp
comes on along with the ‘‘D’’
indicator, there is a problem in the
automatic transmission control
system. Avoid rapid acceleration and
havethetransmissioncheckedbya
Honda dealer as soon as possible.
These indicators on the instrument
panel show which position the shif t
lever is in.
The ‘‘D’’ indicator comes on f or a
f ew seconds when you turn the
ignition switch to ON (II). If it
f lashes while driving (in any shif t
position), it indicates a possible
problem in the transmission. To shif t f rom any position, pull the
lever toward you. You cannot shif t
out of Park when the ignition switch
is in the LOCK (0) or ACCESSORY
(I) positions.
Automatic Transmission
Driving
Shif t L ever Position Indicators
Shif ting
138
SHIFT LEVER

µµ µ
µTo shift from: PtoR
RtoP
NtoR
Dto2 2to1
1to2
2toD
DtoD DtoN
DtoD NtoDRtoN Do this:
Press the brake pedal and
pull the shift lever towards
you.
Pull the shift lever towards
you.
Move the lever.
3
3
3
3
This position mechani-
cally locks the transmission. Use
Park whenever you are turning of f or
starting the engine. To shif t out of
Park, you must press on the brake
pedal and have your f oot of f the
accelerator pedal.
If you have done all of the above and
still cannot move the lever out of
Park, see on
page .
To avoid transmission damage, come
to a complete stop bef ore shif ting
into Park. The shif t lever must be in
Park bef ore you can remove the key
from the ignition switch.
Press the brake
pedal and pull the shif t lever towards
you to shift from Park to Reverse. To
shif t f rom Reverse to Natural, come
to a complete stop and then shift. Use Neutral if you
need to restart a stalled engine, or if
it is necessary to stop brief ly with
the engine idling. Shif t to the Park
position if you need to leave your
vehicle for any reason. Press on the
brake pedal when you are moving
the shift lever from Neutral to
another gear.
Use this position f or
your normal driving. The transmis-
sion automatically selects a suitable
gear f or your speed and acceleration.
You may notice the transmission
shif ting up at higher speeds when
the engine is cold. This helps the
engine warm up f aster.
141
CONT INUED
Park (P)
Shif t L ock Release
Reverse (R) Neutral (N)
Drive (D)
Automatic Transmission
Driving139

µµ µ
This position is
similar to D, except only the f irst
three gears are selected. Use D
when towing a trailer in hilly terrain,
or to provide engine braking when
going down a steep hill. D can also
keep the transmission f rom cycling
between third and f ourth gear in
stop-and-go driving.
This position locks
the transmission in second gear. It
does not downshif t to f irst gear
when you come to a stop.
Use Second gear:
For more power when climbing.
To increase engine braking when
going down steep hills.
For starting out on a slippery
surf ace or in deep snow.
To help reduce wheel spin. When driving downhill with a
trailer.
This position locks, the
transmission locks in f irst gear. By
upshif ting and downshif ting through
1, 2, D , and D, you can operate the
transmission much like a manual
transmission without a clutch pedal. If you exceed the maximum speed
f or the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may f eel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
RPM below the red zone.
3
3 3
Drive (D )
Second (2) First (1)
Engine Speed L imiter3
Automatic Transmission
Driving140

Do this if pushing on the brake pedal
and pulling the shif t lever does not
shif t the transmission out of Park:Set the Parking brake. If you need to use the Shif t Lock
Release, it means your vehicle is
developing a problem. Have it
checked by a Honda dealer.
Put a cloth on the edge of the Shif t
Lock Release slot cover. Using a
key, caref ully pry on the edge of
the cover to remove it. Make sure the key is in the
ignition switch LOCK (0) position. Insert the key in the Shift Lock
Release slot.
Push down on the key while you
pull the shif t lever towards you
and move it out of Park to Neutral.
Remove the key from the Shift
Lock Release slot, then install the
cover. Press the brake pedal, and
restart the engine.
3. 4.
5.
6.
1.
2. Shif t L ock Release
Automatic Transmission
Driving141

The Variable Torque Management
4WD System (VTM-4) automatically
transf ers varying amounts of engine
torque to the rear wheels under
lower traction conditions.
If more traction is needed when your
vehicle is stuck, or is likely to
become stuck, you can use the
VTM-4 Lock button to increase
torque to the rear wheels.The vehicle must be stopped with
the engine running.
Move the shift lever to First (1),
Second (2), or Reverse (R) gear.
Press the VTM-4 Lock button.
The light in the button will come
on.
To get unstuck, apply light pressure
to the accelerator pedal. Do not spin
the f ront tires f or more than a f ew
seconds. Because of the amount of
torque applied to the rear tires, they
should not spin. This is normal. If
you are not able to move the vehicle,
stop and reverse direction. do
one of the f ollowing: Press the VTM-4 Lock button.
Move the shift lever to D or D .
Turn the ignition to LOCK (0).
The VTM-4 Lock will temporarily
disengage when the vehicle speed
exceeds 18 mph (30 km/h). It will
automatically engage again as the
speed slows below 18 mph (30
km/h). The button light will remain
on.
1.
2.
3.
3
To Engage the VTM-4 Lock To Disengage the VTM-4 Lock,
VTM-4 System
Driving142
NOTICE:
NOTICE:
Do not use the VTM-4 Lock
button on dry, paved roads. Driving on
dry, paved roads with VT M-4 Lock ON
may damage the rear dif f erential when
making a turn. Strange noise and
vibration can also result. Do not continually spin the
f ront tires of your vehicle.
Continuously spinning the f ront tires
can cause transmission or rear
dif f erential damage.

µ
Allow more time and distance f or
braking. Do not brake or turn
suddenly the trailer could
jackknif e or turn over.
When driving with a f ix-sided (e.g.
camper, utility) trailer, do not
exceed 55 mph (88 km/h). At
higher speeds, the trailer may
sway or affect vehicle handling.
Whenbeingpassedbyatruckor
large vehicle, cross-winds and air
turbulence can disrupt your
steering and cause your trailer to
sway. Keep a constant speed, steer
straight ahead, and do not try to
make quick steering or braking
corrections. Do not park on an incline unless it
is unavoidable. If you must, turn
the vehicle’s wheels toward the
curb on a downhill or away f rom
the curb on an uphill. Af ter
parking, place wheel chocks at
each trailer tire on the downhill
side.
Always drive slowly and have
someone guide you when backing up.
Grip the of the steering
wheel; then turn the wheel to the lef t
to get the trailer to move to the lef t,
andturnthewheelrighttomovethe
trailer to the right.
If the vehicle’s wheels slip when
retrieving a boat f rom the water,
shif t to f irst gear, and turn on VTM-4
Lock (see page ). Disengage
VTM-4 Lock as soon as the boat is
out of the water to prevent damage
to the VTM-4 system. When climbing hills, closely watch
your temperature gauge. If it nears
the red (Hot) mark, reduce speed
and, if necessary, pull to the side of
the road and let the engine cool.
If the transmission shif ts f requently
while going up a hill, shif t down one
gear.
If youmuststopwhenfacinguphill,
use the f oot brake or the parking
brake. Do not try to hold the vehicle
inplacebypressingonthe
accelerator; this could cause the
automatic transmission to overheat.
When driving down hills, reduce
your speed and shif t down to D . Do
not ‘‘ride’’ the brakes.
142
bottom
3
Backing Up
Ret rieving a Boat Driving on Hills
Trailer Driving Tips
Driving
Remember: It will take longer to
slow down and stop when towing
atrailer.
153