2004 HONDA ACCORD position

After the seat reaches a comfortable
temperature, select LO by pushing
the back of the switch. This will keep
the seat warm.
In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
Both f ront seats are equipped with
seat heaters. The ignition switch
must be in the ON (II) position to
use them. The seat heater switch is
located on each f ront door. Push the
f ront of the switch, HI, to rapidly
heat up the seat.
On EX-V6 models and EX models with leather interior
Seat Heaters
Inst rument s and Cont rols91
——y

y
(
yy

µ
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs.
On EX-V6 model On all EX and EX-V6 models
12 13
On all V6 models, and the 4-cylinder EX
model with leather interior
Moving the long horizontal switch
adjusts the seat bottom in several
directions. The seat bottom adjusts
in the direction you move the switch.
The short vertical switch adjusts the
seat back angle. Raises or lowers the
seat.
Adjusts the seat-back
angle f orward or
backward.
Moves the f ront of the
seat up or down and
the rear of the seat up
or down.
Moves the seat
f orward and backward.
The passenger’s seat also has power
adjustable controls. To change the lumbar support, move
the lever on the right side of the
seat-back forward or backward.
Keep moving the lever f orward or
backward until you f ind a suitable
position.
The controls f or the adjustable
driver’s power seat are on the
outside edge of the seat bottom. You
can adjust the power seat with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving.
Driver’s L umbar Support
Power Seat A djustment
Seats
Inst rument s and Cont rols92
——y

y
(
yy

The f ront passenger’s seat in all
4-cylinder models, and the LX V-6
models adjusts manually.To adjust the seat forward and
backward, pull up on the lever under
the seat cushion’s f ront edge. Move
the seat to the desired position and
releasethelever.Trytomovethe
seat to make sure it is locked in
position.To change the seat-back angle, pull
up on the lever on the outside of the
seat bottom.
The 4-cylinder EX model without
leather interior has a power height
adjustment f or the driver’s seat. All
other seat adjustments in this model
are manual.
The U.S. DX and LX models have
manual seat adjustments (see next
column).
FrontSeatAdjustments
Seats
Inst rument s and Cont rols93
——y

y
(
yy

The height of your driver’s seat is
adjustable. To raise the seat bottom,
repeatedly pull up the lever on the
outside of the seat cushion. To lower
the seat, push down the lever
repeatedly.The height of your driver’s seat is
power adjustable. Pull up on the
switch to raise the seat. Push it down
to lower the seat.
Make all adjustments bef ore you
start driving.Your vehicle is equipped with head
restraints in all seating positions to
help protect you and your
passengers f rom whiplash and other
injuries.
See page f or important saf ety
inf ormation and a warning about how to
properly position the head restraints. 14
On 4-cylinder DX and LX models On 4-cylinder EX models without leather interior
Head Restraints
Driver’s Seat Manual Height
Adjustment Driver’s Seat Power Height
Adjustment
Seats
Inst rument s and Cont rols94
RELEASE BUTTON
——y

y
(
yy

To release the seat-back from inside
the trunk, pull the release loop under
the trunk panel.
To lock the seat-back upright, push it
f irmly against the trunk panel. Make
sure it is latched in place by pulling
on the top of the seat.Make sure all rear shoulder belts are
positioned in f ront of the rear seat-
back whenever the seat-back is in its
upright position.
Make sure all items in the trunk, or
items extending through the opening
into the back seat, are secured.
Looseitemscanflyforwardand
cause injury if you have to brake
hard. See on page
. Never drive with the seat-back
f olded down and the trunk lid open.
See on
page .
56
173 Carrying Cargo Carbon Monoxide Hazard
Seats
Inst rument s and Cont rols96
Pull
——y

y
(
yy

Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The outside mirrors on DX models
adjust manually.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.Push or pull the adjustment knob
right, left, up, or down to move the
mirror.
Turn the adjustment knob to L
(driver’s side) or R (passenger’s
side).
Turn the ignition switch to ON (II). When you f inish, turn the
adjustment knob to the center
(of f ) position. This turns of f the
adjustment knob to keep your
settings.
1. 3.
2. 4.
On all models except U.S. and Canada
DX
Adjusting the Power Mirrors
Mirrors
Inst rument s and Cont rols98
TAB
ADJUSTMENT KNOB
——y

y
(
y

y

µ
The outside mirrors are heated to
remove fog and frost. With the
ignition switch in the ON (II)
position, turn on the heaters by
pressing the button. The indicator in
the button comes on as a reminder.
Press the button again to turn the
heaters off. To open the driver’s
window, push the window switch
f irmly down, then release it. The
window automatically goes down all
the way. To stop the window from
going all the way down, pull back on
the window switch briefly.
Turn the ignition switch to ON (II)
toraiseorloweranywindow,push
the switch down and hold it. Release
the switch when you want the
window to stop. Close the window by
pulling the switch up and holding it. The passenger windows cannot be
raised or lowered if the MAIN switch
is OFF. Keep the MAIN switch off
whenyouhavechildreninthe
vehicle so they do not injure
themselves by operating the
windows unintentionally.
On all Canadian models except DX
Power Mirror Heaters
AUTO
Power Windows
Mirrors, Power Windows
Inst rument s and Cont rols99
HEATED MIRROR BUTTON
DRIVER’S WINDOW
SWITCHMAIN SWITCHClosing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.
——y

y
(
y
y

Turnthekeyclockwiseagain,and
hold it. All f our windows start to
open. To stop the windows,
release the key.
To open the windows f urther, turn
andholdthekeyagain.
To close: Insert the key in the driver’s door
lock.
Turn the key counterclockwise,
then release it.
Turn the key counterclockwise
again, and hold it. All four
windowsstarttoclose.Tostopthe
windows, release the key.
To close the windows f urther, turn
andholdthekeyagain. The moonroof has two positions: it
can be tilted up in the back f or
ventilation, or it can be slid back into
the roof . Use the switch under the
lef t dashboard vent to operate the
moonroof . The ignition switch must
be ON (II). To tilt up the back of the moonroof ,
press and hold the center button
( ). To close the moonroof ,
press and hold the upper button
( ). To open the moonroof ,
press and hold the lower button
( ). Release the button when
the moonroof gets to the desired
position. Make sure everyone’s
hands are away f rom the moonroof
bef ore opening or closing it.
1. 2.3. 4.
3.4.
On all EX and EX-V6 models
Moonroof
Power Windows, Moonroof
Inst rument s and Cont rols102
MOONROOF SWITCH
Opening or closing the
moonroof on someone’s hands
or fingers can cause seriousinjury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.
——y



y
(
y
y