2004 HONDA ACCORD COUPE ECU

Move the steering wheel so it
points to your chest, not toward
your f ace. Make sure you can see
the instrument panel gauges and
indicators.
Push the lever up to lock the
steering wheel in position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up, down, in,
and out.
Insert the key in the ignition
switch, and unlock the steering
column.
Push the lever under the steering
column all the way down.
Make any steering wheel adjustment
bef ore you start driving.
3. 4. 5.
2.
1.See page f or important saf ety
inf ormation about how to properlyposition the steering wheel. 15
Steering Wheel A djustment
Inst rument s and Cont rols74
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.
——y

y
(%
yy

µµ
µ
µ
CONT INUED
Press this button once to
lock both doors. Some exterior lights
will f lash once. When you push
LOCK twice within 5 seconds, you
will hear a beep to verify that the
doors are locked and (if equipped)
that the security system has set. You
cannot lock it if either door is not
f ully closed or the key is in the
ignition switch. Press this button once
to unlock the driver’s door. Push it
twice to unlock the passenger’s door.
Some exterior lights will f lash twice
each time you push the button. If
you do not open either door within
30 seconds, they will automatically
relock and the security system sets
(except f or 4-cylinder LX model).
You cannot unlock it if the key is in
the ignition switch.
The ceiling light (if the ceiling light
switch is in the center position) and
the spotlights (if the switch is in the
Door position) will come on when
you press the UNLOCK button. If
you do not open either door, the
lights stay on f or about 30 seconds,
then f ade out. If you relock the doors
with the remote transmitter before
30 seconds have elapsed, the lights
will go of f immediately. You can also open both power
windows from outside the vehicle
with the remote transmitter (see
page ).
Press this
button f or about one second to open
the trunk. You cannot open it if the
key is in the ignition switch.
Pressthisbuttonfor
about two seconds to attract
attention: the horn will sound and
the exterior lights will f lash f or about
30 seconds. To cancel panic mode,
press any other button on the remote
transmitter or turn the ignition
switch to ON (II). 93
Remote Transmitter
Inst rument s and Cont rols
LOCK
UNL OCK
T RUNK REL EA SE
PA NIC
79
UNLOCK
BUTTONLOCK
BUTTON
TRUNK
RELEASE
BUTTON
PANIC
BUTTON LED
——y

y
(%
yy

Both f ront seats are equipped with
seat heaters. Because of the sensors
f or the side airbag system, there is
no heater in the passenger’s seat-
back. The ignition switch must be
ON (II) to use the heaters.
Make sure all rear shoulder belts are
positioned in f ront of the rear seat-
back whenever the seat-back is in its
upright position.
Make sure all items in the trunk, or
items extending through the opening
into the back seat, are secured.
Looseitemscanflyforwardand
cause injury if you have to brake
hard. See on page
.
Never drive with the seat-back
f olded down and the trunk lid open.
See on
page .
Push the front of the switch, HI, to
rapidly heat up the seat. Af ter the
seat reaches a comfortable
temperature, select LO by pushingthe back of the switch. This will keep
the seat warm.
In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.
Follow these precautions when using
the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.
173
51
On EX-V6 model and EX-L model
Seat Heaters
Carrying Cargo
Carbon Monoxide Hazard
Seats, Seat Heaters
Inst rument s and Cont rols90
SEAT HEATER
SWITCH
——y

y
(%
yy

The heating and air conditioning
systems in your Honda provide a
comf ortable driving environment in
all weather conditions.
The standard audio system has
many f eatures. This section de-
scribes those f eatures and how to
use them.
Your Honda has an anti-thef t audio
system that requires a code number
to enable it.
Navigation Systems are available on
U.S. models only.
The security system helps to dis-
courage vandalism and thef t of your
Honda.............
Vents, Heating, and A/C . 108
..........................
Using the A/C . 113
To Cool or Heat
.......................
Automatically . 115
.........
Dual Temperature Control . 117
.............
Climate Control Sensors . 119
.........................
Playing the Radio . 120
...........................
Radio Reception . 126
Playing the XM
Satellite
.........................................
Radio . 128
.................................
Playing a CD . 134
..................................
CD Changer . 137
...................
Protecting Your CDs . 142
........
CD Player Error Messages . 143
....
CD Changer Error Messages . 144
..............................
Playing a Tape . 146
............
Steering Wheel Controls . 152
................
Radio Thef t Protection . 153
.........................
Setting the Clock . 154
...........................
Security System . 155
..............................
Cruise Control . 156
HomeLink Universal
...............................
Transceiver . 159
On all models except f or 4-cylinder LX
model
Comf ort and Convenience Features
Comf ort and Convenience Feat ures107
——y

y
(%
y

y

The security system helps to protect
your vehicle and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lashes if
someone attempts to break into your
vehicleorremovetheradio.This
alarm continues f or two minutes,
then the system resets. To reset an
alarming system before the two
minutes have elapsed, unlock the
driver’s door with the key or the
remote transmitter.
The security system automatically
sets 15 seconds after you lock the
doors, hood, and trunk. For the
system to activate, you must lock the
doors f rom the outside with the key,
lock tab, door lock switch, or remote
transmitter. The security system
indicator on the instrument panel
starts blinking immediately to show
you the system is setting itself .Once the security system is set,
opening either door without using
the key or the remote transmitter,
the hood, or the trunk will cause it to
sound. It also sounds if the radio is
removed f rom the dashboard or the
wiring is cut.With the system set, you can still
open the trunk with the remote
transmitter without triggering the
alarm. The alarm will sound if the
trunk lock is f orced, or the trunk is
opened with the trunk release handle
or the emergency trunk opener.
The security system will not set if
the hood, trunk, or either door is not
f ully closed. If the system will not set,
check the Door and Trunk Open
Monitor on the instrument panel
(see page ), to see if the doors
and the trunk are f ully closed. Since
it is not part of the monitor display,
manually check the hood.
Do not attempt to alter this system
or add other devices to it.
61
On all models except f or 4-cylinder LX
model and all Canadian models
Comf ort and Convenience Feat ures
Security System
155
SECURITY SYSTEM INDICATOR
——y
y
(%
y
y

µ
The HomeLink
Universal
Transceiver built into your vehicle
canbeprogrammedtooperateupto
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor f or that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
The HomeLink transceiver stores
the code in a permanent memory.
There should be no need to retrain
the transmitter if your vehicle’s
battery goes dead or is disconnected.
If your garage door opener was
manuf actured bef ore April 1982, you
may not be able to program
HomeLink to operate it. They do not have the saf ety f eature
that causes the motor to stop and
reverse if an obstacle is detected
during closing, increasing the risk of
injury.
For quick and accurate training,
make sure the remote control
transmitter for the device (garage
door, automatic gate, security
system, etc.) has a fresh battery.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the first button.
Todothis,pressandholdthetwo
outside buttons on the HomeLink
transceiver for about 20 seconds, or
until the red light f lashes. Release
the buttons, then proceed to Step 1.
If you are training the second or
third buttons, go directly to Step 1.
HomeLink
is a registered
trademark of Johnson Controls .
Always ref er to the operating
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with the HomeLink
Universal Transceiver. If you do not
have this inf ormation, you should
contact the manuf acturer of the
equipment.
CONT INUED
On EX-V6 model
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures
General Inf ormation T raining HomeL ink
Important Saf ety Precautions
Bef ore you begin
159
TM
——y

y
(%
y
y

Press and hold the remote control
button and one of the HomeLink
buttons at the same time.
Unplug the garage door opener
motor f rom the house current. The remote control
you are training f rom may stop trans-
mitting after two seconds. This is not
enough f or HomeLink to learn the
code. Release and press the button
on the remote control every two
seconds until HomeLink has learned
the code.
The red light in HomeLink should
begin f lashing. It will f lash slowly
at first, then rapidly.
When the red light f lashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control. Plug in the garage door opener
motor, then test the HomeLink
transceiver button by pushing it. If
the button does not work, repeat
the procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink transceiver button you
just trained. If the red light blinks
f or two seconds then stays on, you
have a rolling code garage door
opener. Go to ‘‘Training with a
Rolling Code System’’ (see page
)
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
Holdtheendof thegaragedoor
opener remote control 2 to 5
inches f rom the HomeLink
transceiver. Make sure you are not
blocking your view of the red light
in HomeLink.
2. 3. 4.
1.
5.6. 7.
161
Canadian Owners:
Comf ort and Convenience Feat ures
HomeL ink Universal T ransceiver
160
——y
y
(%
y
y

µµ
For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Inf ormation f rom
the remote control and the garage
door opener are needed bef ore
HomeLink can operate the garage
door opener.
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The f ollowing procedure
synchronizes HomeLink to the
garage door opener so they send and
receive the correct codes.
Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure. Press the Training button on the
garage door opener unit until the
light next to the button comes on,
then release it. The light may blink,
or come on and stay on. You then
have approximately 30 seconds to
complete the f ollowing steps.Press and hold the button on
HomeLink f or 3 4 seconds.
Press and hold the HomeLink
button again f or 3 4 seconds.
This should turn of f the training
light on the garage door opener
unit. (Some systems may require
youtopressthebuttonuptothree
times.)
Press the HomeLink button again.
It should operate the garage door.
Find the ‘‘Training’’ button on your
garage door opener unit. The
location will vary, depending on
the manufacturer. 6.
2. 4. 5.
1. 3.
T raining With a Rolling Code
System
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures161
TRAINING BUTTON
——y
y
(%
y
y