2004 HONDA ACCORD COUPE buttons

ÛÝÛÝ
To set the driver’s side temperature
to a different value than the
passenger’s, press the DUAL button,
then turn the driver’s control dial or
press the or buttons on the
driver’s side. To set the passenger’s
side to a dif f erent value than the
driver’s, turn the passenger’s control
dial or press the or buttons on
the passenger’s side. You can adjust
the passenger’s side without
pressing the DUAL button first.
When you set the temperature to its
lower limit or its upper limit, it will be
displayed as ‘‘ ’’ or ‘‘ ’’.
Dual Temperature Control
Comf ort and Convenience Feat ures118
DRIVER’S SIDE PASSENGER’S SIDE
——y
y
(%
y

y

CONT INUED
Playing the Radio
Comf ort and Convenience Feat ures121
PWR/VOL KNOB
STEREO INDICATOR
A.SEL
BUTTON
SEEK BAR TUNE BAR
PRESET
BARS
TUNE BAR
PRESET
BARS
SOUND BUTTON
SCAN BUTTON
A.SEL
BUTTON
PWR/VOL KNOB SOUND BUTTON
AM/FM BUTTON
SCAN BUTTON
EX-L and EX-V6 models
(Canadian Vehicles only)
AM/FM
BUTTONSTEREO
INDICATOR
SEEK
BAR
EX-L and EX-V6 models
without Navigation System
(U.S. Vehicles only)
——y
y
(%
y
y

µ
The HomeLink
Universal
Transceiver built into your vehicle
canbeprogrammedtooperateupto
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor f or that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
The HomeLink transceiver stores
the code in a permanent memory.
There should be no need to retrain
the transmitter if your vehicle’s
battery goes dead or is disconnected.
If your garage door opener was
manuf actured bef ore April 1982, you
may not be able to program
HomeLink to operate it. They do not have the saf ety f eature
that causes the motor to stop and
reverse if an obstacle is detected
during closing, increasing the risk of
injury.
For quick and accurate training,
make sure the remote control
transmitter for the device (garage
door, automatic gate, security
system, etc.) has a fresh battery.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the first button.
Todothis,pressandholdthetwo
outside buttons on the HomeLink
transceiver for about 20 seconds, or
until the red light f lashes. Release
the buttons, then proceed to Step 1.
If you are training the second or
third buttons, go directly to Step 1.
HomeLink
is a registered
trademark of Johnson Controls .
Always ref er to the operating
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with the HomeLink
Universal Transceiver. If you do not
have this inf ormation, you should
contact the manuf acturer of the
equipment.
CONT INUED
On EX-V6 model
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures
General Inf ormation T raining HomeL ink
Important Saf ety Precautions
Bef ore you begin
159
TM
——y

y
(%
y
y

Press and hold the remote control
button and one of the HomeLink
buttons at the same time.
Unplug the garage door opener
motor f rom the house current. The remote control
you are training f rom may stop trans-
mitting after two seconds. This is not
enough f or HomeLink to learn the
code. Release and press the button
on the remote control every two
seconds until HomeLink has learned
the code.
The red light in HomeLink should
begin f lashing. It will f lash slowly
at first, then rapidly.
When the red light f lashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control. Plug in the garage door opener
motor, then test the HomeLink
transceiver button by pushing it. If
the button does not work, repeat
the procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink transceiver button you
just trained. If the red light blinks
f or two seconds then stays on, you
have a rolling code garage door
opener. Go to ‘‘Training with a
Rolling Code System’’ (see page
)
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
Holdtheendof thegaragedoor
opener remote control 2 to 5
inches f rom the HomeLink
transceiver. Make sure you are not
blocking your view of the red light
in HomeLink.
2. 3. 4.
1.
5.6. 7.
161
Canadian Owners:
Comf ort and Convenience Feat ures
HomeL ink Universal T ransceiver
160
——y
y
(%
y
y

Toerasethecodesstoredinallthree
buttons, press and hold the two
outside buttons until the red light
begins to f lash, then release the
buttons.
Youshoulderaseallthreecodes
bef ore selling the vehicle.
Totrainanalreadyprogrammed
transceiver button with a new device,
you do not have to erase all the
memory. Train the selected button
over the existing memory code
f ollowing the steps under. If you have problems with training
the HomeLink Universal Transceiver,
or would like inf ormation on home
products that can be operated by the
transmitter, call (800) 355-3515. On
the Internet, go to www.homelink.
com.
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, including
interf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not cause
interf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures
Erasing Codes Customer Assistance
Retraining a Button
T raining
HomeL ink
162
——y
y
(%
y
y

There are hooks on the f loor and
sides of the trunk. They can be used
to install a net f or securing items.The cargo net can be used to help
hold down items stored in the trunk.
To use the cargo net, hook it to the
buttons on the f loor and sides of the
trunk. You can use the cargo net in
several conf igurations by hooking it
to dif f erent buttons.
When you are not using the cargo
net,storeitinthesparetirewell.On all EX and EX-V6 models
Carrying Cargo
Bef ore Driving
T runk Hooks Cargo Net
176
——y

y
(%
y
y

......
Taillights, Changing Bulbs in . 238
.
Taking Care of the Unexpected . 255
Technical Descriptions
......
DOT Tire Quality Grading . 288
.....
Emissions Control Systems . 293
.....................
Oxygenated Fuels . 164
Three Way Catalytic
...............................
Converter . 295
.......................
Temperature Gauge . 67 ........
Temperature, Inside Sensor . 119
....................
Temperature, Outside . 66
..............
Tether Anchorage Points . 45
..
Three Way Catalytic Converter . 295
..................
Tilt the Steering Wheel . 74
..........................
Time, Setting the . 154
....................................
Timing Belt . 232
....................................
Tire Chains . 250
.........
Tire, How to Change a Flat . 257
...........................
Tire Inf ormation . 290
...............................................
Tires . 245
......................
Air Pressure . 245, 246
........................................
Chains . 250
.........................
Checking Wear . 247
..........................
Compact Spare . 256
......
DOT Tire Quality Grading . 288
......................................
Inf lation . 245
..................................
Inspection . 247
.....................................
Labeling . 290
...................................
Replacing . 248
......................................
Rotating . 248
...........................................
Snow . 250
....................
Specif ications . 285, 287
...................
Tools, Tire Changing . 257
Towing
.....................................
A Trailer . 194 ................
Emergency Wrecker . 272
....
Equipment and Accessories . 196
.....................
Weight Limit . 194, 195
..
Traction Control System (TCS) . 191
...
TCS Activation Indicator . 60, 192
......................
TCS Indicator . 60, 191
...............
TCS ON/OFF Switch . 192
.............................
Trailer Loading . 194
......................
Trailer Towing Tips . 198
Transmission
Checking Fluid Level, ......................
Automatic . 225, 226
Checking Fluid Level, ...................................
Manual . 228
..................
Fluid Selection . 225, 228
..............
Identif ication Number . 283
.............
Shif ting the Automatic . 183
..................
Shif ting the Manual . 180
.....................................
Treadwear . 288
.......................................
Trip Meter . 66
................................................
Trunk . 82
....................
Emergency Opener . 82
.........................................
Hooks . 176
.................................
Opening the . 82
.............
Open Monitor Indicator . 61
....................................
Turn Signals . 70
Steering Wheel
..................................
Adjustment . 74
.............
Anti-theft Column Lock . 77
...............
Steering Wheel Buttons . 152
Stereo Sound
........................................
System . 120
....................
Storing Your Vehicle . 254
........................................
Sun Visor . 101
........................
Sunglasses Holder . 103
Supplemental Restraint System
......................................
Servicing . 30
.........................
SRS Indicator . 27, 59
...................
System Components . 21
..................................
Synthetic Oil . 218
Index
T
VIII
——y

y
(%
y
y