Engine Data
Engine 2.0L SVT Zetec engine
Cubic inches 121
Horsepower 170@7000
Torque 145 lb-ft @5500 rpm
Required fuel 91 octane
Firing order 1–3–4–2
Spark plug gap 1.3 mm (0.051 inch)
Ignition system Electronic Ignition
Compression ratio 10:2:1
6–SPEED TRANSMISSION
Shift pattern
The shift pattern is shown opposite.
To select reverse gear, shift the
lever into neutral position and then
move the lever fully to the left-hand
side of the gate against the spring
pressure. Once the lever is fully to
the left, push it forward into the
reverse gear position.
Drivetrain
Item Description
Transaxle GetragTwin layshaft 6–speed manual
Gear RatiosGear Overall ratio Speed (mph)
1st 12.7:1 15
2nd 7.7:1 25
3rd 5.7:1 35
4th 4.6:1 45
5th 3.8:1 55
6th 3.1:1 60
Reverse 12.0:1—
Engine/Transmission/Drivetrain
10
•Tire pressures are specified“cold”and should be checked after the
vehicle has been parked for at least 3 hours. Do not reduce pressure
of warm tires.
•Check your tire pressure often to maintain it properly. Tire pressure
can diminish over time and fluctuate with temperature.
•Do not overload your vehicle. Maximum vehicle and axle weights are
listed on the tire information placard.
•Extra caution should be taken when operating the vehicle near its
maximum load, including assuring proper tire pressure and reducing
speeds.
•Extra caution should be taken when operating on rough roads to avoid
impacts that could cause tire damage.
•In the event that you encounter an abnormally harsh impact, inspect
your tires for damage.
•Inspect your tires for damage on a regular basis. If a tire is damaged,
replace it immediately.
•Proper suspension alignment is critical for maximum performance and
optimal tire wear. If you notice uneven tire wear, have your alignment
checked.
•Rotate tires as recommended in your Owner’s Guide or SVT Owner’s
Guide Supplement.
•When replacing tires, the only way to assure original performance is to
use the original equipment tire. If a different tire is used, it should be
the same size, speed rating and load rating.
Wheels
Your SVT vehicle is equipped with unique wheels matched to the tires.
These wheels are more susceptible to damage due to their diameter,
width and low profile tires. To reduce the risk of damage to your wheels:
•Maintain proper tire pressure (see“Tires”previously listed).
•Extra caution should be taken when using automatic car washes.
Although your vehicle is capable of being washed in an automatic car
wash, equipment may vary and wheel damage is possible.
•When installing wheels, always torque lug nuts to specification with a
torque wrench.
•Inspect your wheels for damage on a regular basis. If a wheel is
damaged, replace it immediately.
•In the event that you encounter an abnormally harsh impact, inspect
the outer diameter of your wheels, both inside and out, for damage
Chassis
12
