2004 FORD EXPEDITION set clock

[x] Cancel search: set clock

Page 19 of 344

FORD EXPEDITION 2004 2.G Owners Manual In CD mode, REW control reverses the CD within the current track.
FF (Fast Forward):Works in tape
and CD modes.
In the tape mode, tape direction
automatically reverses when the end of the tape is reac

Page 24 of 344

FORD EXPEDITION 2004 2.G Owners Manual Treble:Press TREB; then press
SEL
/to decrease/increase
the treble output.
7.Select:Use with Bass, Treble,
Balance and Fade controls to adjust
levels and set the clock.
8.Balance:Press BAL; then press

Page 25 of 344

FORD EXPEDITION 2004 2.G Owners Manual COMP OFF is displayed. Press the SEL control again to disable the
feature when COMP ON is displayed.
Setting the clock:Press MENU until SELECT HOUR or SELECT
MINUTE is displayed. Use SEL to manually i

Page 77 of 344

FORD EXPEDITION 2004 2.G Owners Manual Display options
Use this feature to change the
display setting. This feature can be
accessed by selecting“Display
Options”within the Main Menu.
Use the cursor control to select one
of the followin

Page 78 of 344

FORD EXPEDITION 2004 2.G Owners Manual 5. Select the SET soft key to synchronize/set the minutes and seconds to
GPS time. The hours will remain at the user set value.
You may choose to set the clock to a 12 or 24 hour display.
General info

Page 254 of 344

FORD EXPEDITION 2004 2.G Owners Manual 3. Unsnap the wheel lug nut wrench, jack extension and handle from the
plastic tray. Remove the jack and instruction sheet from the tray
assembly.
Removing the spare tire
1. Fold the rear seat down. R

Page 255 of 344

FORD EXPEDITION 2004 2.G Owners Manual 1. Park on a level surface, activate
hazard flashers and set the parking
brake.
2. Place gearshift lever in P (Park),
turn engine OFF and block the
diagonally opposite wheel. (If
changing the tire on

Page 290 of 344

FORD EXPEDITION 2004 2.G Owners Manual battery. When the battery is disconnected or a new battery is installed,
the engine must relearn its idle and fuel trim strategy for optimum
driveability and performance. To begin this process:
1. Wit
Page:   1-8 9-16 next >