Page 74 of 397

N Manual Reclining Seats Ð If Equipped .......83
N Manual Lumbar Ð If Equipped ............84
N Middle Rear Bench Seat Recline Ð If
Equipped ............................84
N Middle Quad Fold & Tumble Seating ........85
N Middle Quad Fold & Tumble Seat Removal ....86
N 50/50 Fold & Tumble Rear Seat Removal .....88
N 2 ± Passenger And 3 ± Passenger Bench Seats . .90
N Plastic Grocery Bag Retainer ..............91
N Rear-Most Bench Seat ...................92
N Rear Seat Descriptions ...................92
N Rear Bench Seating Flexibility .............92
N Rear Quad And 50/50 Seating Flexibility .....94 m To Open And Close The Hood ..............96
m Lights ................................98
N Interior Lights ........................98
N Park Lights ...........................99
N Headlights ...........................99
N Automatic Headlights Ð If Equipped .......100
N Daytime Running Lights (Canada/Fleet
Vehicles Only) .......................101
N Lights-On Reminder ...................101
N Battery Protection .....................101
N Headlight Time Delay Ð If Equipped .......101
N Front Fog Lights Ð If Equipped ...........102
m Multifunction Lever .....................10274 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 96 of 397

WARNING!² Not all head restraints in this vehicle are the same.
Head restraints from one seating position should
not be removed and installed in any other seating
position. In a collision, serious injury or death may
result if the proper head restraint is not installed on
each seat.
² The cargo area in the rear of the vehicle should not
be used as a play area by children. They could be
seriously injured in a collision. Children should be
seated and using the proper restraint system.
² It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seriously
injured or killed.
² Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat belts.
² Be sure everyone in your vehicle is in a seat and
using a seat belt properly. TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released. First pull
the hood release lever located under the left side of the
instrument panel.96 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 97 of 397
Next, push to the left the safety catch located under the
front edge of the hood, near the center.
Use the hood prop rod to secure the hood in the open
position. To prevent possible damage, do not slam the hood to
close it. Lower the hood until it is open approximately 30
cm (12 inches) and then drop it. This should secure both
latches. Never drive your vehicle unless the hood is fully
closed, with both latches engaged.
WARNING!If the hood is not fully latched, it could fly up when
the vehicle is moving and block your forward vision.
You could have a collision. Be sure all hood latches
are fully latched before driving. UNDERSTANDING THE FEATURES OF YOUR VEHICLE 97
3
Page 318 of 397

Cooling System
Inspection
WARNING!² When working near the radiator cooling fan, turn
the ignition key to the OFF position. The fan is
temperature controlled and can start at any time
when the ignition key is in the ON position.
² You or others can be badly burned by hot coolant
or steam from your radiator. If you see or hear
steam coming from under the hood, don't open
the hood until the radiator has had time to cool.
Never try to open a cooling system pressure cap
when the radiator is hot. Coolant Checks
Coolant protection checks should be made every 12
months (prior to the onset of freezing weather, where
applicable). If coolant is dirty or rusty in appearance, the
system should be drained, flushed and refilled with fresh
coolant. Check the front of the A/C condenser for any
accumulation of bugs, leaves, etc. If dirty, clean by
removing the upper grill support and gently spraying
water from a garden hose vertically down the face of the
condenser.
Check the coolant recovery bottle tubing for brittle rub-
ber, cracking, tears, cuts and tightness of the connection
at the bottle and radiator. Inspect the entire system for
leaks.
With the engine at normal operating temperature (but
not running), check the coolant pressure cap for proper
vacuum sealing by draining a small amount of coolant318 MAINTAINING YOUR VEHICLE