etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contact HomeLink at:www.homelink.com or 1-800-355-
3515.
Erasing HomeLink Buttons
To erase programming from the three buttons (individual
buttons cannot be erased but can be9reprogrammed9-
note below), follow the step noted:
²Press and hold the two outer HomeLink buttons until
the indicator light begins to flash-after 20 seconds.
Release both buttons. Do not hold for longer that 30
seconds. HomeLink is now in the train (or learning)
mode and can be programmed at any time beginning
with9Programming9- step 2.
Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink button.Do
NOTrelease the button.
2. The indicator light will begin to flash after 20 seconds.
Without releasing the HomeLink button, proceed with
9Programming9step 2
For questions or comments, contact HomeLink at:
www.homelink.com or 1-800-355-3515.
Security
If you sell your vehicle, be sure to erase the frequencies.
To erase all of the previously trained frequencies, hold
down both outside buttons until the green light begins to
flash.
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
This device complies with part 15 of FCC rules and with
RSS-210 of Industry Canada. Operation is subject to the
following conditions:
²This device may not cause harmful interference.
²This device must accept any interference that may be
received including interference that may cause undes-
ired operation.
NOTE:Changes or modifications not expressly ap-
proved by the party responsible for compliance could
void the user's authority to operate the equipment.
HomeLinktis a trademark owned by Johnson Controls,
Inc.
POWER SUNROOF Ð IF EQUIPPED
The power sunroof control is located between the sun
visors on the overhead console.
Press and hold the switch rearward to fully open the
sunroof. The sunroof can be stopped at any position
between closed and full open. Momentarily pressing the
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 125
3
High Beam/Low Beam Select Switch........ 103
Lights On Reminder.................... 101
Replacing............................ 339
Time Delay.......................... 101
Heated Seats............................ 82
Heater............................... 199
Heater, Engine Block..................... 230
Homelink Transmitter..................... 119
Hood Release........................... 96
Hoses.............................322,326
Ignition
Key ................................. 12
Illuminated Entry........................ 16
Immobilizer............................ 13
Indicator, Traction Control................. 156
Infant Restraint.......................... 59
Information Center.................... 115,159
Information Center, Vehicle.............. 115,159Inside Rearview Mirror.................... 77
Instrument Cluster.................149,150,151
Instrument Panel and Controls.............. 148
Instrument Panel Lens Cleaning............. 334
Integrated Child Seat...................... 58
Integrated Power Module.................. 336
Interior Appearance Care.................. 333
Interior Fuses.......................... 336
Interior Lights.........................98,99
Intermittent Wipers.................104,219,220
Introduction............................. 4
Jack Location........................... 283
Jack Operation.......................282,285
Jump Starting.......................... 288
Key, Programming........................ 15
Key, Replacement........................ 15
Key, Sentry............................. 13
388 INDEX
