Page 64 of 341

NFolding Front Passenger Seat Ð If Equipped . . .84
NAdjustable Head Restraints...............85
NHeated Seats Ð If Equipped..............85
NFolding Rear Seat......................86
NTumbling Rear Seat.....................88
NRear Seat Removal.....................90
mTo Open And Close The Hood..............92
mLights................................93
NOverhead Console Map/Reading Lights Ð If
Equipped............................93
NInterior Lights........................94
NMulti-Function Control Lever..............95
NHeadlights, Parking Lights, Instrument Panel
Lights..............................96NDaytime Running Lights (Canada Only)......96
NLights-On Reminder....................96
NFog Lights Ð If Equipped................97
NTurn Signals..........................97
NHighbeam/Lowbeam Select Switch..........97
NPassing Light.........................97
mWindshield Wipers And Washers............98
NWindshield Washers....................98
NMist Feature..........................98
NWindshield Wiper Operation..............99
NIntermittent Wiper System................99
mTilt Steering Column....................100
mTraction Control Switch Ð If Equipped.......100
64 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 98 of 341
WINDSHIELD WIPERS AND WASHERS
The wipers and washers are operated by a switch
on the control lever. The lever is located on the
right side of the steering column. Move the con-
trol lever up to select the desired wiper speed.
Windshield Washers
To use the washer, pull the control lever toward you and
hold while spray is desired. If the lever is pulled while in
the delay range, the wiper will operate in low speed for
two wipe cycles after the lever is released, and then
resume the intermittent interval previously selected.
If the lever is pulled while in the OFF position, the wipers
will operate for two wipe cycles, then turn OFF.
Mist Feature
Push down on the wiper control lever to activate a single
wipe to clear the windshield of road mist or spray from
a passing vehicle. As long as the lever is held down, the
wipers will continue to operate.
98 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 99 of 341
CAUTION!
In cold weather, always turn off the wiper switch
and allow the wipers to return to the park position
before turning off the engine. If the wiper switch is
left on and the wipers freeze to the windshield,
damage to the wiper motor may occur when the
vehicle is restarted.
Windshield Wiper Operation
Move the lever upward to the second detent for Low
speed wiper operation, or to the third detent for High
speed operation
Intermittent Wiper System
Use the intermittent wiper when weather conditions
make a single wiping cycle, with a variable pause be-
tween cycles, desirable. Move the lever to the DEL
position, then select the delay interval by turning the end
of the lever. Rotate the knob upward (clockwise) to
decrease the delay time and downward (counterclock-
wise) to increase the delay time. The delay can be
regulated from a maximum of approximately 18 seconds
between cycles, to a cycle every second.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 99
3
Page 263 of 341

Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild non abrasive cleaner or use the washer solvent. This
will remove accumulations of salt, waxes or road film
and help reduce streaking and smearing.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield. Avoid using the wiper blades to
remove frost or ice from the windshield. make sure that
they are not frozen to the glass before turning them on to
avoid damaging the blade. Keep the blade rubber out of
contact with petroleum products such as engine oil,
gasoline, etc.
Windshield Wiper Blade Replacement
1. Lift the wiper arm away from the glass.2. Push the release tab shown in the illustration and slide
the wiper blade assembly down along the arm. Gently
place the wiper arm on the windshield.
3. Install the new blade assembly onto the wiper arm tip
until it locks in place.
MAINTAINING YOUR VEHICLE 263
7
Page 329 of 341

Radiator Cap......................... 267
Selection of Coolant.................... 267
Corrosion Protection..................... 276
Crankcase Emission Control System.......... 258
Cruise Light........................... 133
Cup Holder............................ 112
Customer Assistance..................... 316
Dealer Service.......................... 250
Defroster, Rear Window................... 173
Defroster, Windshield................60,168,169
Delay Wipers........................... 99
Diagnostic System, Onboard................ 248
Dimmer Switch, Headlight.................. 97
Disposal
Engine Oil........................... 255
Door Ajar............................. 133
Door Locks............................. 18
Door Locks, Automatic.................... 20Downshifting.......................... 191
Drive Belts............................ 256
Driving
On Slippery Surfaces.................... 238
Electric Rear Window Defrost............... 173
Electric Remote Mirrors.................... 68
Electrical Power Outlets................... 110
Electronic Power Distribution Center.......... 282
Electronic Speed Control................... 101
Emergency, In Case of
Jacking............................. 230
Jump Starting......................... 235
Towing............................. 240
Emergency Trunk Release................... 29
Emission Control System Maintenance......249,294
Engine............................246,247
Break-In Recommendations................ 59
Checking Oil Level..................... 251
INDEX 329
10
Page 341 of 341
Windshield Wipers.....................98,263
Wiper Blade Replacement.................. 263Wiper, Rear............................ 174
Wipers, Intermittent....................... 99
INDEX 341
10