2004 CHRYSLER PACIFICA parking brake

When parking on a hill, it is important to set the parking
brake before placing the gear selector in Park, otherwise
the load on the transmission locking mechanism may
make it difficult to move the selector out of park. As an
added precaution, turn the front wheels toward the curb
on a downhill grade and away from the curb on a uphill
grade.
The parking brake should always be applied when the
driver is not in the vehicle.WARNING!
²Leaving children in a vehicle unattended is dan-
gerous for a number of reasons. A child or others
could be injured. Children should be warned not
to touch the parking brake, brake pedal or the
gear selector lever. Don't leave the keys in the
ignition. A child could operate power windows,
other controls, or move the vehicle.
²Be sure the parking brake is fully disengaged
before driving: failure to do so can lead to brake
failure, and an accident.
STARTING AND OPERATING 207
5

Spare Tire Removal
Fit the jack-handle over the drive nut. Rotate the nut to
the left until the spare is on the ground with enough slack
cable to allow you to pull the tire out from under the
vehicle.
CAUTION!
The winch mechanism is designed for use with the
jack handle only. Use of an air wrench or other
power tools is not recommended and can damage the
winch.
When the spare is clear, tilt the retainer at the end of the
cable and pull it through the center of the wheel.
Preparations For Jacking
Park the vehicle on a firm level surface, avoid ice or
slippery areas,set the parking brakeand place the gear
selector in PARK. Turn OFF the ignition.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.
²Turn on the Hazard Warning Flasher.
²Block both the front and rear
of the wheel diagonally oppo-
site the jacking position. For
example, if changing the right
front tire, block the left rear
wheel.
254 WHAT TO DO IN EMERGENCIES

1. Wear eye protection and remove any metal jewelry
such as watch bands or bracelets that might make an
inadvertent electrical contact.
2. When boost is provided by a battery in another
vehicle, park that vehicle within booster cable reach and
without letting the vehicles touch. Set the parking brake,
place the automatic transmission in PARK and turn the
ignition switch to the OFF position for both vehicles.
3. Turn off the heater, radio and all unnecessary electrical
loads.
4. Connect one end of a jumper cable to the positive
terminal of the discharged battery. Connect the other end
of the same cable to the positive terminal of the booster
battery.5. Connect the other cable, first to the negative terminal
of the booster battery andthen to the engine of the
vehicle with the discharged battery.Make sure you have
a good contact on the engine.
6. Start the engine in the vehicle which has the booster
battery, let the engine idle a few minutes, then start the
engine in the vehicle with the discharged battery.
7. When removing the jumper cables, reverse the above
sequence exactly. Be careful of the moving belts and fan.
DRIVING ON SLIPPERY SURFACES
Acceleration
Rapid acceleration on snow covered, wet, or other slip-
pery surfaces may cause the front wheels to pull errati-
cally to the right or left. This phenomenon occurs when
there is a difference in the surface traction under the front
(driving) wheels.
WHAT TO DO IN EMERGENCIES 259
6

CAUTION!
Using a transmission fluid other than the manufac-
turers recommended fluid may cause deterioration
in transmission shift quality and/or torque converter
shudder. Using a transmission fluid other than the
manufacturers recommended fluid will result in
more frequent fluid and filter changes. Refer to
Recommended Fluids, Lubricants and Genuine Parts
for correct fluid type.
Procedure For Checking Fluid Level
The fluid level in the automatic transmission should be
checked whenever the vehicle is serviced. Operation with
an improper fluid level will greatly reduce the life of the
transmission and of the fluid.
To properly check the automatic transmission fluid level,
the following procedure must be used:
1. The vehicle must be on level ground.
2. The engine should be running at curb idle speed for a
minimum of 60 seconds.
3. Fully apply parking brake.
4. Place the gear selector momentarily in each gear
position ending with the lever in P (PARK). Wipe the area
around the dipstick clean to eliminate the possibility of
dirt entering the transmission.
296 MAINTAINING YOUR VEHICLE

Special Additives...................... 298
Autostick........................ 112,203,204
Ball Joints............................. 283
Battery............................... 279
Jump Starting......................... 258
Keyless Transmitter Replacement............ 23
Bearings.............................. 300
Belts, Drive............................ 276
Body Mechanism Lubrication............... 284
B-Pillar Location........................ 218
Brake, Parking.......................... 206
Brake System........................208,292
Anti-Lock........................... 208
Fluid Check.......................293,313
Hoses.............................. 292
Warning Light........................ 140
Brake/Transmission Interlock............... 201
Break-In Recommendations, New Vehicle........ 61Bulb Replacement....................... 307
Bulbs, Light............................ 306
Calibration, Compass..................... 152
Capacities, Fluid........................ 311
Caps, Filler
Fuel................................ 240
Radiator............................ 289
Car Washes............................ 301
Carbon Monoxide Warning................. 239
Cargo Area Cover....................... 127
Cargo Compartment
Luggage Carrier....................... 130
Cargo Tie-Downs........................ 128
Cassette Tape and Player Maintenance......... 180
Cassette Tape Player...................160,164
Catalytic Converter...................... 278
CD Changer......................159,168,170
CD Player..................155,157,160,166,170
INDEX 347
10

Occupant Restraints....................... 31
Octane Rating, Gasoline................... 235
Odometer............................. 142
Oil, Engine.........................272,312
Capacity............................ 311
Change Interval....................... 274
Checking............................ 272
Disposal............................ 276
Filter............................276,312
Filter Disposal........................ 276
Identification Logo..................... 275
Materials Added to..................... 276
Recommendation...................... 274
Synthetic............................ 276
Viscosity............................ 275
Onboard Diagnostic System..............269,270
Opener, Garage Door..................... 115
Operator Manuals......................... 4
Overdrive............................. 203Overhead Console....................... 114
Overhead Travel Information Center.......... 114
Overheating, Engine...................138,251
Owner's Manual.......................4,340
Panic Alarm............................ 21
Parking Brake.......................... 206
Parking On Hill......................... 207
Passing Light........................... 107
Pedals, Adjustable........................ 99
Pets.................................. 61
Phone, Cellular.......................... 73
Phone, Hands-Free....................... 73
Placard, Tire and Loading Information......... 218
Power
Brakes.............................. 208
Distribution Center..................... 305
Door Locks........................... 17
Lift Gate............................. 27
INDEX 355
10