Massaging Lumbar
If your vehicle has this
feature, the control is
located on the outboard
sides of the front
seats. With the ignition on,
brie y press the top of
the control where it
is marked AUTO to
activate the massaging
lumbar feature.
The massage cycle will run continuously for up to
10 minutes and can be interrupted by brie y pressing
the bottom of the control. The lumbar support can
be adjusted during the massage cycle by moving the
control forward to increase support and rearward
to decrease support. The massage cycle will continue to
run even if the ignition is turned to OFF unless
interrupted.
If your vehicle has this feature, it will not have the
adaptive seat feature.
Heated and Cooled Seats
Your vehicle may have heated and cooled front seats.
The buttons are located on
the front seat armrests.
I(Heated Seatback):Press this button to turn on the
heated seatback.
J(Heated Seat and Seatback):Press this button to
turn on the heated seat and seatback.
H(Cooled Seat):Press this button to turn on the
cooled seat.
Press the button to turn on the feature that you want.
A light on the button will display to show which feature
is on.
1-3
Press the button to turn on the feature that you want. A
light on the button will display to show which feature
is on.
There are three temperature ranges for each feature. A
light bar on the controls will display which setting the
feature is in; high, medium or low. The longest bar
shows the high range and the shortest bar shows the
low range.
When you press a button, the feature will turn on at the
highest setting. Each time you press the button, the
feature will go down one temperature setting.
To turn the feature off, keep pressing the button until
the display lights turn off.Power Lumbar
Your vehicle may be equipped with four-way lumbar
support, without the massage feature, for the outboard
rear seating positions.
The rear lumbar support
controls are located on the
rear door trim panels.
To activate the rear lumbar support feature, push forward
on the control to increase support or rearward to
decrease support. The lumbar control can also be moved
up and down to adjust the location of the support.
1-6
