2004 BMW MOTORRAD R 850 R warning light

2
23
2
Safety check
MAXMIN1
2
 Check oil level at sight glass: MAX Upper edge
Ring marking
MIN Lower edge
Ring marking
– The difference between the two marks is approx. 0.5 litres
 If necessary, unscrew the oil filler screw 2 and top up the
engine oil through the engine
oil filler 1
 Then retighten the oil filler
screw 2
e Attention:
Warning light, engine oil pres-
sure red
p (b 7) indicates no
(or very little) oil pressure in
the lube-oil system; this light
m u s t n o t b e r e g a r d e d a s a n o i l
level check. Oil pressure
builds up after 1-2 seconds
and the warning light goes out
– the redengine oil pressure
warning light
p should remain
off while the engine is running.
Engine oil
BMW recommends Castrol
10r2802g3.fm Seite 23 Donnerstag, 3. Juni 2004 11:29 11

2
25
2
Safety check
Refuel
– Refuel only with super (premium) grade fuel to
DIN 51607 standard or equiv-
alent, minimum octane
number 95 (RON) or
85 (MON)
 Close the fuel filler cap
Capacity
L Note:
The fuel gauge does not oper-
ate unless the ignition is
switched on.
– Usable tank capacity 20.4 litres
– When the reserve fuel
quantity is reached
(approx. 5 litres), the orange
warning light 1 comes on
Fuel
1
10r2802g3.fm Seite 25 Donnerstag, 3. Juni 2004 11:29 11

22
38
Safety checkChecking lights
e Attention:
Check that all lights are opera-
tional at the start of each jour-
ney.
L Note:
If turn indicator repeater flashes
at twice the usual speed: defec-
tive flasher bulb.
BMW Integral ABS
OE:
General warning light ON (
b 7):
Check brake light or tail light.
If the tail light is defective the
brake light is dimmed and acts
as a tail light. When you apply the
brakes the brake light shines at
full brightness. To change bulbs in parking
lights, headlight (dipped and
main beams), rear/brake lights,
turn indicators and the number-
plate light: (
b
Maintenance
Instructions, Chapter 2)
Masking off headlightIf the motorcycle is ridden in a
country where the opposite rule
of the road applies, its asym-
metric dipped beam will tend to
dazzle oncoming traffic.
To prevent this, mask over part
of the headlight glass (apply a
piece of adhesive tape cut to
the correct size and shape).
OEOptional extra
Lights
10r2802g3.fm Seite 38 Donnerstag, 3. Juni 2004 11:29 11

3
57
3
Starting – Riding – Parking
Running in
Running in new brake
pads
d Warning:
New brake pads must “bed
down” and therefore do not
achieve their optimum friction
levels during the first 500 km.
This slight initial reduction in
braking efficiency can be
compensated for by exerting
greater pressure on the lever.
Try to avoid all unnecessary
hard braking during this initial
period.
e Attention:
Comply with the notes on BMW
Integral ABSOE (b 68-75).
Running in new tyres
d Warning:
New tyres have a smooth sur-
face. This must be roughened
by riding in a restrained man-
ner at various heel angles
until the tyres are run in.
This running in procedure is
essential if the tyres are to
achieve maximum grip.

Optional extra
10r28bkg3.book Seite 57 Dienstag, 25. Mai 2004 5:26 17

33
62
Starting – Riding – Parking
1234*
5
Fuel levelWhen the warning light1
comes on, there are still
approx. 5 litres of fuel in the
tank.
Engine oil pressureWarning light 2 goes out above
idle speed.
* depending on national-market speci-
fication
e Attention:
If warning light 2 comes on dur-
ing the journey, take the follow-
ing action as soon as traffic
conditions permit:
Declutch
 Operate the kill switch
 Bring the motorcycle safely to a halt
 Check engine oil level (
b 22)
If the warning light comes on
even though the oil level is cor-
rect, you must consult a spe-
cialist workshop, preferably an
authorised
BMW motorcycle dealer.
Telltale and warning lights
10r28bkg3.book Seite 62 Dienstag, 25. Mai 2004 5:26 17

3
63
3
Starting – Riding – Parking
1234*
5
Warning light, general General warning light 3 lights
up if the BMW Integral ABSOE
develops a fault (
b 75), or if the
tail light or brake light is defec-
tive.
ABS warning lightOE
The ABS warning light 4 lights
up if the BMW Integral ABS
develops a fault (
b 75)
* depending on national-market speci-
fication
Battery charge currentWarning light 5 goes out above
idle speed.
e Attention:
If warning light 5 comes on dur-
ing the journey:
Consult a specialist, preferably
an authorised BMW motorcycle
dealer.

Optional extra
Telltale and warning lights
10r28bkg3.book Seite 63 Dienstag, 25. Mai 2004 5:26 17

33
72
Starting – Riding – Parking
12*
Self-diagnosis with
pull-away test
The BMW Integral ABS per-
forms self-diagnosis and a pull-
away test to ensure its operabil-
ity.
Self-diagnosis is performed
automatically when you switch
on the ignition.
d Warning:
Self-diagnosis is not per-
formed unless both brake le-
vers are in their fully released
positions.
Only the RESIDUAL BRAKING
FUNCTION is available until
self-diagnosis is completed
(b 71).  Release the brake levers, if
necessary
 Switch on the ignition
Initially:
– ABS warning light 2:
flashes at 4 Hz (
b 58)
– General warning light 1:
ON
bSelf-diagnosis is in
progress
Then:
– ABS warning light 2:
flashes at 1 Hz
– General warning light 1:
OFF
bSelf-diagnosis successfully
completed

Optional extra
* depending on national-market speci- fication
Brake system - with BMW Integral ABSOE
10r28bkg3.book Seite 72 Dienstag, 25. Mai 2004 5:26 17

3
73
3
Starting – Riding – Parking
12*
Start the engine.
 Move off
– ABS warning light2:
OFF (as of approx. 5 km/h
road speed)
bPull-away test successfully
completed
bBMW Integral ABS
is available
L Note:
Starting on gradients:
Always switch on the ignition
with gear engaged, clutch lever
released and both brake levers
released.
Self-diagnosis cannot be per-
formed if you do not follow this
procedure.
When self-diagnosis com-
pletes, apply the brakes, disen-
gage the clutch, and start the
engine.
L Note:
Flashing at 1 Hz = 1 flash per
second (slow flashing)
Flashing at 4 Hz = 4 flashes per
second (fast flashing)

Optional extra
* depending on national-market speci- fication
Brake system - with BMW Integral ABSOE
10r28bkg3.book Seite 73 Dienstag, 25. Mai 2004 5:26 17