2004 BMW MOTORRAD K 1200 RS clock

38
Maintenance and care
2
Tail light/brake light
e Important:
Switch off the ignition before
changing a bulb.
L Note:
Do not touch the glass of new
bulbs with the fingers. Use a
clean, dry cloth to hold the
bulbs when inserting them.
 Place the motorcycle on its
main stand on a firm, flat
surface
 Remove the rear seat  Remove 2 retaining screws 1
 Pull rear light
2 to the rear to
remove
Turn bulb socket 4 counter-
clockwise to disengage and
remove it from the rear light
 Press the bulb 3 into its
socket and turn it counter-
clockwise to release it
 Remove the bulb
 Installation is the reverse of the removal procedure
– Brake/rear light bulb 3:
12 V 21/5 W
3
4
Changing bulbs
22
1
20k41bkg3.book Seite 38 Mittwoch, 26. Mai 2004 3:33 15

41
Maintenance and care
2
 Turn bulb socket5 counter-
clockwise to disengage and
remove it from the turn-indi-
cator housing
 Press bulb 4 into its socket
and turn it counter-clockwise
to release
 Remove the bulb
– Front turn-indicator bulbs 4:
12 V 21 W  Installation is the reverse of
the removal procedure
L Note:
When installing the turn-indica-
tor housing, begin by engaging
spring link 3 in the front fairing.
Changing bulbs
54
20k41bkg3.book Seite 41 Mittwoch, 26. Mai 2004 3:33 15

42
Maintenance and care
2
Rear turn indicators
e Important:
Switch off the ignition before
changing a bulb.
L Note:
Do not touch the glass of new
bulbs with the fingers. Use a
clean, dry cloth to hold the
bulbs when inserting them.  Place the motorcycle on its
main stand
 Remove retaining screw 1
 Remove the flashing turn indi- cator glass 3
 Press bulb 2 into its socket
and turn it counter-clockwise
to release.
Remove the bulb
 Installation is the reverse of
the removal procedure
– Rear turn indicator bulbs 2:
12 V 21 W
Changing bulbs
231
20k41bkg3.book Seite 42 Mittwoch, 26. Mai 2004 3:33 15

51
Maintenance and care
2
Battery maintenance instructions
Motorcycle out of use for a
lengthy period
 The battery has to be charged prior to lay-up periods of
more than one month.
e Attention:
If the battery is not
disconnected, the on-board
electronics (clock, etc.) will
discharge the battery. This can
cause the battery to run flat. If
this happens, warranty claims
will not be accepted.
Disconnect the ground (earth)
lead from the battery prior to a
lay-up. – Batteries that are not in use
must be stored in a cool
place. Do not store a
discharged battery
– If the battery is in storage for an extended period of time,
recharge it at regular intervals
of approx. 4 months. If the
battery is not disconnected
from the motorcycle's
systems, recharge it every 2
months at the latest
– Always fully recharge the bat-
tery before restoring it to use
In case of doubt ask a specialist,
preferably an authorised BMW
motorcycle dealer, to prepare
the vehicle for laying up and to
carry out the necessary battery
maintenance and storage
20k41bkg3.book Seite 51 Mittwoch, 26. Mai 2004 3:33 15