2004 AUDI A6 pin

Overview13
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Tips
You can find information about the different drives starting on page 34.Anti-theft codingGeneral
Effective safety measures in conjunction with the PIN
prevent misuse of the equipment by unauthorized
parties.The electronic lock-up is operational, if:

the Navigation System is removed from the vehicle,


the Navigation System is disconnected from the vehicle current
supply,


the battery is disconnected or


the electric fuse for the Navigation System is blown.
I f t h e a n t i - t h e ft c o d i n g h as l o cke d up t h e N a v i g a t i o n S ys t e m fo r o n e
of the reasons given, the speller display for entering the PIN
page 14, fig.6 appears after the Navigation System is switched
on.
After that, the Navigation System can only be operated again only
by entering the correct PIN.
This PIN is attached to the equipment card along with the equip-
ment number.
The PIN can be used for your equipment alone and cannot be
changed.
Note
The “equipment card” should be removed and kept in a safe place -
under no circumstances should it be kept in the vehicle. This makes
the Audi Navigation System unusable by thieves.Applies to vehicles: with convenience codingUser-friendly radio codingAft e r t he P I N i s e n t e re d t h e fir s t t im e , t h e N a v i g a t i o n S ys t e m g e t s to
know its vehicle.
If the power supply was interrupted, the Navigation System checks
to see whether it is still its vehicle. If it is, the Navigation System is
ready for use again after a few seconds.
It is no longer necessary to manually disable the electronic lock!
However, if the Navigation System is installed in another vehicle,
the electronic lock must be cancelled by entering the PIN page 14.

Overview 14Entering PINFig. 6 Speller display: Entering PIN– Switch the ignition on.
– Switch the Navigation System on if it is not switched on
automatically
page 11.
– Enter the PIN using the speller
fig.6.
– Confirm your entry with OK. The electronic lock is
cancelled.Yo u h a v e two attempts to enter the correct PIN. The number of
attempts is shown in the display. If you enter the incorrect PIN twice
in succession, the message System is locked appears in the display.Unlocking the system (unlocking procedure)
Before you can enter the PIN again, the electronic lock must be
cancelled. This happens automatically w h e n t h e N a v i g a t i o n S y s t e m
has been switched on for about 60 minutes. If you do not insert the
ignition key into the lock, the Navigation System switches off auto-
matically after 30 minutes. When the Navigation System switches
off automatically or is switched off, the unlocking process is
cancelled and has to be started over.
When the unlocking process is complete, you have two more
attempts to enter the correct PIN. If you enter the incorrect PIN
again twice in succession, the procedure must be repeated.
Tips
If you lose your PIN, contact an Audi dealership or authorized
facility.

Display 32Making entries with the spellerFig. 27 Display: Entering letters in the speller
Fig. 28 Display: Entering numbers in the speller
Entering digits, letters and characters
– Select the desired letters, numbers or characters in the
speller display using the selector arrow by rotating
the control knob.
– To confirm the entry, press the control knob after each
selection of a letter, number or character.
– Select OK to close out the entry.
Deleting numbers, letters and characters
– With the selection arrow, select DEL by rotating the
control knob.
– Press the control knob, and the last entry in the entry
field will be deleted.In some cases, such as in navigation, the selection of letters is
limited by logical exclusion.
For e xample, if you have entered part of a city in the speller display
and you already recognize the desired city in the speller display list,
you can shift directly to the city list by keeping pressure on the
control knob.
A1
A
A

Drives47
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Loading the magazine with CDs– Hold the CD with the printed side facing up and grasping
it by the hole and outer edge
page 51, fig.52.
– Hold the magazine with “disc” facing upwards
fig.47.– Insert the CDs one at a time (printed side facing up) into
the magazine until they “click” into place
fig.48.
Always insert the CDs straight in the CD slot with the printed side
facing up.
M a ke s u re y o u p a y a t t e n t i o n to t h e C D s e que n c e o n t h e r i g h t s id e o f
the magazine.
I f y o u h a v e n o t f i l l e d C D s l o t s i n t h e m a g a z i n e , Empty appears in the
display when you select the Changer control button in the CD func-
tion.
Tips
Always close the sliding cover after inserting the magazine to
protect your CD changer from dirt and dust
page 46, fig.46. This
helps to prevent malfunctions.
Fig. 47 Side of maga-
zine marked "disc" Fig. 48 Inserting the
CD in the magazine
A;

Navigation (NAV)109
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
Tips


The Navigation System is designed to provide you with
suggested routes in locating addresses, destinations and other
points of interest.


Changes in street names, construction zones, traffic flow, points
of interest or other road system changes are beyond the control of
Audi of America, Inc.


Complete, detailed mapping of lanes, roads, streets, toll roads,
highways, etc., is not possible, therefore you may encounter
discrepancies between the mapping and your actual location.
IntroductionGeneralFig. 112 Display: Example of navigation mapThe Audi Navigation System can help you to reach your destination
without spending a lot of time studying maps.
During the trip you will receive information on vehicle location,
in structions for turning (directio n and dis tance to turn-off), p resen t
distance to destination and estimated time of arrival at destination
in the Navigation System display
fig.112 and in the instrument
cluster display
page 111, fig.114. In addition you will receive
navigation prompts in the form of a spoken announcement
page 112.
There are two possibilities for guide destination:

Route without stopover (Single destination mode)

Navigation (NAV) 120
– Select Select city center to navigate to the center of the
selected locality, or
– Select Input street name, Special destination in city or
Destination input on map to set more detailed destina-
tion criteria.
– Select Start route guidance
page 129.After you have started route guidance, you are offered up to three
routes
page 130, f i g .1 3 6 . S e l e c t o n e o f t h e r o u t e s b y r o t a t i n g a n d
pressing the control knob. If you do not select any of the routes
s u g g e s t e d , t h e r o u t e m a r k e d i s a u t o m a t i c a l l y i m p o r t e d a f t e r a d e l a y
once the trip has started or during the trip. The delay gives you the
opportunity to change the route selection one more time. You can
find additional information on route selection starting on
page 130.
Switch from the letter speller to the number speller to enter a city
with special characters (e.g. hyphen, apostrophe or period) page 125.
Selection “Select city center”
The Navigation System calculates route guidance to the center of
the city entered.
Selection “Input street name”
B y i n p u t t i n g t h e s t r e e t i n a c i t y, y o u c a n s p e c i f y t h e d e s t i n a t i o n m o r e
precisely.
After selecting the street, you can specify more detailed destination
criteria by inputting an Intersection, a House number or through
Enter destination on map
page 128.
If you would like to find a street independently of the city, select
Street after selecting the country in the destination entry menu.Selection “Special destination in city”
By selecting a special destination in the specified city, tourist attrac-
tions or public facilities (e.g. hospital, movie theater,) can be
selected directly as a destination.
If you would like to find a particular special destination indepen-
dently of the city, select Special destination after selecting the
country in the destination entry menu
page 126.
Selection “Destination input on map”
You can find destinations for a specified city from the map display.
If the map is being displayed to select a destination, the crosshairs
are in the center of the city in question. By moving the crosshairs
horizontally and vertically, you can set a new destination
page 149.
If additional detailed information is available for the selected point
on the map, you can display it using the Detail info function.
I f y o u a r e n a v i g a t i n g i n s i n g l e d e s t i n a t i o n m o d e , t h e Set as stopover
function is greyed out
page 139.
Yo u c a n a l s o Save to directory
page 135 the selected map destina-
tion
By inputting a street, you can predetermine the map location in
greater detail.
Tips


If you have entered a city in the speller display, you can confirm
the entry for this city by pressing and holding the control knob. Or,
y o u e n t e r p a r t o f a c it y a n d yo u a l re a d y r e c o g n i z e t h e d e s i re d c i t y i n
the speller display list, you can shift directly to the city list by
keeping pressure on the control knob.


Entered destinations can be saved
page 135.

Navigation (NAV) 122Selection “Special destination in city”
By selecting a special destination in the specified city, tourist attrac-
tions or public facilities (e.g. hospital, movie theater,) can be
selected directly as a destination.
If you would like to find a particular special destination indepen-
dently of the city, select Special destination after selecting the
country in the destination input menu
page 126.
Selection “Destination input on map”
You can find destinations for a specified city from the map display.
If the map is being displayed to select a destination, the crosshairs
are in the center of the city in question. By moving the crosshairs
horizontally and vertically, you can set a new destination
page 149.
If additional detailed information is available for the selected point
on the map, you can display it using the Detail info function.
Using the Set as stopover fu n c t io n , y o u c a n a l s o s e t t h e d e s t in a t io n
from the map as a stopover
page 139.
Yo u c a n a l s o Save to directory the selected map destination
By inputting a street, you can predetermine the map location in
greater detail.
Tips


If you have entered a city in the speller display, you can confirm
the entry for this city by pressing and holding the control knob. Or,
yo u e n t e r p a r t o f a c i t y a n d y o u a l re a d y re co g n i ze t h e d e s ir e d c i t y in
the speller display list, you can shift directly to the city list by
keeping pressure on the control knob.


Route plans that have been entered can be saved
page 137.

Navigation (NAV)125
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP Selection “Input street name”
By inputting the street in a city, the destination can be specified
more precisely.
After selecting the street, you can specify more detailed destination
criteria by inputting an Intersection, a House number or through
Enter destination on map
page 128.
If you would like to find a street independently of the city, select
Street after selecting the country in the main navigation menu.
Selection “Special destination in city”
By selecting a special destination in the specified city, tourist attrac-
tions or public facilities (e.g. hospital, movie theater,) can be
selected directly as a destination.
If you would like to find a particular special destination indepen-
dently of the city, select Special destination after selecting the
country in the main navigation menu
page 126.
Selection “Destination input on map”
You can find destinations for a specified city from the map display.
If the map is being displayed to select a destination, the crosshairs
are in the center of the city in question. By moving the crosshairs
horizontally and vertically, you can set a new destination
page 149.
If additional detailed information is available for the selected point
on the map, you can display it using the Detail info function.
You can select the Set as destination function, if you have set the
route guidance with stopovers. If you are navigating without stop-
over, the Set as stopover function is greyed out
page 139.
Yo u c a n a l s o Save to directory
page 135 t h e s e l e c t e d m a p d e s t i n a -
tion By inputting a street, you can predetermine the map location in
greater detail.
Tips
If you have entered a city in the s peller display, you can confirm the
entry for this city by pressing and holding the control knob. Or, you
enter par t o f a city and you a lre ady recognize the d esired city in the
speller display list, you can shift directly to the city list by keeping
pressure on the control knob.Entering street/city with special charactersFig. 130 Navigation: Switch from letter to number speller– In a destination input menu
page 117, fig.121, select
another Region from the list by rotating and pressing the
control knob.