2004 Alfa Romeo 156 tutela

CAR MAINTENANCE
260
Do not add oil with dif-
ferent characteristics than
those of the oil already in
the system.
The oil level should never exceed the
MAXmark on the dipstick on the COLD
side, if the level is checked cold and on the
HOTside if the level is checked with the
gearbox/differential unit hot.
fig. 14
A0B0163m
The level should be between the MINand
MAXmarks of the sector identified by the
word COLD(+40°C).
WARNINGAfter long journeys with the
gearbox/differential unit very hot, the oil
level should be between the MINand
MAXmarks of the sector identified by the
word HOT(+80°C).
Q-SYSTEM AUTOMATIC
GEARBOX OIL LEVEL
(fig. 14)
The oil should be checked with the engine
idling and at operating temperature, the
gearshift lever at position Pand the car on
level ground.
To check the level, proceed as follows:
– remove the dipstick (A);
– clean it with a clean lint free cloth;
– insert the dipstick in its housing pushing
well down to the bottom;
– remove it to check.
If the oil level is near or below the MIN
mark, add TUTELA GI/2oil through the
dipstick housing.
When the engine is very
hot, take care when work-
ing inside the engine compartment
to avoid burns. Remember that
when the engine is hot, the fan may
cut in: danger of injury.
WARNING
Used gearbox oil contain
pollutants. Contact Alfa
Romeo Authorized Services to
have the oil changed as these are
equipped to dispose of the waste
oil respecting the environment and
laws.
WARNING

CAR MAINTENANCE
264
WINDSCREEN/HEADLIGHT
WASHER FLUID Fig. 21: T.SPARK, 2.0 JTS and diesel ver-
sions
Fig. 22: 2.5 V6 24V version.
Check the level in the reservoir removing
the cap (A).fig. 21
A0A0156m
fig. 22
A0A0155m
To avoid damaging the
pump motors, do not use
the windscreen washers
when the reservoir is empty.
If necessary top up using a mixture of wa-
ter and TUTELA PROFESSIONAL SC 35
as follows:
– 30% of TUTELA PROFESSIONAL
SC 35and 70% water in summer;
– 50% of TUTELA PROFESSIONAL
SC 35and 50% water in winter;
– in the case of temperatures below
–20°C use TUTELA PROFESSIONAL
SC 35fluid neat.
Do not travel with the
windscreen washer reser-
voir empty: the action of the wind-
screen washer is fundamental for
improving vision.
WARNING
Some commercial additives
for windscreen washers
are inflammable. The engine com-
partment contains hot components
which could set it on fire.
WARNING

CAR MAINTENANCE
273
Proceed as follows:
– Raise the windscreen wiper arm and po-
sition the blade so that it forms an angle
of 90° with the arm.
– Press tab (B) of the coupling spring and
remove the blade to be replaced from the
arm (A).
– When the spring is released from the
curved top of the arm, move the blade to al-
low the arm to be withdrawn through the slot.
– Insert a new blade passing it through the
curved top of the arm (A) through the slot.
– Lift the blade to clamp tab (B) of the cou-
pling spring with the curved top of the arm.
– Lower the windscreen wiper arm.
WARNINGThe blades may differ ac-
cording to the versions. In any case, follow
the instructions provided in the packs avail-
able as spares from Alfa Romeo Authorized
Services. Changing the windscreen wiper
blade (fig. 27)
WARNINGThe blade on driver’s side
is fitted with a spoiler that improves adhe-
sion between the blade and the windscreen.
To prevent improper fitting, before changing
the blade, check the spoiler direction of the
blade to be replaced, then fit the new blade
following the same spoiler direction.
fig. 27
A0B0580m
WINDSCREEN/REAR
SCREEN WIPERSBLADESPeriodically clean the rubber part using spe-
cial products TUTELA PROFESSIONAL
SC 35is recommended.
If the rubber blades are bent or worn they
should be replaced. In any case they should
be changed once a year.
A few simple notions can reduce the pos-
sibility of damage to the blades:
– If the temperature falls below zero,
make sure that ice has not frozen the rub-
ber against the glass. If necessary, thaw us-
ing an antifreeze product.
– Remove any snow from the glass: in ad-
dition to protecting the blades, this prevents
effort on the motor and overheating.
– Do not operate the windscreen and rear
window wipers on dry glass.
Driving with worn wiper
blades is a serious hazard,
because visibility is reduced in bad
weather.
WARNING

TECHNICAL SPECIFICATIONS
319
2.0 JTS
63
●9 ●6.9
4.4 ◆2
–
–
–
2,5
5.32.0 JTS
Selespeed63 ●9 ●6.9
4.4 ◆2
–
0.6
–
2,5
5.3 1.8
T.SPARK
63
●9 ●6.9
4.4 ■2
–
–
–
2,5
5.3 1.6
T.SPARK
63
●9 ●6.9
4.4 ■2
–
–
–
2,5
5.32.5 V6
24V
63
●9 ●9.2
5.9 ■–
2
–
–
2,5
5.3JTD
63
❍9 ❍6.1
4.5 ❑2
–
–
–
2,5
5.3 2.5 V6
24V
Q-System63 ●9 ●9.2
5.9 ■–
–
–
3.8
2,5
5.3
REFILLING
JTD 20V
Multijet
63
❍9 ❍7.25
5 ❑
3.1
–
–
–
2,5
5.3
JTD 16V
Multijet
63
❍9 ❍6.1
4.5 ❑
2
–
–
–
2,5
5.3
Fuel tank: litres
– including a reserve of litresEngine cooling system litres
Oil sump and filter litresMechanical gearbox/differential litres
Mechanical gearbox/differential litres
Selespeed gearbox litresactuation hydraulic system
Q-System litresautomatic gearbox
Windscreen washer and
rearscreen washer fluid
reservoir: litres– with headlamp washer litresSpecified fuels
Recommended products
●Unleaded petrol at not
less than 95 R.O.N
(specification EN228)❍Diesel fuel for motor
vehicles (Specification EN590)Mixture of distilled water and
PARAFLU 11(blue) at 50% or
PARAFLU UP(red) at 50%■ SELENIA 20K for Alfa
Romeo◆SELENIA RACING❑ SELENIA WR
TUTELA CAR
ZC 75 Synth
TUTELA CAR MATRYX
TUTELA CAR CS SPEED
TUTELA GI/2
Mixture of water and liquid
TUTELA PROFESSIONAL
SC 35
■
For decidedly sportive use of the car, fully synthetic SELENIA RACING
SAE
10W-60 engine oil is recommended.
For use in particularly harsh weather conditions SELENIA PERFORMER MULTIPOWER
SAE
5W-30 engine oil is recommended.

TECHNICAL SPECIFICATIONS
321
UseLubricants and greases
for transmissionsBrake fluidProtective agent for radiatorsAdditive for fuel oil
Windscreen/
rearscreen/headlampwasher fluid
(*) IMPORTANTDo not add or mix with fluids with specifications other than the specified ones.Quality features of fluids and lubricants
for correct vehicle operation
Synthetic-based engine oil, SAE 75W-80 EP grade that passes API GL5
and MIL-L-2105 D Lev specifications
SAE 75W-85 completly synthetic engine oil.
Meets API GL 4 and ZF TE ML06 (B&C) LEVEL, ALLISON C4 specifications
“ATF DEXRON II D LEV”, type oil
“ATF DEXRON III” type specific oil
“ATF DEXRON II D LEV”, SAE 10W type oil
Lithium-soap-based grease with molybdenum bisulphate.
Consistency NLGI 2
FMVSS n° 116 DOT 4, ISO 4925, SAE J1704,
CUNA NC 956-01 synthetic fluid
Protective with antifreeze action, blue color, based on inhibited monoethylene
glycol, CUNA NC 956-16
Protective with antifreeze action, red colour, based on inhibited monoethylen
glycol, with O.A.T.-based organic formula, that passes CUNA NC 956-16,
ASTM D 3306 specifications
Additive for fuel oil with protective action for Diesel engines
Mixture of spirits and surface-active agents CUNA NC 956-11Recommended fluids
and lubricants
TUTELA CAR
ZC 75 Synth
TUTELA CAR
MATRYX
TUTELA GI/2
TUTELA CAR
CS SPEED
TUTELA GI/A
TUTELA MRM 2
TUTELA CAR TOP 4
for Alfa Romeo
PARAFLU 11 (*)
or
PARAFLU UP (*)
DIESEL MIX
TUTELA
PROFESSIONAL
SC 35
Applications
Mechanical gearbox and
differential
Mechanical gearbox and
differential for high
temperatures
Automatic gearbox
Selespeed transmission
electrically-operated
electrohydraulic drive
Hydraulic power steering
C.V. joints
Hydraulic brake and
clutch control
Cooling ducts
Percentage:
50% down to –35°C
To be mixed with the fuel
oil (25 cc per 10 litres)
To be used neat
or diluted