2004 Alfa Romeo 156 key

GETTING TO KNOW YOUR CAR
100
Warning light Message
on displaym
GLOW PLUGS (JTD engines)When the ignition key is turned to MAR, the dial warning light comes on and go out when the
glow plugs have reached the pre-established temperature.
Start the engine as soon as the warning light has gone out.
WARNINGWith a high environment temperature, the warning light may turn on for an imper-
ceptible length of time. For versions/markets where applicable, the warning light flashes for approx.
30 seconds after starting the engine, which means that there is a fault in the glow plug warming
system, contact Alfa Romeo Authorized Services.
c
WATER IN THE FUEL OIL FILTER (JTD engines)The warning light switches on with fixed light when driving, to indicate the presence of water in
the fuel oil filter.
The presence of water in the fuel circuit may cause serious damage to
the entire injection system and cause irregular engine operation. If warn-
ing light
c
comes on the dial, contact Alfa Romeo Authorized Services
as soon as possible to have the system relieved. Should the above warning in-
dication come one immediately after topping up, water has probably been poured
into the tank: turn the engine off immediately and contact Alfa Romeo Autho-
rized Services.

GETTING TO KNOW YOUR CAR
102
Warning light Message
on display>
INEFFICIENT ABS SYSTEMWhen the ignition key is turned to MAR, the warning light comes on but must go out after a
few seconds.
This warning light comes on (together with the message + symbol, where required, on the display)
when the system is inefficient. In this case, normal braking is ensured, though without making use
of the ABS system. Caution is recommended, especially in cases of less than perfect grip. In any
case, contact Alfa Romeo Authorized Services as soon as possible.Inefficient EBD electronic braking distributor
x>+
The vehicle is equipped with an electronic braking distributor (EBD). Si-
multaneous lighting of dial warning lights
>
and
x
(together with the
message + symbol on the display) with the engine running indicates an EBD
system failure; in this case, any sudden braking action can cause early locking
of rear wheels, with possible sideslip. Drive very carefully and go immediately
to the nearest Alfa Romeo Authorized Service to have the system checked.
WARNING

GETTING TO KNOW YOUR CAR
103
Warning light Message
on displayá
VDC SYSTEM (VEHICLE DYNAMICS CONTROL)
(optional for versions/markets where applicable)When the ignition key is turned to MAR, the dial warning light comes on but must go out after
a few seconds.
If the warning light does not go out, or if it stays on (together with the message + symbol on the
display and the coming on of the ASR button led) when the vehicle is running, contact Alfa Romeo
Authorized Services.
The flashing of the warning lamp when the vehicle is running indicates the actuation of the VDC
system.
W
OUTSIDE LIGHT FAILUREThe warning light comes on when an anomaly is found in one of the following lights:
– sidelights
– braking lights or corresponding fuse
– rear fog guards
– number plate lights.
The warning of a fault may mean one or more blown bulbs, a burnt fuse or cut off connection.

GETTING TO KNOW YOUR CAR
104
Warning light Message
on display
SPEED LIMIT EXCEEDED The message + symbol turns on, together with the sound of the buzzer, on the display when the
vehicle exceeds the speed limit set previously (see “Speed limit” in this section).
ç
FUEL RESERVEThe warning light comes on when about 7 litres of fuel are left in the tank, and when the car
range is below 50 km.REDUCED RANGE This message is displayed when the car range is below 50 km.SCHEDULED MAINTENANCEThis message appears on the display 2,000 kilometres from the deadline given in the Scheduled
Maintenance Programme (every 20,000 km) and it is shown again at timed intervals, turning the
ignition key to MARevery 200 km.

GETTING TO KNOW YOUR CAR
107
Warning light
on the dialMessage
on display
SELESPEED GEARBOX FAILURETurning the ignition key to MAR, the warning light on the cluster shall come on and then go off af-
ter about 4 seconds. If the warning light stays on, it indicates that a fault has been detected in the Se-
lespeed gearbox; at the same time, the buzzer beeps intermittently for 4 seconds to draw the atten-
tion of the driver. Contact Alfa Romeo Authorised Services as soon as possible to remove the fault.Q-SYSTEM AUTOMATIC GEARBOX FAILURETurning the ignition key to MAR, the warning light on the cluster shall come on and then go off
after about 4 seconds. If the warning light stays on or turns on when travelling, it indicates over-
heated gearbox oil (glowing steadily) or a gearbox fault (flashing).
Warning light glowing steadily: it indicates that the gearbox oil has reached the maxi-
mum established temperature.
To make oil cooling down, stop the car, move the lever to Por Nand let the engine idle until the
warning light goes out. Resume driving without demanding high performance from the engine. If
the warning light comes on again, it is necessary to stop again with the engine idling until it goes
out again. If the interval between one lighting up of the warning light and next is below 15 minutes,
you are advised to stop the car, turn the engine off and wait for the engine-gearbox unit to cool down
completely. Contact Alfa Romeo Authorised Services as soon as possible.
Warning light flashing: it indicates a fault in the automatic gearbox.
The automatic control system provides an emergency programme. Under these circumstances,
you are advised to stop the car and turn the engine off; in fact, the next time the engine is started,
the self-diagnostic system could cut off the fault which will however be memorised. Conversely, if
the fault remains (warning light flashing), it is necessary to select the gears manually as if driving
a car with mechanical gearbox, bearing in mind that the only two speeds available are the 2
ndand
4
thgear. Contact Alfa Romeo Authorised Services as soon as possible.
t
t

GETTING TO KNOW YOUR CAR
116
The anti-pollution sensor
is placed in the air flow in
front of the combined par-
ticle activated carbon filter and,
therefore, must be protected
against possible compressed air
jets produced by cleaning equip-
ment. Moreover, the water col-
lected from the windscreen wipers
should not come into contact with
the sensor: otherwise, the internal
air recirculation function could be
disabled for long periods.
WARNINGThe demisting procedure is
enabled every time the ignition key is turned
to MAR, or pressing the
AUTO
button.
When this procedure is working it can be
turned off pressing one of the following but-
tons: compressor, air recirculation, air dis-
tribution, air flow. This operation inhibits the
incipient misting sensor signal until the AUTO
button is pressed again or the next time the
ignition key is turned to MAR.
On certain versions, the system is inte-
grated by an anti-pollution sensor that is able
to switch on the inside air recirculation func-
tion automatically, to reduce the unpleasant
smell of polluted air when driving in urban
areas, queues, tunnels, and when the wind-
screen wash/wiper is operated (with the
typical smell of spirits).WARNINGThe function of the anti-pol-
lution sensor is subordinate to safety con-
ditions; therefore disabling the climate con-
trol compressor or at an outside temperature
below 4°C, the sensor is disabled. In any
case, the sensor can be re-enabled press-
ing the recirculation button
v
until taking
it to the automatic mode. To ensure correct opera-
tion of the incipient misting
sensor, stickers (e.g. road
licence holder) must not be applied
in the “control” area between the
sensor and the windscreen. For this
very reason, both the sensor and
the windscreen must always be
kept clean, to avoid accumulation
of dirt or other substances.

GETTING TO KNOW YOUR CAR
134
This function is timed and switches off au-
tomatically after 20 minutes, or pressing the
button again; the function is also switched
off when the engine is stopped and will not
be switched on again the next time the en-
gine is started.
WARNINGThe system turns on
rearscreen heating automatically if the tem-
perature is below 3°C.
WARNINGDo not apply stickers on the
inside of the rearscreen over the heating fil-
aments to avoid damage that might cause
it to stop working properly.
WARNINGWhen reconnecting the neg-
ative battery cable after having disconnected
it, wait for 2 minutes before turning the key
to enable the climate control system to re-
set actuator strokes properly.
POLLEN FILTER This filter has the specific capability of com-
bining the mechanical filtering of the air with
an electrostatic effect so that the outside air
admitted to the passenger compartment is
purified and free from particles such as dust,
pollen, etc.
In addition to the above, it also effectively
reduces the concentration of pollutants.
The filtering action takes place under all
air inlet conditions and it is clearly most ef-
fective with the windows shut.
Have the conditions of the filter checked by
Alfa Romeo Authorized Services at least once
a year, preferably on the onset of summer.If the vehicle is used mainly in polluted
or dusty areas it should be checked and if
necessary replaced, at shorter intervals.
Failure to replace the fil-
ter may considerably re-
duce the effectiveness of
the climate control system up to
blocking the air flow from the out-
lets and vents.

GETTING TO KNOW YOUR CAR
135
ADDITIONAL HEATER(JTD engines) (for versions/
markets where applicable)
The car is equipped with an additional
heater (not programmable) which supports
the engine during cold or winter weather
to quickly reach a comfortable temperature
inside the passenger compartment.
The heater operates with the engine run-
ning when the outside temperature is below
20°C and the engine has not yet reached
normal operating temperature.
HAZARD WARNING LIGHTS(fig. 116)
They are switched on by pressing button
(A), regardless of the position of the igni-
tion key.
When the hazard warning lights are
switched on, the switch itself begins to flash
together with the direction indicator warn-
ing lights and the emergency indicator on
the instrument panel. This functions is
switched off by pressing the button again.
CONTROLSTAILGATE OPENING
(fig. 115)
To open the boot pull the lever (A) at the
side of the driver’s seat.
fig. 115
A0B0042m
fig. 116
A0B0036m
Do not operate the boot re-
lease lever with the car on
the move.
WARNING
Use of the hazard warning
lights is ruled by the High-
way Code of the country in which
the car is used. Observe regula-
tions.
WARNING