CAR MAINTENANCE
273
Proceed as follows:
– Raise the windscreen wiper arm and po-
sition the blade so that it forms an angle
of 90° with the arm.
– Press tab (B) of the coupling spring and
remove the blade to be replaced from the
arm (A).
– When the spring is released from the
curved top of the arm, move the blade to al-
low the arm to be withdrawn through the slot.
– Insert a new blade passing it through the
curved top of the arm (A) through the slot.
– Lift the blade to clamp tab (B) of the cou-
pling spring with the curved top of the arm.
– Lower the windscreen wiper arm.
WARNINGThe blades may differ ac-
cording to the versions. In any case, follow
the instructions provided in the packs avail-
able as spares from Alfa Romeo Authorized
Services. Changing the windscreen wiper
blade (fig. 27)
WARNINGThe blade on driver’s side
is fitted with a spoiler that improves adhe-
sion between the blade and the windscreen.
To prevent improper fitting, before changing
the blade, check the spoiler direction of the
blade to be replaced, then fit the new blade
following the same spoiler direction.
fig. 27
A0B0580m
WINDSCREEN/REAR
SCREEN WIPERSBLADESPeriodically clean the rubber part using spe-
cial products TUTELA PROFESSIONAL
SC 35is recommended.
If the rubber blades are bent or worn they
should be replaced. In any case they should
be changed once a year.
A few simple notions can reduce the pos-
sibility of damage to the blades:
– If the temperature falls below zero,
make sure that ice has not frozen the rub-
ber against the glass. If necessary, thaw us-
ing an antifreeze product.
– Remove any snow from the glass: in ad-
dition to protecting the blades, this prevents
effort on the motor and overheating.
– Do not operate the windscreen and rear
window wipers on dry glass.
Driving with worn wiper
blades is a serious hazard,
because visibility is reduced in bad
weather.
WARNING
ALFA 156 SPORTWAGON
297
IF AN INTERIOR
LIGHTS GOES OUTWARNINGBefore changing a bulb, read
the warnings and precautions given in the
chapter “In an emergency”.TAILGATE LIGHTTo change the bulb (Type C, 10W):
– Open the tailgate.
– Remove the light (A-fig. 57) levering
with a flat-tipped screwdriver in the point
shown.
fig. 56
A0B0136m
ADDITIONAL STOP LIGHTS
(3
rdSTOP)
The additional stop light is built into the
rear spoiler (fig. 56).
Refer to the Alfa Romeo Authorized Ser-
vices for its replacement. – Remove the bulb (B-fig. 58) pulling
outwards and releasing it from the side con-
tacts.
– Insert the new bulb fitting it correctly be-
tween the contacts.
– Refit the light inserting it and then press-
ing until the catch clicks into place.
fig. 57
A0B0139m
fig. 58
A0B0140m
