2004 Alfa Romeo 156 engine coolant

CORRECT USE OF THE CAR
190
WARNINGOn the 2.0 JTS version,
keep the brake pedal pressed when starting
the engine. As the brake pedal stiffens if it
is pressed repeatedly with the engine off. In
this situation, to allow the engine to be
started, it is necessary to increase the pres-
sure exerted on the pedal itself.PROCEDURE FOR JTD VERSIONS1)Make sure the handbrake is engaged.
2)Move the gearshift lever to neutral.
3)Turn the ignition key to the MARpo-
sition. The warning light
m
on the instru-
ment cluster will turn on.
4)Wait for the
m
warning light to go
off, which will depend on how warm the en-
gine is. With the engine very hot the warn-
ing light may stay on for such a short time
that it is not noticed.
5)Fully depress the clutch pedal.
6)Turn the ignition key to AV Vas soon
as the
m
warning light goes off. Waiting
too long would make the glow plug heating
work pointless.WARNINGThe electric devices that ab-
sorb much energy (air conditioner,
rearscreen heating, etc.) are disengaged au-
tomatically during engine starting.
If the engine does not start at the first at-
tempt, move the ignition key back to the
STOPposition before repeating starting.
If starting is difficult (with the Alfa Romeo
CODE system efficient), do not insist with
prolonged attempts.
Only use an auxiliary battery if it is noted
that the cause is due to low charge of the
car’s battery. Never use a battery charger to
start the engine (see “If the battery is flat”
in the chapter “In an emergency”).
WARMING THE ENGINE– Drive off slowly, at medium revs with-
out accelerating abruptly.
– Do not drive at full performance for the
initial kilometers of the journey, Wait until
the engine coolant temperature is between
50 and 60°C.SWITCHING OFF– Release the accelerator pedal and wait
until the engine reaches idle speed.
– Turn the ignition key to the STOPpo-
sition and switch off the engine.
WARNINGAfter a taxing drive it is bet-
ter to allow the engine to “catch its breath”
before turning it off by letting it idle to al-
low the temperature in the engine com-
partment to fall.

CORRECT USE OF THE CAR
192
SAFE DRIVINGIn designing your Alfa 156, Alfa
Romeo has worked thoroughly to achieve a
vehicle able to offer top levels of safety to
its passengers. However, the behaviour of
the driver is still a decisive factor for road
safety.
Below you will find a few simple rules for
travelling safely under different conditions.
You are certainly familiar with many of them
but it is still helpful to read them all care-
fully.BEFORE DRIVING OFF– Make sure the lights and headlights are
working properly.
– Adjust the seat, steering wheel and
rearview mirrors, in order to obtain a correct
position for driving.
– Adjust the seat back upright and keep
your head as close as possible to the head
restraint.– Carefully adjust the headrests so that
the head and not the neck rests on them.
Check that nothing (mats, etc.) can get un-
der the foot pedals.
– Make sure that any child restraint sys-
tem (seats, cradles, etc.) are correctly fas-
tened on the rear seat.
– Place any objects in the boot with care
to prevent abrupt braking from throwing
them forwards.
– Avoid heavy meals before a journey. A
light meal will help to keep reflexes ready.
Above all avoid alcohol.
Routinely remember to check:
– tyre pressure and conditions;
– engine oil level;
– engine coolant level and system condi-
tions;
– brake fluid level;
– power steering oil level;
– windscreen washer fluid level.
WHEN TRAVELLING– The first rule for safe driving is care.
– Care also means being able to predict
the actions of other road users.
– Strictly respect the traffic regulations in
all countries, especially the speed limits.
– Ensure that both yourself and your pas-
sengers are wearing their seat belts, that
children are carried with the appropriate
seats and that any animals are in appropri-
ate compartments.
– Long distances should be trackled in
good health.
Driving under the influence
of drugs and/or some
medicines is highly dangerous for
oneself and for others.
WARNING

CORRECT USE OF THE CAR
204
REMOVING FROM STORAGEBefore using your vehicle after a long pe-
riod of inactivity, the following operations
should first be carried out:
– Do not dust the outside of the vehicle.
– Visually check that there are no leaks
(oil, brake and clutch fluid, engine coolant,
etc.).
– Replace engine oil and filter.
– Check:
- brake-clutch fluid level
- level of engine coolant fluid.
– Check the air cleaner and replace if nec-
essary.
– Check tyre pressure and ensure that they
are not damaged, cracked or cut. If they are
they must be replaced.– Check the state of the drive belts.
– Reconnect the battery negative termi-
nal (–) after checking that the charge is ad-
equate.
– With the gear lever in neutral start the
engine and allow the engine to run for a few
seconds whilst repeatedly working the clutch
pedal.
USEFUL ACCESSORIESIn addition to the legal requirements, we
recommend keeping the following in the car
(fig. 1):
– first aid kit with non-alcoholic base dis-
infectant, steril gauzes, a roll of gauze, plas-
ters, etc.;
– torch;
– round-ended scissors;
– work gloves.fig. 1
A0B0389m
This operation must be per-
formed in the open. The
exhaust gases contain carbon
monoxide which is extremely toxic
and may also be lethal.
WARNING

CAR MAINTENANCE
250
20 40 60 80 100 120 140 160 180
Thousand of km
Change fuel filter (diesel versions only)Change air cleaner cartridge (petrol engines)Change air cleaner cartridge (diesel versions only)
Check and if necessary top up fluid levels (brakes, hydraulic clutch, power steering, windscreen wiper, battery, engine coolant, etc..) Check and if necessary top up Selespeed oil level (2.0 JTS version)Replacement of timing drive belt (*) and Poly-V accessory drive beltReplacement of counter-rotating shaft drive belt (only 2.0 JTS)Replacement of spark plugs (T.SPARK 16V, 2.0 JTS and 2.5 V6 24V versions) Check operation of engine control systems (through diagnosis)Check gearbox and differential oil levelCheck automatic gearbox oil level (2.5 V6 24V version)Change engine oil and oil filterChange brake fluid (or every 2 year)Replacement of dust/pollen filter
●●●●●●●●●
●●●●
●●●●●●●●●
●●●●●●●●●
●●●●●●●●●
●
●
●
●●●●
●●
●●●●●●●●●
●●●●●●●●●
●●●
●●●●●●●●●
(*) Or every 3 years in harsh conditions (cold – hot climates, stop and go city traffic, dusty areas or roads covered with sand and/or salt)
Or every 5 years, regardless of the mileage.

CAR MAINTENANCE
251
ADDITIONAL
OPERATIONSEvery 1000 kmor before long journeys
check and if necessary top up:
– engine coolant level
– brake fluid/hydraulic clutch control flu-
id level
– power steering fluid level
– windscreen washer and headlamp wash-
er fluid level
– tyre pressure and conditions.
Every 3000 kmcheck the level of the
engine oil and top up if necessary.
You are recommended to use products of
the FL Selenia, designed and developed
expressly for Alfa Romeo cars (see the table
“Specifications of fluids and lubricants” in
the “Technical specifications” chapter).
ANNUAL INSPECTION
PROGRAMMEAn annual inspection programme
has been established for cars thet
cover less than 20,000 km (e.g.
10,000 km). It consists of the fol-
lowing:
– Check tyre conditions/wear and adjust
pressure if required (including the compact
spare wheel)
– Check lighting system operation (head-
lights, direction indicators, hazard lights,
boot lights, passenger compartment lights,
glovebox light, warning lights of instrument
panel, etc.)
– Check windscreen and rear-screen
wiper/washer operation, adjust nozzles
– Check windscreen/rear-screen blade po-
sition/wear
– Check condition and wear of the front
brake pad
– Check for bonnet and boot lock clean-
ness, lever cleanness and lubrication– Visually check the following: engine,
gearbox, transmission, piping (exhaust - fu-
el - brakes) rubber components (casings -
sleeves - bushings, etc..), brake and fuel
hoses
– Check battery charge condition
– Visually check the condition of the belts
and various controls
– Check and top up if necessary, the flu-
id levels (coolant, brake fluid, windscreen
washer fluid, battery, etc.)
– Change engine oil
– Replace engine oil filter
– Change pollen filter.

CAR MAINTENANCE
254
fig. fig. fig. 2 - 2.0 JTS version
A0B00436m
fig. 1 - 1.6 T.SPARK, 1.8 T.SPARK versions
A0B00174m
CHECKING FLUID
LEVELS1Engine oil - 2Battery - 3Brake fluid -
4Windscreen washer fluid - 5Engine
coolant fluid - 6Power steering fluid When topping up take
care not to confuse the var-
ious types of fluids: they
are all incompatible with one an-
other and could seriously damage
the car.
Never smoke while work-
ing in the engine compart-
ment; gas and inflammable
vapours may be present, with the
risk of fire.
WARNING

CAR MAINTENANCE
255
fig. 3 - 2.5 V6 24V version
fig. 4 - JTD version
A0B00175mA0B00176m
1Engine oil - 2Battery - 3Brake fluid -
4Windscreen washer fluid - 5Engine
coolant fluid - 6Power steering fluid
1Engine oil - 2Battery - 3Brake fluid -
4Windscreen washer fluid - 5Engine
coolant fluid - 6Power steering fluid

CAR MAINTENANCE
256
A0B0558m
1Engine oil - 2Battery - 3Brake fluid -
4Windscreen washer fluid - 5Engine
coolant fluid - 6Power steering fluid
1Engine oil - 2Battery - 3Brake fluid -
4Windscreen washer fluid - 5Engine
coolant fluid - 6Power steering fluidfig. 5 - JTD 16V Multijet version
fig. 6 - JTD 20V Multijet version
To improve picture detail, the engine compartment is illustrated without the bonnet
A0B0616m