INSTRUMENT AND CONTROL FUNCTIONS
3-19
3
EAU01084
Catalytic converter This motorcycle is equipped with a cat-
alytic converter in the exhaust cham-
ber.
EW000128
WARNING
_ The exhaust system is hot after op-
eration. Make sure that the exhaust
system has cooled down before do-
ing any maintenance work. _
EC000114
CAUTION:_ The following precautions must be
observed to prevent a fire hazard or
other damages.
Use only unleaded gasoline.
The use of leaded gasoline will
cause unrepairable damage to
the catalytic converter.
Never park the motorcycle near
possible fire hazards such as
grass or other materials that
easily burn.
Do not allow the engine to idle
too long.
_
EAU03814
Seats Rider seat
To remove the rider seatPull up the rear corners of the rider seat
as shown, remove the bolts, and then
pull the seat off.To install the rider seat
Insert the projection on the front of the
rider seat into the seat holder as
shown, place the seat in the original
position, and then install the bolts.
1. Bolt (× 2)
1. Projection
2. Seat holder
U5SLE0.book Page 19 Wednesday, September 11, 2002 11:46 AM
INSTRUMENT AND CONTROL FUNCTIONS
3-20
3
Passenger seat
To remove the passenger seat
1. Insert the key into the seat lock,
and then turn it counterclockwise.
2. While holding the key in that posi-
tion, lift the front of the passenger
seat and pull it forward.To install the passenger seat
1. Insert the projection on the rear of
the passenger seat into the seat
holder as shown, and then push
the front of the seat down to lock it
in place.
2. Remove the key.NOTE:_ Make sure that the seats are properly
secured before riding. _
1. Passenger seat lock
2. Unlock.Left side
1. Projection
2. Seat holder
U5SLE0.book Page 20 Wednesday, September 11, 2002 11:46 AM
