2003 YAMAHA WARRIOR 350 low beam

Cable inspection and lubrication ........ 8-65
Brake and shift pedal/brake and
clutch lever lubrication...................... 8-65
Front upper and lower arm
pivot lubrication ................................ 8-67
Rear arm pivot lubrication .................. 8-69
Wheel removal ................................... 8-71
Wheel installation ............................... 8-73
Battery ................................................ 8-75
Replenishing the battery fluid ............. 8-79
Fuse replacement............................... 8-83
Replacing a headlight bulb ................. 8-85
Headlight beam adjustment................ 8-93
Tail/brake light bulb replacement ....... 8-95
Troubleshooting.................................. 8-97
Troubleshooting chart......................... 8-99
CLEANING AND STORAGE ................... 9-1
A. Cleaning ........................................... 9-1
B. Storage ............................................ 9-7
9
SPECIFICATIONS................................. 10-1
CONVERSION TABLE .......................... 11-1
1011
U5NF61.book Page 3 Wednesday, June 13, 2001 5:18 PM

4-5 1. Light switch “LIGHTS”
2. Engine stop switch “ENG. STOP”
3. Start switch “START”
1. Contacteur d’éclairage “LIGHTS”
2. Coupe-circuit du moteur “ENG. STOP”
3. Contacteur du démarreur “START”
1. Interruptor de luces “LIGHTS”
2. Interruptor de paro del motor “ENG. STOP”
3. Interruptor de arranque “START”
EBU00053
Handlebar switches
EBU00943
Light switch “LIGHTS”
Turn the switch to the “LO” position to switch on
the low beam and the taillight.
Turn the switch to the “HI” position to switch on the
high beam and the taillight.
Turn the switch to the “OFF” position to switch off
the headlights and the taillight.CAUTION:_ Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it. _
U5NF61.book Page 5 Wednesday, June 13, 2001 5:18 PM

8-93 1. Vertical adjusting screw (× 2)
1. Vis de réglage vertical (× 2)
1. Tornillo de ajuste vertical (× 2)
EBU00409
Headlight beam adjustmentCAUTION:
It is advisable to have a Yamaha dealer make
this adjustment.1. Vertical adjustment:
To raise the beam, turn the adjusting screw
clockwise.
To lower the beam, turn the screw counter-
clockwise.
U5NF61.book Page 93 Wednesday, June 13, 2001 5:18 PM