Page 41 of 74
6-11
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9i. Fill the engine with oil. Install
the oil filler cap and tighten.
EC000066
cC
8Do not put in any chemical
additives. Engine oil also lubri-
cates the clutch and additives
could cause clutch slippage.
8Be sure no foreign material
enters the crankcase.
Recommended oil:
See page 8-1
Oil quantity:
Total amount:
1.3 L
Periodic oil change:
1.0 L
With oil filter replacement:
1.1 LTightening torque:
Drain plug:
10 Nm (1.0 m0kg)
Filter cover screw:
10 Nm (1.0 m0kg)
Drain bolt (filter cover):
10 Nm (1.0 m0kg)j. Start the engine and warm up
for a few minutes. While
warming up, check for oil leak-
age. If oil leakage is found,
stop the engine immediately
and check for the cause.
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 40
Page 42 of 74

6-12
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU01094Air filter
The air filter should be cleaned at
the specified intervals. It should be
cleaned more frequently if you are
riding in unusually wet or dusty
areas.
1. Remove panel B. (See page 6-7
for panel removal and installa-
tion procedures.)
2. Remove the air filter case fit-
ting screws and the air filter
case cover.
1
1. Air filter
3. Remove the air filter from its
case and clean it with solvent.
After cleaning, remove the
remaining solvent by squeez-
ing the air filter.
4. Apply the recommended oil to
the entire surface of the filter
and squeeze out the excess oil.
It should be wet but not drip-
ping.
1
1. Screw (×4)
Recommended oil:
Same as engine oil
5. Install the air filter in its case.
6. Install panel B.
EC000085
cC
8Make sure the air filter is prop-
erly seated in the filter case.
8The engine should never be
run without the air filter
installed. Excessive piston
and/or cylinder wear may
result.
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 41
Page 54 of 74

6-24
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00772
Cable inspection and
lubrication
EW000112
w
Damage to the outer housing of
cables may lead to internal rusting
and interfere with the cable move-
ment. Replace damaged cables as
soon as possible to prevent unsafe
conditions.
Lubricate the cables and cable
ends. If a cable does not operate
smoothly, ask a Yamaha dealer to
replace it.
Recommended lubricant:
Same as engine oil
EAU00773
Throttle cable and grip
lubrication
The throttle twist grip assembly
should be greased at the time that
the cable is lubricated, since the
grip must be removed to get at the
end of the throttle cable. After
removing the screws, hold the end
of the cable up in the air and put in
several drops of lubricant. With the
throttle grip disassembled, coat the
metal surface of the grip assembly
with a suitable all-purpose grease.
EAU00776
Brake and shift pedal
lubrication
Lubricate the pivoting parts.
Recommended lubricant:
Same as engine oil
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 53
Page 55 of 74
6-25
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00778
Brake and clutch lever
lubrication
Lubricate the pivoting parts.
EAU00785
Sidestand lubrication
Lubricate the sidestand pivoting
point and metal-to-metal contact
surfaces. Check that the sidestand
moves up and down smoothly.
EW000113
w
If the sidestand does not move
smoothly, consult a Yamaha deal-
er.
Recommended lubricant:
Same as engine oil
Recommended lubricant:
Same as engine oil
EAU00791
Rear suspension lubrication
Lubricate the pivoting parts.
Recommended lubricant:
Lithium soap base grease
5FY-9-E0 (TW200) 7/29/02 10:54 AM Page 54