2003 YAMAHA TDM 900 wheel

7
7-5
MOTORCYCLE CARE AND STORAGE
d. Turn the engine over several
times with the starter. (This
will coat the cylinder walls with
oil.)
e. Remove the spark plug caps
from the spark plugs, and then
install the spark plugs and the
spark plug caps.
EWA00003
w
To prevent damage or injury from
sparking, make sure to ground the
spark plug electrodes while turn-
ing the engine over.
4. Lubricate all control cables and
the pivoting points of all levers
and pedals as well as of the
sidestand/centerstand.5. Check and, if necessary, correct
the tire air pressure, and then lift
the motorcycle so that both of its
wheels are off the ground.
Alternatively, turn the wheels a
little every month in order to pre-
vent the tires from becoming
degraded in one spot.
6. Cover the muffler outlets with
plastic bags to prevent moisture
from entering them.
7. Remove the battery and fully
charge it. Store it in a cool, dry
place and charge it once a
month. Do not store the battery
in an excessively cold or warm
place [less than 0 °C or more
than 30 °C]. For more informa-
tion on storing the battery, see
page 6-34.
NOTE:
Make any necessary repairs before
storing the motorcycle.
5PS-28199-E1 8/29/02 9:17 AM Page 96

8
8-1
EAU01038
SPECIFICATIONS
SpecificationsSpecifications
Model TDM900
Dimensions
Overall length 2,180 mm
Overall width 800 mm
Overall height 1,290 mm
Seat height 825 mm
Wheelbase 1,485 mm
Ground clearance 160 mm
Minimum turning radius 2,900 mm
Basic weight (with oil and full
fuel tank)221 kg
Engine
Engine type Liquid-cooled 4-stroke, DOHC
Cylinder arrangement Forward-inclined parallel
2-cylinder
Displacement 897 cm
3
Bore ×Stroke 92.0 ×67.5 mm
Compression ratio 10.4:1
Starting system Electric starter
Lubrication system Dry sumpEngine oil
Type
Recommended engine oil
classification API Service SE, SF, SG type
or higher
cC
In order to prevent clutch slippage (since the engine oil also
lubricates the clutch), do not mix any chemical additives. Do
not use oils with a diesel specification of “CD” or oils of a
higher quality than specified. In addition, do not use oils
labeled “ENERGY CONSERVING II” or higher.
Capacity
Without oil filter element
removal 3.8 L
With oil filter element removal 3.9 L
Total amount (dry engine) 4.7 L
5PS-28199-E1 8/29/02 9:17 AM Page 98

8
8-3
SPECIFICATIONS
Maximum load* 203 kg
Tire air pressure
(measured on cold tires)
Up to 90 kg*
Front
225 kPa (2.25 kgf/cm2, 2.25 bar)
Rear250 kPa (2.50 kgf/cm2, 2.50 bar)
90 kg load–Maximum*
Front
225 kPa (2.25 kgf/cm2, 2.25 bar)
Rear290 kPa (2.90 kgf/cm2, 2.90 bar)
High-speed riding
Front
225 kPa (2.25 kgf/cm2, 2.25 bar)
Rear250 kPa (2.50 kgf/cm2, 2.50 bar)
*Total weight of rider, passenger, cargo and accessories
Wheels
Front
Type Cast wheel
Size 18 M/C ×MT 3.50
Rear
Type Cast wheel
Size 17 M/C ×MT 5.00Brakes
Front
Type Dual disc brake
Operation Right hand
Fluid DOT 4
Rear
Type Single disc brake
Operation Right foot
Fluid DOT 4
Suspension
Front
Type Telescopic fork
Rear
Type Swingarm (link suspension)
Spring/shock absorber
Front Coil spring/oil damper
Rear Coil spring/gas-oil damper
Wheel travel
Front 150 mm
Rear 133 mm
5PS-28199-E1 8/29/02 9:17 AM Page 100

Shift points (for Switzerland only) ...........5-3
Shifting ...................................................5-2
Shock absorber assembly, adjusting ....3-16
Sidestand .............................................3-18
Sidestand, checking and lubricating .....6-30
Spark plugs, checking ............................6-7
Specifications .........................................8-1
Speedometer unit ...................................3-4
Starting the engine .................................5-1
Steering, checking ................................6-32
Storage ...................................................7-4
Storage compartment ...........................3-14
Supporting the motorcycle ....................6-38
T
Tachometer unit .....................................3-5
Tail/brake light bulb, replacing ..............6-37
Throttle cable free play, adjusting ........6-18
Throttle grip and cable, checking
and lubricating ...................................6-29
Tires .....................................................6-18
Tool kit ....................................................6-1
Troubleshooting ....................................6-43
Troubleshooting charts .........................6-44
Turn signal light bulb, replacing ............6-37
V
Valve clearance, adjusting ...................6-18
Vehicle identification number .................9-1W
Wheel (front)..........................................6-39
Installing .............................................6-40
Removing ...........................................6-39
Wheel (rear) .........................................6-40
Installing .............................................6-42
Removing ...........................................6-40
Wheel bearings, checking ....................6-32
Wheels .................................................6-22
INDEX
5PS-28199-E1 8/29/02 9:17 AM Page 107