2003 YAMAHA BREEZE tire type

2-13
8Never operate an ATV in fast flowing water or
in water deeper than that recommended in
this manual. Remember that wet brakes may
have reduced stopping ability. Test your
brakes after leaving water. If necessary, apply
them several times to let friction dry out the
linings.
8Always be sure there are no obstacles or peo-
ple behind you when you operate in reverse.
When it is safe to proceed in reverse, go
slowly.
8Always use the size and type tires specified in
this manual.
8Always maintain proper tire pressure as
described in this manual.
8Never modify an ATV through improper instal-
lation or use of accessories.
5VJ-9-60-02 3/26/02 9:19 PM Page 14

5-19
EBU00158Tires
Always use the recommended tires.wUse of improper tires on this ATV, or opera-
tion of this ATV with improper or uneven tire
pressure, may cause loss of control, increas-
ing your risk of accident.
Pay attention to the following.
1. The tires listed below have been
approved by Yamaha Motor Co., Ltd. for
this model. Other tire combinations are
not recommended.
2. The tires should be set to the recom-
mended pressure:
8Recommended tire pressure
Front 20 kPa (0.20 kg/cm
2, 0.20 bar)
Rear 25 kPa (0.25 kg/cm2, 0.25 bar)
Manufacturer Size Type
Front DUNLOP AT20 ×7 – 8KT536A
Rear DUNLOP AT22 ×10 – 8KT537A
5VJ-9-60-05 3/26/02 9:14 PM Page 20

7-15
wAlways use the size and type tires specified
in the Owner's Manual for this vehicle on
pages 5-19 – 5-21. Always maintain proper
tire pressure as described in the Owner's
Manual on page 5-23. Use of improper tires
on this ATV, or operation of this ATV with
improper or uneven tire pressure, may cause
loss of control, increasing your risk of an
accident.Do not operate at speeds too fast for your
skills or the conditions.wAlways go at a speed that is proper for the
terrain, visibility and operating conditions,
and your experience. Operating this ATV at
speeds too fast for your skills or the condi-
tions increases your chances of losing con-
trol of the ATV, which can result in an acci-
dent.
5VJ-9-60-07 3/26/02 9:15 PM Page 16

8-72
FBU01112Dépose d’une roue
1. Desserrer les écrous de roue.
2. Surélever le VTT et placer un support adé-
quat sous le cadre.
3. Retirer les écrous de la roue.
4. Déposer la roue.FBU01150Repose d’une roue
1. Poser la roue et les écrous.N.B.:
Les écrous de fixation des roues avant et arrière
sont de type conique. Monter les écrous en pla-
çant leur partie conique du côté de la roue.2. Reposer la roue sur le sol.
3. Serrer les écrous de roue au couple de serra-
ge spécifié.
SBU01112Desmontaje de una rueda
1. Afloje las tuercas de la rueda.
2. Levante el ATV y coloque un soporte ade-
cuado debajo del chasis.
3. Quite las tuercas de la rueda.
4. Extraiga la rueda.SBU01150Montaje de la rueda
1. Instale la rueda y las tuercas.NOTA:
Tanto en la rueda delantera como en la trasera
se utilizan tuercas cónicas. Coloque la tuerca
con el lado cónico orientado hacia la rueda.2. Baje el ATV al suelo.
3. Apriete las tuercsa de la rueda al par de tor-
sión especificado.
Couple de serrage:
Écrou de roue avant:
55 Nm (5,5 m
0kgf)
Écrou de roue arrière:
55 Nm (5,5 m0kgf)
Par de torsión:
Tuerca de la rueda delantera:
55 Nm (5,5 m0kgf)
Tuerca de la rueda trasera:
55 Nm (5,5 m0kgf)
5VJ-9-60-08 3/26/02 9:17 PM Page 8-73

10-4
Model YFA1
Chassis:
Frame type Steel tube frame
Caster angle 6°
Trail 15 mm
Tire:
Type Tubeless
Size: Front AT20 ×7 - 8
Rear AT22 ×10 - 8
Manufacturer/type:
Front DUNLOP/KT536ARear DUNLOP/KT537A
Brake:
Front brake type Drum brake
Operation Right hand operation
Rear brake type Drum brakeOperation Left hand operation
Suspension:
Front Swing axle
Rear Swingarm
5VJ-9-60-09~11 3/26/02 9:18 PM Page 15