2003 YAMAHA BLASTER 200 recommended oil

5-13
EBU00134
Engine oil
Make sure the engine oil is at the specified level.
Add oil as necessary (see page 10-2).
NOTE:
Be sure to push the cap into the filler neck until it
is properly seated.
q
1. Oil tank filler cap1. Bouchon de remplissage de réservoir d’huile1. Tapa de llenado de depósito de aceite
Recommended oil:
Air-cooled 2-stroke engine oil
Oil quantity:
Total amount:
1.3 L
5VM-9-60 (4~5 shou) 6/20/02 4:15 PM Page 50

5-15
EBU01308
Transmission oil
Make sure the transmission oil is at the specified
level. Add oil as necessary. (See pages 8-17–
8-23.)
cC
8In order to prevent clutch slippage (since
the transmission oil also lubricates the
clutch), do not mix any chemical additives.
Do not use oils with a diesel specification of
“CD” or oils of a higher quality than speci-
fied. In addition, do not use oils labeled
“ENERGY CONSERVING
II” or higher.
8Make sure that no foreign material enters
the crankcase.
Recommended oil:
SAE 10W30
Recommended oil classification:
API Service SE, SF, SG type or higher
Oil quantity:
Total amount:
0.7 L
Periodic oil change:
0.65 L
5VM-9-60 (4~5 shou) 6/20/02 4:15 PM Page 52

8-9
NOTE:
8Recommended brake fluid: DOT 4
8Brake fluid replacement:
9When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally
check the brake fluid level and add fluid as required.
9On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two
years.
9Replace the brake hoses every four years, or if cracked or damaged.
5VM-9-60 (8 shou) 6/20/02 4:22 PM Page 10

8-21
cC
8Be sure to use motor oils that do not con-
tain anti-friction modifiers. Passenger car
motor oils (often labeled “ENERGY CON-
SERVING
II”) contain anti-friction addi-
tives which will cause clutch and/or starter
clutch slippage, resulting in reduced com-
ponent life and poor engine performance.
8Be sure no foreign material enters the
crankcase.
Recommended oil:
See page 10-2
Oil quantity:
Total amount
0.7 L
Periodic oil change
0.65 L
5VM-9-60 (8 shou) 6/20/02 4:22 PM Page 22

8-81
EBU00570
Cable inspection and lubrication
w
Inspect cables frequently and replace if dam-
aged. Corrosion can result when the outer
covering of control cables becomes dam-
aged. Cables can also become frayed or
kinked. Operation of controls could be
restricted, which could cause an accident or
injury.
Lubricate the inner cables and the cable ends. If
the cables do not operate smoothly, ask a
Yamaha dealer to replace them.
Recommended lubricant:
Engine oil
5VM-9-60 (8 shou) 6/20/02 4:23 PM Page 82

10-2
Model YFS200
Engine oil (2-cycle):
Type Air-cooled 2-stroke engine oil
Quantity 1.3 L
Transmission oil:
Type SAE 10W30 type SE motor oil
Recommended transmission oil
classificationAPI Service SE, SF, SG type or higher
cC
In order to prevent clutch slippage (since the
transmission oil also lubricates the clutch),
do not mix any chemical additives. Do not
use oils with a diesel specification of “CD” or
oils of a higher quality than specified. In
addition, do not use oils labeled “ENERGY
CONSERVING
II” or higher.
Quantity:
Periodic oil change 0.65 L
Total amount 0.7 L
Air filter Wet type element
10
5VM-9-60 (9 shou ~) 6/21/02 11:14 AM Page 13