2003 VOLKSWAGEN PASSAT Engine light

Various factors influence fuel consumption:
engine wear. brakes
and tires, environmen­
tal impact.
T his chapter addresses some of these
points.
Your
warm up.
When the engine is idling, it takes a very
long time to warm
up. Moreover. during
warm-up, both engine wear and exhaust
gas emissions are very high. Therefore, be
ready to drive
off immediately after starting
the engine and avoid high engine speeds.
Avoid
Upshift as early as possible -do not drive at unnecessarily high engine speeds.
The highest fuel economy and the least di­
sturbance to the environment are attained
when you drive at l
ow engine speeds and in
the highest possible gear.
For example , fuel consumption is twice
as high in 2nd gear as it is in the highest gear.
Downshift only when the engine is no longer running smoothly.
Depending on the transmission you have.
you can normally drive in the highest gear at
25 to 37 mph
(40 to km
Avoid driving at high speed.
Fuel consumption, exhaust emissions and
engine noise increase disproportionately at
high speeds.
you drive at approximately
three quarters of top speed, fuel consump­
tion
be reduced by one half. Never drive
faster than the posted speed limit and wea­
ther condit ions permitting.
Drive as smoothly as possible and keep a lookout ahead.
Unnecessary accelerating and braking in­
crease fuel consumption and disturb the en­
vironment.
Switch off your engine if you are caught in a traffic jam. This sa­
ves fuel and reduces emissions.
The
Heavy traffic, especially in large cities
w ith many traffic lights.
Stop-and-go driving, especially short di­
stances so that the engine never warms up as it should.
Driving in heavy, slow moving traffic in low gear so that the engine speed is relati­
vely high when compared to the distance
driven.
Plan your trips ahead of time. Organize your trips to include several errands and to avoid heavy traffic.
course. there are some conditions that affect fuel consumption that you can't
control.
For example, fuel consumption increases in
the wint er or under difficult conditions
(bad roads. towing a trailer. etc.).
DRIVING AND

Lights
The
proper working of
Safety chains
Be sure connected from the Leave enough
A
to the extent
as
transfe r some cargo to th e
requirements
and
The higher the the more
Be
Reduce speed shows the
some areas
speeds for are
The cooling effect of the radiator
fan cannot be increased by downs­hifting because fan speed is inde­
pendent of engine speed. Therefo­re, when driving
---------DRIVING AND

Checking the engine
when you
check the oil.
To obtain an accu ra te reading, the engine
must be switched off.
marks when the engi­
n e is col d and can
be slightly above the
Indicator
blink until
the coolant level has been restored to nor­
mal.
losses may indicate a leak in the
cooling sys tem. In the event of coo la n t los ­
ses, the cooli ng sys tem should be inspec­
t ed immediately by your authorized
WAGEN dealer. It is not enough merely to add coolant.
In a sealed system, losses
can occ ur on ly if
the boiling point of the coolant is exceeded as a result of over heating .
AND FILLING----------------41

You must depress the clutch pedal
the way before you can start the engine.
Always depress the clutch pedal ful­ly when changing gears. Do not hold
the vehicle on a hill with the clutch pedal partially depressed. This may cause premature clutch wear or da­mage.
Resting your hand on the gearshift lever knob while driving will cause
premature wear in the transmission.
Drive in 6th gear for optimum fuel economy
when cruising. However,
if more accelera­
tion is required (when passing, for exam ­
ple). shift down .
Gearshift pattern
press down and push forward. after driving forward. stop the ve­
I .
-
B45-667K
High beam
The headlights work only when the ignition
is switched on.
The headlights stay on when you switch on
the high beam.
high beam with
high beam with reduced brightness.
High beam with brightness
Switching on:
With the headlights on. push the lever for­
ward ( 4 ).
The blue indicator ligh t in the instrument
the lever (3 ) towards you.
High beam with reduced bright-
ness
With the headlights
will come on.
the switch (A ) qut to the second detent.
Switching off: