Page 250 of 271

’03 Rav4_U (L/O 0208)
2442003 RAV4 from Aug. ’02 Prod. (OM42517U)
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.Light bulbsBulb
No.WTy p e
Headlights—60/55A
Front fog lights—51B
Parking and front
side marker lights1685C
Front turn signal
lights (without
front fog lights)
7440A21C
Front turn signal
lights (with front
fog lights)
744021C
Rear turn signal
lights744021C
Stop/tail and rear
side marker lights744321/5C
Back up lights744021C
High mounted stop
light744021C
License plate light1685C
Replacing light bulbs—
Page 252 of 271
’03 Rav4_U (L/O 0208)
2462003 RAV4 from Aug. ’02 Prod. (OM42517U)
“TOP” mark
3. Install the rubber cover with the“TOP” mark upward, and fit it se-
curely on the boss. Plug in the con-
nector.
Make sure the rubber cover fits securely
on the bulb base and the mounting body.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.1. Loosen the retainer screw with a Phillips head screwdriver and take
out the front turn signal light unit.2. Remove the front fog light unit.
—Front fog lights
Page 253 of 271
’03 Rav4_U (L/O 0208)
2472003 RAV4 from Aug. ’02 Prod. (OM42517U)
3. Unplug the connector while depress-ing on the tab.
If the connector is tight, wiggle it.4. Turn the bulb and remove it.5. Install a new bulb and the connector into the mounting hole. Install the
front fog light unit then the front
turn signal light unit, and tighten the
retainer screw.