2003 TOYOTA LAND CRUISER stop start

ii
2003 Land Cruiser 100 Navigation (OM60A00U)
Important information about this manual
For safety reasons, this manual indicates
items requiring particular attention with the
following marks.
CAUTION
This is a warning against anything
that may cause injury to people if the
warning is ignored. You are informed
about what you must or must not do
in order to reduce the risk of injury to
yourself and others.
NOTICE
This is a warning against anything
which may cause damage to the ve-
hicle or its equipment if the warning is
ignored. You are informed about what
you must or must not do in order to
avoid or reduce the risk of damage to
your vehicle and its equipment.
INFORMATION
This provides additional information.
Initial screen
UN001
When you start the engine or turn the ignition
key to ”ACC”, the initial ”TOYOTA” screen
appears and the system begins operating.
CAUTION
When the vehicle is stopped with the
engine running, always apply the park-
ing brake for safety.
After a few seconds, the ”CAUTION” screen
appears.
OUE003
Touch either “English” or “French” to se-
lect the language. Read it and follow the
instructions.
If a screen other than for the navigation sys-
tem is displayed (i.e., for the trip information
screen), the current screen would change to
the ”CAUTION” screen by pushing the
”MAP/VOICE”, ”DEST” or ”MENU”
button on the bezel or by touching the
”Maintenance” switch on the informa-
tion menu screen.
When you touch the
”I agree” switch on
the screen, the ”map” screen appears.

102
2003 Land Cruiser 100 Navigation (OM60A00U)
Trip information such as driving time,
driving distance, average vehicle speed,
fuel consumption, etc. can be displayed
on the screen.
1. Push the
”INFO” button to display
the information menu screen.
UNG403a
2. To u c h t h e ”Trip Information”switch.
UNG401
Consumption
The consumption is calculated and dis-
played based on the driving distance and
the fuel consumption for 2 seconds with
engine running.
The value is updated every 2 seconds.
If you are driving at low speeds just before
stopping, the accurate figure way not be
shown.
After Refueling
The consumption after refueling is calcu-
lated and displayed based on the total
driving distance and the total fuel con-
sumption after refueling.
The value is updated every 10 seconds. When refueling, be
sure to stop your vehicle
and turn the ignition switch off.
Cruising Range
How far you can drive with the remaining
fuel is displayed.
Even though the display indicates sufficient
miles to run, if the fuel level on the fuel gauge
approaches ”E” or the low fuel level warning
light comes on, fill the fuel tank as soon as
possible.
INFORMATION
 When you first start driving your new
vehicle, the correct cruising range
may not be shown. One or more re-
fills of 10 gallons or more may be re-
quired for the system to set its cal-
ibration.
 The cruising range displayed is cal-
culated based on past fuel consump-
tion and may vary according to your
driving style and road condition.
Trip information

103
2003 Land Cruiser 100 Navigation (OM60A00U)
Average Speed
The Average Speed is displayed. The av-
erage vehicle speed is calculated and dis-
played based on the total driving distance
and the total driving time after the engine
is started.
The displayed value is updated every 10
seconds.
To calculate from the beginning, touch the
”Reset” switch.
Distance
The distance after engine starting is dis-
played.
When refueling, be sure to stop your vehicle
and turn the ignition switch off.
To calculate from the beginning, touch the
”Reset” switch. The function returning to the previous
screen from the audio or air conditioner
screen is selectable.
1. Push
the
”INFO” button on the bezel
to display the Information menu screen
and touch the
”Screen Transition”switch.
UNG404
2. Select the ”ON” or ”OFF” and then
touch the
”OK”.
ON: The previous screen automatically re-
turns from the audio or air conditioner screen
20 seconds after the end of audio or air con-
ditioner screen operation.
OFF: The audio or air conditioner screen re-
mains on. You can adjust the brightness or contrast
of the screen depending on the bright-
ness of your surroundings. Y
ou also can
turn the display off.
Push the
”DISPLAY” button on the bez-
el to display the Display screen.
Screen transitionScreen adjustment

123
2003 Land Cruiser 100 Navigation (OM60A00U)
Your vehicle has an electronic tuning radio
(ETR). Tune in the desired station using one
of the following methods.
Preset tuning: Touch the switch (1−6) or
push the ”
” or ”” bu tto n of th e ”CH” button
for the station you want. The switch (1 −6) is
highlighted in green and station frequency
appears on the display.
Manual tuning: Turn the ”TUNE” knob brief-
ly. Each time you turn the knob, the radio will
step up or down to another frequency.
Seek t uning: Push the ”” or ”” button of
the ”SEEK” button and hold it until you hear
a beep. The radio will begin seeking up or
down for a station of the nearest frequency
and will stop on reception. Each time you
push the button, the stations will be searched
out one after another.
UNG612
Scan tuning: Touch the ”SCAN” switch
briefly. ”SCAN” appears on the display. The
radio will find the next station up or down the
band, stay there for a few seconds, and then
scan again. To select a station, touch the
”SCAN” switch a second time.
Preset scan tuning: Touch the ”SCAN”
switch and hold it until you hear a beep. ”P.
SCAN” appears on the display. The radio will
tune in the next preset station up or down the
band, stay there for a few seconds, and then
move to the next preset station. To select a
station, touch the ”SCAN” switch a second
time.
TRAF (T raffic) function: A station that reg-
ularly broadcasts traffic information is
automatically sought.
When you push the ”TRAF” button, ”TRAF
SEEK” appears on the display and the radio
will start seeking any traffic program station.
If any traffic program station is not found,
”NOTHING” appears and the previous mode
returns.
If the traffic program station is found, the
name for traffic program station is displayed
and ”TRAF” is lit for a while until traffic an-
nouncement is received.
(c) Selecting a station(d) RDS (Radio Data System)

125
2003 Land Cruiser 100 Navigation (OM60A00U)
UNG618
If a new message is received with the first
text message on the display, ”MSG” appears
on the corner of the screen again. When you
touch the ”LATEST MESSAGE” switch, the
new message appears.
The RDS audio system can store three mes-
sages consisting of 64 characters in
memory. To store a message in memory,
touch the ”STORE” switch until you hear a
beep.
If 3 messages are already stored in memory,
the oldest message will be overwritten by the
new message. To recall a radio text message, touch the
”RECALL”
switch. Each time you touch the
switch, the available messages will be dis-
played beginning with the newest one.
When you touch the ”OK” switch, the pre-
vious screen returns.
unc614
When you insert a cassette tape, the ex-
posed tape should face to the right.
The player will automatically start when you
insert a cassette tape. At this time, ”Tape”
appears on the display.
If a metal or chrome equivalent cassette tape
is put in the cassette player, the player will
automatically recognize it and ”MTL” ap-
pears on the display.
To stop or eject the cassette tape, push the
”
” button.
Cassette tape player
o
peration
(a) Playing a cassette tape

130
2003 Land Cruiser 100 Navigation (OM60A00U)
unx608
5. Insert the magazine into the player as
indicated by the arrow ahead on the mag-
azine, close the door and console box.
When the magazine is set completely, the
system will be in a “Load” cycle for approxi-
mately 30 seconds while the system
searches for discs in the magazine. Upon
completion of this cycle, the DVD player unit
will be ready to play. If the “DISC” button is
pushed during the “Load” cycle, “LOAD” ap-
pears on the display until the system has
completed the load cycle, after which the
system will begin normal play.
CAUTION
To reduce the chance of injury in case
of an accident or a sudden stop, always
keep the console box closed while driv-
ing.
Push the “DISC” button if the magazine is
already loaded in the player.
“DVD CHANGER” appears on the display.
The discs set in the magazine are played
continuously, starting with disc number 1.
The disc number of the disc currently being
played, the track number and the time from
the beginning of the program are shown on
the display.
(b) Playing a disc

134
2003 Land Cruiser 100 Navigation (OM60A00U)
Precautions on DVD video disc
When recording with a DVD video or video
CD, audio tracks may not record in some
cases while the menu is displayed. As audio
will not play in this case, verify that the video
tracks are playing and then activate play-
back.
When playback of a disc is completed:
 If an audio CD is playing, the next CD will
be selected and playback will begin auto-
matically.
 If a DVD video or video CD is playing,
playback will stop or the menu screen will
be displayed. The next disc will not play
back automatically. (Audio tracks cannot
be heard while the disc is stopped)
The title/chapter number and playback time
display may not appear while playing back
certain DVD video discs.
CAUTION
Conversational speech on some DVDs
is recorded at a low volume to empha-
size the impact of sound effects. If you
adjust the volume assuming that the
conversations represent the maximum
volume level that the DVD will play, you
may be startled by louder sound effects
or when you change to a different audio
source. The louder sounds may have a
significant impact on the human body
or pose a driving hazard. Keep this in
mind when you adjust the volume.
The ”DVD Hint!” screen appears when
the video screen is first displayed after
you turn the ignition key to ”ACC” or
”ON”.
Touch the ”OK” switch when you read the
message.

136
2003 Land Cruiser 100 Navigation (OM60A00U)
(iii) Description of each switch
 Switches on top page
“Menu” and “Top Menu” switches: If you
touch any of the above switches, the menu
screen for DVD video appears. (For the op-
eration, see the manual that come with the
DVD video disc provided separately.)
“
” switch: The menu control key ap-
pears on the screen. (See page 136.)
“
” switch: Use this switch to pause the
video screen. When you touch this switch
again, the video screen advances frame by
frame.
“ \b\b ” switch: Touch this switch to fast re-
verse during playback and reverse slowly
during pause.
“  ” switch: Use this switch to resume nor-
mal play after stop or pause.
“  ” switch: Touch this switch to fast for-
ward during playback and forward slowly
during pause.
 Switches on second page
“Set Up” switch: The initial set up screen
appears. (See page 138.) “Search” switch: The title search screen
appears. (See page 137.)
“Return”
switch: Use this switch to display
the predetermined scene and start playing
from there.
“Audio” switch: The audio changing
screen appears. (See page 137.)
“Sub Title” switch: The subtitle changing
screen appears. (See page 137.)
“Angle” switch: T h e a n g le s e le c tio n
screen appears. (See page 138.) (iv) Selecting a menu item
Enter the menu item using ”
”, ””, ””
and ” ” switches and touch ”Enter”.
The player starts playing video for that
menu item. (For details, see the manual
that comes with the DVD video disc pro-
vided separately.)
Each you push ”Shift Keys” switch, the
switches on the screen move upward and
downward.
When you push ”OFF” switch, the displayed
switches do not display. To display them
again, push ”ON” switch.
Touch ”Back”, the previous screen returns.