2003 TOYOTA AVENSIS Spoiler

NEW MODEL OUTLINEMO-28
EQUIPMENT LIST

: Standard OP: Option
EuropeGeneral
ENTRYMID
TECHNICALMID
ELEGANTGeneral
Countries
Exterior
Rear SpoilerWagon


Ð
Side Protection MouldingOPOPOPOP
WindshieldGreen


Ð
Front SideGreen




GlassRear Side & BackGreen



GlassRear Side & BackWagonPrivacyOPOPOPÐ
Rear QuarterWagonGreen


ÐRear QuarterWagonPrivacyOPOPOPÐ
Chassis
195/65 R153ZZ-FE & 1ZZ-FE & 1AZ-FE




205/55 R161AZ-FSE & 1CD-FTV


Ð
Tire205/55 R163ZZ-FE & 1ZZ-FE & 1AZ-FEOPOPOPOP
215/45 R171AZ-FEÐOPOPÐ215/45 R171AZ-FSEÐOPOPÐ
15 x 6J Steel3ZZ-FE & 1ZZ-FE & 1AZ-FE




16x61/2J Steel1AZ-FSE & 1CD-FTV


Ð16 x 6 1/2 J Steel3ZZ-FE & 1ZZ-FE & 1AZ-FEOPOPOPOP
Disc Wheel16 x 6 1 / 2 JJ AluminumOPOPOPOP
16 x 6 1 / 2 JJ Light Weight AluminumOPOPOPOP
17 x 7JJ Aluminum1AZ-FEÐOPOPÐ17 x 7JJ Aluminum1AZ-FSEÐOPOPÐ
ABS (Anti-lock Brake System) with EBD (Electronic Brake force Distrib\
ution)




VSC (Vehicle Stability Control) & Brake1AZ-FSEÐ

(y)Assist & TRC (Traction Control)1CD-FTVOPOPOPÐ
Wheel4-Spoke Urethane
ÐÐ
Wheel4-Spoke LeatherÐ

Ð
SteeringColumnManual Tilt & Telescopic



SteeringEPS*13ZZ-FE & 1ZZ-FE


Ð
Hydraulic Type Power
Steering1AZ-FSE & 1CD-FTV & 1AZ-FE




Body
CoverFabric



CoverLeather1AZ-FSE & 1CD-FTVÐOPOPÐ
FrontManual




SeatFrontPower1AZ-FSE & 1CD-FTVÐOPOPÐ
FixSedan
ÐÐÐ
Rear60:40 FoldingSedanÐ



60:40 Double FoldingLiftback & Wagon


Ð
SeatBelt
Front3-Point ELR*2 Electrical Sensing Type Pretensioner
& Force Limiter




BeltRear3-Point ELR*2 & ALR*3




CRS (Child Restraint System) Anchor System (Rear Outside Seat Only)




*1: Electoronic Power Steering
*2: Emergency Locking Retractor
*3: Automatic Locking Retractor
http://vnx.su

031GY±01
±
SERVICE SPECIFICATIONS EXTERIOR/INTERIOR TRIM
03±75
AVENSIS REPAIR MANUAL (RM1018E)
EXTERIOR/INTERIOR TRIM
TORQUE SPECIFICATION
Part TightenedN
mkgf
cmft
lbf
FUEL LID CONTROL ASSY
Fuel lid control assy x Body8.08271 in.
lbf
REAR BUMPER COVER
Rear bumper cover x Body5.55649 in.
lbf
Rear bumper reinforcement No. 1 x Body11.511 516
BACK DOOR GARNISH OUTSIDE
Back door garnish  Body4.95043 in.
lbf
REAR SPOILER (WAGON MODELS)
Rear spoiler  Body9.89987 in.
lbf
http://vnx.su

650T1±01
I352352Clamps
I35236
I35238
I35239
65±26
±
LIGHTING CENTER STOP LAMP ASSY
AVENSIS REPAIR MANUAL (RM1018E)
CENTER STOP LAMP ASSY
REPLACEMENT
1.REMOVE REAR SPOILER (WAGON MODELS) (See page 76±30)
2.REMOVE BACK DOOR TRIM BOARD ASSY (LIFTBACK MODELS) (See page 75±40) 3. REMOVE CENTER STOP LAMP ASSY (SEDANMODELS)
(a) Remove the center stop lamp assy as shown in the il- lustration.
(b) Disconnect the connector.
(c) Remove the center stop lamp bulb as shown in the il- lustration.
4. REMOVE CENTER STOP LAMP ASSY (WAGON MODELS)
(a) Remove the 2 screws and center stop lamp assy.
5. REMOVE CENTER STOP LAMP ASSY (LIFTBACK MODELS)
(a) Disconnect the connector.
(b) Remove the 3 screws and center stop lamp assy.
(c) Remove the center stop lamp socket and the bulb.
http://vnx.su

650SU±01
I35241
I35242
I35243
I35254
65±16
±
LIGHTINGHEADLAMP UNIT LH
AVENSIS REPAIR MANUAL (RM1018E)
REPLACEMENT
1.REMOVE FRONT SPOILER COVER LH (See page 76±3)
2.REMOVE FRONT SPOILER COVER RH (See page 76±3)
3.REMOVE FRONT BUMPER COVER (See page 76±3) 4. REMOVE HEAD LIGHT ASSY
(a) Disconnect the connector.
(b) Remove the 2 screws.
(c) Remove the headlamp assy and disengage the claw asshown in the illustration.
5. REMOVE HEADLAMP, NO.1 BULB (HALOGEN HEAD LAMP)
(a) Release the lock of the set spring and remove the head- lamp bulb No.1.
6. REMOVE DISCHARGE HEADLAMP BULB (DISCHARGE HEAD LAMP)
(a) Rotate the bulb socket cover in the direction of the arrow
and pull it of backward of the vehicle.
http://vnx.su

700T9±01
B67062
Back Door Trim Panel Assy Upper
Back Door Side Garnish RH Back Door Side Garnish LH Back Door Trim Board
Rear Spoiler

Back Door Glass
Wiper Motor Assy Rear Wiper Arm Assy
Wiper Arm Head Cap
: Specified torqueN

m (kgf
cm, ft
lbf)

Non±reusable part
5.5 (56, 49 in.
lbf)
5.5 (56, 49 in.
lbf)
70±40
±
WINDSHIELD/WINDOWGLASS/MIRROR BACK DOOR GLASS (WAGON MODELS)
AVENSIS REPAIR MANUAL (RM1018E)
BACK DOOR GLASS (WAGON MODELS)
COMPONENTS
http://vnx.su

700TA±01
B68025
Clip
Piano Wire
B69236
Protective Tape
BO4421
±
WINDSHIELD/WINDOWGLASS/MIRROR BACK DOOR GLASS (WAGON MODELS)
70±41
AVENSIS REPAIR MANUAL (RM1018E)
REPLACEMENT
HINT:
The installation is in the reverse order of the removal. However, when there is a special point concerning
the installation, it is indicated.
1.REMOVE BACK DOOR TRIM BOARD ASSY (See page 75±45)
(a) Remove the back door trim panel upper.
(b) Remove the back door side garnish LH.
(c) Remove the back door side garnish RH.
(d) Remove the back door trim board.
2.REMOVE REAR SPOILER (See page 76±30)
3.REMOVE REAR WIPER MOTOR ASSY (See page 66±17)
(a) Remove the wiper arm head cap.
(b) Remove the rear wiper arm.
(c) Remove the wiper motor.
4. REMOVE BACK DOOR GLASS
(a) Pass a piano wire between the body and glass from theinterior.
(b) Tie both wire ends to wooden blocks or similar objects.
HINT:
Apply protective tape to the outer surface to prevent the surface
from being scratched.
NOTICE:
When separating the glass, take care not to damage the
paint and interior and exterior ornaments.
(c) Cut off the adhesive by pulling the piano wire around it.
(d) Using a suction rubber, remove the glass.
NOTICE:
Leave as much adhesive on the body as possible when re-
moving the glass.
5. CLEAN BACK DOOR GLASS
(a) Clean the outer circumference of the glass with white gas- oline.
NOTICE:

Do not touch the glass surface after cleaning it.

Be careful not to damage the body.
http://vnx.su

750N7±01
B66987
Back Door Trim Panel Assy UpperBack Door Side Garnish LH
Wiper Motor Assy
Rear Spoiler
Back Door Garnish Sub±assy Outside RH Back Door Trim Board Assy
Door Pull Handle
Back Door Lock Striker
Back Door Side Garnish RH
Door Pull Handle
: Specified torque
N´m (kgf´cm, ft´lbf)
Floor Finish Plate
Rear Wiper Arm and Blade Assy
Wiper Arm Head Cap
5.5 (56, 49 in.´lbf)
Rear Wiper w/ Packing
Washer
Back Door
Stay Assy LH
7.0 (71, 62 in.´lbf)
22 (264, 19)
11.5 (120, 8)
Back Door Stay Assy RH
7.0 (71, 62 in.´lbf)
8.0 (82, 71 in.´lbf)
19.5 (200, 14)
Back Door Service Hole Cover
Back Door Lock Assy
4.9 (49, 43 in.´lbf)4.9 (49, 43 in.´lbf)
75±42
±
ENGINE HOOD/DOOR BACK DOOR (WAGON MODELS)
AVENSIS REPAIR MANUAL (RM1018E)
BACK DOOR (WAGON MODELS)
COMPONENTS
http://vnx.su

750N9±01
B66997: Clip
H19055Clip
B66998: Clip

B68469: Clip
±
ENGINE HOOD/DOORBACK DOOR(WAGON MODELS)
75±45
AVENSIS REPAIR MANUAL (RM1018E)
OVERHAUL
HINT:
The installation is in the reverse order of the removal. However, when there is a special point concerning
the installation, it is indicated.
1.REMOVE BACK DOOR TRIM PANEL ASSY UPPER
(a)Using a screwdriver, disengage the 4 clips and removethe trim panel.
HINT:
Tape the screwdriver tip before use.
2.REMOVE BACK DOOR SIDE GARNISH LH
(a)Using a screwdriver, disengage the 2 clips and remove the side garnish.
HINT:
Tape the screwdriver tip before use.
3.REMOVE BACK DOOR SIDE GARNISH RH
HINT:
Use the same procedures described for the LH side.
4.REMOVE BACK DOOR TRIM BOARD ASSY
(a)Using a screwdriver, disengage the 13 clips and remove the trim board.
HINT:
Tape the screwdriver tip before use.
(b)Remove the 3 service hole covers.
5.REMOVE DOOR PULL HANDLE
(a)Using a screwdriver, disengage the 4 claws and remove the pull handle.
6.REMOVE REAR SPOILER (See page 76±30)
7.REMOVE REAR WIPER MOTOR ASSY (See page 66±17)
8.REMOVE BACK DOOR GARNISH SUB±ASSY OUTSIDE RH (See page 76±29)
http://vnx.su