2003 SUBARU IMPREZA WRX rear view mirror

Seat, seatbelt and SRS airbags
1-49
– CONTINUED –
WARNING
Do not attach accessories to the windshield, or fit an extra-wide mirror over the rear view
mirror. If the SRS airbag deploys, those ob-jects could become projectiles that could seri-ously injure vehicle occupants.

Instruments and controls
3-30
lanes. Use the inside mirror (or glance back- wards) to determine the actual size and dis-
tance of objects that you view in convex mir-
ror.
Remote control mirror switch
1) Selection switch
2) Direction control switch
The remote control mirrors operate only when the
ignition switch is in the “ON” or “ACC” position.
1. Press either end of the selection switch, “L” for
the left, “R” for the right.
2. Move the direction control switch in the direction you want to move the mirror.
3. Return the selection switch to the neutral position
to prevent unintentional operation.
The mirrors can also be adjusted manually.
Outside mirror defogger (if equipped)
1) OFF
2) ON 3) Push
The outside mirror defogger shares the switch with
rear window defogger.
The outside mirror defogger operates only when the
ignition switch is in the “ON” position.
To turn on the outside mirror defogger, push the
switch. To turn it off, push the switch again. The indi-

Driving tips
8-34
WARNING
Adequate size trailer brakes are required
when the trailer and its cargo exceed 1,000 lbs (453 kg) total weight. Do not directly connect your trailer ’s
hydraulic brake system to the hydraulic brake
system in your vehicle. Direct connectionwould cause the vehicle ’s brake performance
to deteriorate and could lead to an accident.
Trailer safety chains
In case the trailer hitch connector or hitch ball
should break or become disconnected, the trailer
could get loose and create a traffic safety hazard.
For safety, always connect the towing vehicle and
trailer with trailer safety chains. Pass the chains
crossing each other under the trailer tongue to pre-
vent the trailer from dropping onto the ground in
case the trailer tongue should disconnect from the
hitch ball. Allow sufficient slack in the chains taking
tight-turn situations into account; however, be care-
ful not to let them drag on the ground.
For more information about the safety chain connec-
tion, refer to the instructions for your hitch and trailer.
WARNING
Always use safety chains between your ve-
hicle and the trailer. Towing a trailer withoutsafety chains could create a traffic safety haz-ard if the trailer separates from the hitch due to coupling damage or hitch ball damage.
Side mirrors
After hitching a trailer to your vehicle, check that the
standard side mirrors provide a good rearward field of view without significant blind spots. If significant blind spots occur with the vehicle ’s standard side
mirrors, use towing mirrors that conform with Fed-

Driving tips
8-36
safety’s sake, you should employ extra cau-
tion when towing a trailer and you should
never speed. You should also keep the follow-ing tips in mind:
Before starting out on a trip
Check that the vehicle and vehicle-to-hitch mount-
ing are in good condition. If any problems are
apparent, do not tow the trailer. Check that the vehicle sits horizontally with the
trailer attached. If the vehicle is tipped sharply up at
the front and down at the rear, check the total trailer
weight, GVW, GAWs and tongue load again, then
confirm that the load and its distribution are accept-able. Check that the tire pressures are correct.
Check that the vehicle and trailer are connected
properly. Confirm that
–the trailer tongue is connected properly to the
hitch ball.– the trailer lights connector is connected prop-
erly and trailer ’s brake lights illuminate when the
vehicle’ s brake pedal is pressed, and that the trail-
er’ s turn signal lights flash when the vehicle ’s turn
signal lever is operated.– the safety chains are connected properly. –
all cargo in the trailer is secured safety in posi-
tion.– the side mirrors provide a good rearward field of
view without a significant blind spot.
Sufficient time should be taken to learn the “feel”
of the vehicle/trailer combination before starting out
on a trip. In an area free of traffic, practice turning, stopping and backing up.
Driving with a trailer
You should allow for considerably more stopping
distance when towing a trailer. Avoid sudden brak-
ing because it may result in skidding or jackknifing
and loss of control. Avoid abrupt starts and sudden accelerations. If
your vehicle has a manual transmission, always start
out in first gear and release the clutch at moderate
engine revolution. Avoid uneven steering, sharp turns and rapid lane
changes. Slow down before turning. Make a longer than
normal turning radius because the trailer wheels will
be closer than the vehicle wheels to the inside of the
turn. In a tight turn, the trailer could hit your vehicle. Crosswinds will adversely affect the handling of
your vehicle and trailer, causing sway. Crosswindscan be due to weather conditions or the passing of

Specifications
12-6
Fuses and circuits Fuse panel located behind the coin trayFuse panelFuse ratingCircuit
115AHeater fan
215AHeater fan
315APower door lock
Remote keyless entry
420ACigarette lighter
Remote controlled rear view mirrors
510ATail light
Parking light
615ASRS airbag
715AFog light
820AABS solenoid
915ARadio
10Empty
1115AEngine ignition sys- tem
SRS airbag
AT control system