2003 SUBARU IMPREZA WRX child restraint

Seat, seatbelt and SRS airbags
1-14
Expectant mothers
Expectant mothers also need to use the seatbelts.
They should consult their doctor for specific recom-
mendations. The lap belt should be worn securely
and as low as possible over the hips, not over thewaist. Emergency Locking Retractor (ELR)
The driver ’s seatbelt has an Emergency Locking Re-
tractor (ELR).
The emergency locking retractor allows normal
body movement but the retractor locks automaticallyduring a sudden stop, impact or if you pull the belt very quickly out of the retractor.
Automatic/Emergency Locking Retractor (A/ELR)
Each passenger ’s seatbelt has an Automatic/Emer-
gency Locking Retractor (A/ELR). The Automatic/
Emergency Locking Retractor normally functions asan Emergency Locking Retractor (ELR). The A/ELR
has an additional locking mode “Automatic Locking
Retractor (ALR) mode ” intended to secure a child
restraint system. When the seatbelt is once drawn
out completely and is then retracted even slightly,
the retractor locks the seatbelt in that position and
the seatbelt cannot be extended. As the belt is re-
winding, clicks will be heard which indicate the re-
tractor functions as an ALR. When the seatbelt is re-
tracted fully, the ALR mode is released.
When securing a child restraint system on the rear seats by the use of the seatbelt, the seatbelt mustbe changed over to the Automatic Locking Retractor (ALR) mode.
When the child restraint system is removed, make
sure that the seatbelt retracts fully and the retractor
returned to the Emergency Locking Retractor (ELR)mode.
For instructions on how to convert the retractor to

Seat, seatbelt and SRS airbags
1-15
– CONTINUED –
the ALR mode and restore it to the ELR mode, see the “Child restraint systems ” section in this chapter.
Seatbelt warning light and chime
Your vehicle is equipped with a seatbelt warningdevice at the driver ’s seat, as required by current
safety standards.
This device causes the seatbelt warning light on the
instrument panel to light up for about six seconds
when the ignition switch is turned to “ON” to remind
the driver to wear the seatbelt. If the driver ’s seatbelt
is not fastened, a warning chime sounds at thesame time. Fastening the seatbelt
WARNING
Never use a belt that is twisted or reversed.
In an accident, this can increase the risk or
severity of injury. Keep the lap belt as low as possible on your
hips. In a collision, this spreads the force of the lap belt over stronger hip bones instead ofacross the weaker abdomen.
Seatbelts provide maximum restraint when
the occupant sits well back and upright in the
seat. To reduce the risk of sliding under the
seatbelt in a collision, the front seatbacksshould be always used in the upright position
while the vehicle is running. If the front seat-
backs are not used in the upright position in a
collision, the risk of sliding under the lap belt
and of the lap belt sliding up over the abdo-men will increase, and both can result in seri-ous internal injury or death. Do not put cushions or any other materials
between occupants and seatbacks or seat
cushions. If you do so, the risk of slidingunder the lap belt and of the lap belt slidingup over the abdomen will increase, and bothcan result in serious internal injury or death.

Seat, seatbelt and SRS airbags
1-31
– CONTINUED –
Child restraint systems
Infants and small children should always be placed
in an infant or child restraint system in the rear seat
while riding in the vehicle. You should use an infant
or child restraint system that meets Federal Motor
Vehicle Safety Standards or Canada Motor Vehicle
Safety Standards, is compatible with your vehicle
and is appropriate for the child ’s age and size. All
child restraint systems are designed to be secured
in vehicle seats by lap belts or the lap belt portion of
a lap/shoulder belt (except those covered under the section in this manual, entitled “Installation of child
restraint systems by use of lower and tether anchor-
ages”).
Children could be endangered in an accident if their
child restraints are not properly secured in the ve-
hicle. When installing the child restraint system,
carefully follow the manufacturer ’s instructions.
According to accident statistics, children are safer
when properly restrained in the rear seating posi-
tions than in the front seating positions.
All U.S. states and Canadian provinces require that
infants and small children be restrained in an
approved child restraint system at all times while the
vehicle is moving.
WARNING
Never let a passenger hold a child on his or her lap or in his or her arms while the vehicleis moving. The passenger cannot protect the child from injury in a collision, because the
child will be caught between the passengerand objects inside the vehicle.
Additionally, holding a child in your lap orarms in the front seat exposes that child to
another serious danger. Since the SRS airbag
deploys with considerable speed and force, the child could be injured or even killed.

Seat, seatbelt and SRS airbags
1-32
WARNING
Children should be properly restrained at all times. Never allow a child to stand up, or tokneel on any seat. Unrestrained children willbe thrown forward during sudden stop or in
an accident and can be injured seriously.
Additionally, children standing up or kneeling on or in front of the front seat are exposed
another serious danger. Since the SRS airbag
deploys with considerable speed and force,the child could be injured or even killed.
WARNING
Put children aged 12 and under in the rear seat properly restrained at all times. The SRSairbag deploys with considerable speed andforce and can injure or even kill children, es-
pecially if they are 12 years of age and under and are not restrained or improperly re-strained. Because children are lighter and
weaker than adults, their risk of being injured
from deployment is greater.
For that reason, be sure to secure ALL types of child restraint devices (including forward
facing child seats) in the REAR seats at all
times. You should choose a restraint devicewhich is appropriate for the child’s age, height
and weight. According to accident statistics,children are safer when properly restrained in the rear seating positions than in the front seating positions.

Seat, seatbelt and SRS airbags
1-33
– CONTINUED –
WARNING
SINCE YOUR VEHICLE IS EQUIPPED WITH A
PASSENGER’ S SRS AIRBAG, NEVER
INSTALL A REARWARD FACING CHILD SAFE-
TY SEAT IN THE FRONT PASSENGER ’S SEAT.
DOING SO RISKS SERIOUS INJURY OR
DEATH TO THE CHILD BY PLACING THE
CHILD’ S HEAD TOO CLOSE TO THE SRS AIR-
BAG.
WARNING
Child restraint systems and seatbelts can
become hot in a vehicle that has been closed up in sunny weather; they could burn a smallchild. Check the child restraint system before you place a child in it. Do not leave an unsecured child restraint
system in your vehicle. Unsecured child re-straint systems can be thrown around insideof the vehicle in a sudden stop, turn or acci-
dent; it can strike and injure vehicle occu- pants as well as result in serious injuries or death to the child.

Seat, seatbelt and SRS airbags
1-34
Installing child restraint systems with seatbelt
1. Set the child restraint system in the seating posi- tion.
2. Run the lap and shoulder belt through or around
the child restraint system following the instructions
provided by its manufacturer. If the shoulder belt
goes in front of the child ’s face or neck, put it behind
the child restraint system.
3. Insert the tongue plate into the buckle.
4. Take up the slack in the lap belt.
5. Pull out the seatbelt fully from the retractor to
change the retractor over from the Emergency Lock- ing Retractor (ELR) to the Automatic Locking Re-
tractor (ALR) function. Then, allow the belt to rewind
into the retractor. As the belt is rewinding, clicks will
be heard which indicate the retractor functions asALR.
6. Before having a child sit in the child restraint sys-
tem, move it back and forth to check if it is firmly
secured. Sometimes a child restraint can be more
firmly secured by pushing it down into the seat
cushion and then tightening the seatbelt.
7. Pull at the shoulder portion of the belt to confirm
that it cannot be pulled out (ALR properly function- ing).

Seat, seatbelt and SRS airbags
1-35
– CONTINUED –
If the child restraint system requires a top tether,
latch the hook onto the top tether anchor and tighten
the top tether. See the “Top tether anchorages ” for
additional instructions.
8. To remove the child restraint system, press the
release button on the seatbelt buckle and allow the
belt to retract completely. The belt will return to theELR mode.
If you have any question concerning this type of
child restraint system, ask your SUBARU dealer.
NOTE When the child restraint system is no longer in use, remove it and restore the ELR function of the retractor. That function is restored by allow-
ing the seatbelt to retract fully.
WARNING
When you install a child restraint system, fol- low the manufacturer
’s instructions supplied
with it. After installing the child restraint sys-tem, check to ensure that it is held securely in
position. If it is not held tight and secure, the
danger of your child suffering personal injury in the event of an accident may be increased.

Seat, seatbelt and SRS airbags
1-36
Installation of child restraint systems by use of lower and tether anchor-ages
Some types of child restraint systems can be
installed on the rear seat of your vehicle without use
of the seatbelts. Such child restraint systems are se-
cured to the designated anchorages provided on
the vehicle body. Your vehicle is equipped with four lower anchorages
(bars) and three upper anchorages (tether anchor-
ages) for accommodating such child restraint sys-tems.The lower anchorages (bars) are used for installing
a child restraint system only on the rear seat win- dow-side seating positions. For each window-side
seating position, two lower anchorages are pro-vided.