2003 SUBARU FORESTER fuel cap

8-15
Driving tips
– CONTINUED –
can change the way your vehicle handles. This
could result in loss of control and cause per-
sonal injury. Also, overloading can shorten the
life of your vehicle. Do not place anything on the extended cargo
area cover. Such items could tumble forward in
the event of a sudden stop or a collision. This
could cause serious injury.
Do not carry spray cans, containers with flam-
mable or corrosive liquids or any other danger-
ous items inside the vehicle.
NOTE
For better fuel economy, do not carry unneeded
cargo.
Vehicle capacity weight
HS8006BA
HS8024BA

8-16
Driving tips
The load capacity of your vehicle is determined by
weight, not by available cargo space. The maximum
load you can carry in your vehicle is shown as the Ve-
hicle Capacity Weight on the tire information label at-
tached to the driver’s side door jamb. It includes the
total weight of driver and all passengers and their be-
longings, any optional equipment such as a trailer
hitch, roof rack or bike carrier, etc., and the tongue
load of a trailer.
The tire information label also shows recommended
tire inflation pressure under full loading and trailer tow-
ing conditions. Adjust tire inflation pressures accord-
ing to the loading conditions. For the tire inflation
pressures, refer to the “Tires and wheels” section in
Chapter 11.

GVWR and GAWR (Gross Vehicle
Weight Rating and Gross Axle Weight
Rating)
The certification plate attached to the driver’s side
door jamb shows GVWR (Gross Vehicle Weight Rat-
ing) and GAWR (Gross Axle Weight Rating).
The GVW (Gross Vehicle Weight) must never exceed
the GVWR. GVW is the combined total of weight of the
vehicle, fuel, driver, all passengers, luggage, any op-
tional equipment and trailer tongue load. Therefore,
the GVW changes depending on the situation. The
GVWR equals Curb Weight (actual weight of your ve-
hicle – including standard equipment, fluids, emergen-
HS8007BA

11 - 1 2
Maintenance and service
result in an oil leak.
11.Close the access cover by turning it clockwise and
reinstall the six clips in their original positions.
12.Pour engine oil through the filler neck.
Oil quantity (guideline):
4.2 US qt (4.0 liters, 3.5 Imp qt)
The oil quantity indicated above is only a guideline.
The necessary quantity of oil depends on the quantity
of oil that has been drained. The quantity of drained oil
differs slightly depending on the temperature of the oil
and the time the oil is left flowing out. After pouring oil
into the engine, therefore, you must use the dipstick to
confirm that the level is correct.
13.Start the engine and make sure that no oil leaks ap-
pear around the filter’s rubber seal.
14.Run the engine until it reaches the normal operat-
ing temperature. Then stop the engine and wait a few
minutes to allow the oil drain back. Check the oil level
again and if necessary, add more engine oil.
Recommended grade and viscosity
Oil grade:
API classification SL or SJ with the words “ENER-
GY CONSERVING” (if you cannot obtain the oil
with the SL or SJ grade, you may use SH or SG
grade oil.) or the new API certification mark (Star-
burst mark) displayed on the container.
API Service label
1) Indicates the oil quality by API designations
2) Indicates the SAE oil viscosity grade
3) Indicates that the oil has fuel saving capabilities
APISERVICESL
E
NERGYCONSERVING
SAE
5W µ30
1
2
3
HSB022BB

11 -1 5
Maintenance and service
–CONTINUED –
Cooling fan, hose and connections
Your vehicle employs an electric cooling fan which is
thermostatically controlled to operate when the engine
coolant reaches a specific temperature.
If the radiator cooling fan does not operate even when
the engine coolant temperature gauge exceeds the
normal operating range, the cooling fan circuit may be
defective. Check the fuse and replace it if necessary.
If the fuse is not blown, have the cooling system
checked by your SUBARU dealer.
If frequent addition of coolant is necessary, there may
be a leak in the engine cooling system. It is recom-
mended that the cooling system and connections be
checked for leaks, damage, or looseness.
Engine coolant
Checking the coolant level
1) “FULL” level mark
2) “LOW” level mark
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside of the reser-
voir while the engine is cool.
2. If the level is close to or lower than the “LOW” level
mark, add coolant up to the “FULL” level mark. If the
reserve tank is empty, remove the radiator cap and re-
fill as required.
HSB018CB
1
2

12-4
Specifications
Capacities
Tires
Fuel tank15.9 US gal (60 liters, 13.2 Imp gal)
Engine oil4.2 US qt (4.0 liters, 3.5 Imp qt)
Transmission oilManual transmission3.7 US qt (3.5 liters, 3.1 Imp qt)
Automatic transmission9.8 US qt (9.3 liters, 8.2 Imp qt)
AT differential gear oil1.3 US qt (1.2 liter, 1.1 Imp qt)
Rear differential0.8 US qt (0.8 liter, 0.7 Imp qt)
Power steering gear fluid0.7 US qt (0.7 liter, 0.6 Imp qt)
Engine coolantManual transmission7.3 US qt (6.9 liters, 6.1 Imp qt)
Automatic transmission7.2 US qt (6.8 liters, 6.0 Imp qt)
Tire sizeP215/60R16 94H
Wheel size16 x 6 1
/2 JJ
PressureFrontLight load29 psi (200 kPa, 2.0 kg/cm 2
)
Full load29 psi (200 kPa, 2.0 kg/cm 2
)
RearLight load28 psi (190 kPa, 1.9 kg/cm 2
)
Full load36 psi (250 kPa, 2.5 kg/cm 2
)
Trailer towing41 psi (280 kPa, 2.8 kg/cm 2
)

14-4
Index
Stopping .................................................... 7-11
Exterior care ................................................... 10-2 F
Flat tires ................................................. 9-3, 9-5
Floor mat ........................................................ 6-15
Fluid level Automatic transmission ............................. 11-24
Brake ......................................................... 11-30
Clutch (MT vehicles) .................................. 11-31
Power steering ........................................... 11-29
Fog light switch ............................................... 3-21
Front differential gear oi l (AT vehicles) ........... 11-26
Front seatbelt pretensioners ........................... 1-27
Front seats ..................................................... 1-2 Fore and aft adjustment ............................. 1-3
Reclining .................................................... 1-4
Front-wheel drive warning light (AT vehicles) . 3-15
Fuel ................................................................ 7-2
Economy hints ........................................... 8-2
Filler lid and cap ........................................ 7-4
Gauge ........................................................ 3-7
Requirements ............................................ 7-2
Fuses ............................................................. 11-50
Fuses and circuits .......................................... 12-6 G
GAWR ............................................................. 8-16
Glove box ........................................................ 6-5
Gross axle weight rating .................................. 8-16
Gross vehicle weight rating ............................. 8-16
GVWR ............................................................. 8-16 H
Hazard warning flasher ................................... 3-5
Headlights ....................................................... 3-17
Headrest adjustment ....................................... 1-10
Headlight flasher ............................................. 3-18
Heater operation ............................................. 4-6
High beam indicator light ................................. 3-15
Hill holder ................................................ 7-29, 11-35
Horn ................................................................ 3-34 I
Ignition switch .................................................. 3-2
Illuminated entry .............................................. 2-8
Illumination brightness control ......................... 3-20
Indicator light ................................................... 3-9
Inside mirror .................................................... 3-29
Interior lights .................................................... 6-2

GAS STATION REFERENCE
Fuel:
Use only unleaded gasoline with an octane rat-
ing of 87 AKI or higher.
Fuel octane rating:
This octane rating is the average of the Re-
search Octane and Motor numbers and is com-
monly referred to as the Anti Knock Index
(AKI). Refer to “Fuel” section in this manual.
Fuel capacity:
15.9 US gal (60 liters, 13.2 Imp gal)
Engine oil:
Use only API classification SL or SJ with the
words “ENERGY CONSERVING” or the New
API certification mark (starburst mark) dis-
played on the container.Engine oil capacity:
4.2 US qt (4.0 liters, 3.5 Imp qt)
Cold tire pressure:
See the label located under the driver’s door
latch.