2003 SSANGYONG MUSSO Service Manual

OM600 ENGINE MECHANICAL 1B3-169
OIL FILTER1 Nut ............................................................ 25 Nm
2 Oil Filter ..................................................... Cover
3 O-Ring ................................................... Replace
4 Oil Filter ...............Element Replace If necessary
5 Oil Filter Housing 6 Bolt (M8)
.................................................... 10Nm
7 Oil Pressure Switch
8 Gasket
9 Bolt ........................................................... 25 Nm

1B3-170 OM600 ENGINE MECHANICAL
Removal & Installation Procedure
1. Remove the oil filter cover and then drain the oil.
2. Remove the oil pressure switch line.
3. Remove the oil filter housing.
4. Clean the sealing surface.
5. Installation should follow the removal procedure in thereverse order.

OM600 ENGINE MECHANICAL 1B3-171
OIL PAN1 Gasket ................................................... Replace
2 Upper Oil Pan
3 Combination Bolt ...................................... 10 Nm
4 Combination Bolt ...................................... 10 Nm
5 Gasket ................................................... Replace 6 Lower Oil Pan
7 Combination Bolt
...................................... 25 Nm
8 Drain Plug ................................................. 25 Nm
9 Washer Seal .......................................... Replace
10 Oil Pan
*Remove and install as numerical sequence. Notice Replace the washer seal with new one.
OM662LA OM661LA

1B3-172 OM600 ENGINE MECHANICAL Oil Circulation

OM600 ENGINE MECHANICAL 1B3-173
Oil Filter
a From Oil Pump
b To Main Oil Galleryc To Oil Pan

1B3-174 OM600 ENGINE MECHANICAL
OIL SPRAY NOZZLE
1 Fitting Sleeve
2 Oil Spray Nozzle
Disassembly Procedure
1. Remove oil pan or crankshaft.
2. Loose the bolt and then remove the nozzle.3 Combination Bolt ..................................... 10 Nm
A Oil Duct

OM600 ENGINE MECHANICAL 1B3-175
OIL PUMP
1 Oil Pump
2 Piston
3 Pressure Spring
4 Guide Pin5 Screw Plug
................................................ 50 Nm
6 Combination Bolt ...................................... 25 Nm
7 Oil Strainer
8 Bracket
Disassembly Procedure
1. Remove the oil pan.
2. Unscrew the mounting bolt of spracket.

1B3-176 OM600 ENGINE MECHANICAL
Tightening Torque 10 Nm
3. Unscrew the oil strainer bracket bolt.
4. Remove the oil pump.
5. Unscrew the screw plug and remove the relief valve.
6. Installation should follow the removal procedure in thereverse order.