Page 56 of 210
234a45
11 10 9 8 7
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:45-page56
1.48
INSTRUMENT PANEL(continued)
The presence and operation of the warning lights described below depend on the vehicle equipment and
country.
If the warning light comes on, you must stop as soon as traffic conditions allow.
If the warning light comes on, you should visit a Renault Dealer in the near future.
Page 57 of 210
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:45-page57
1.49
INSTRUMENT PANEL(continued)
The presence and operation of the warning lights described below depend on the vehicle equipment and
country.
9Coolant temperature
warning light
If this lights up when
the vehicle is being driven, it
indicates that the engine is
overheating. Stop and allow the
engine to run at idle speed for a
minute or two. The
temperature should drop. If it
does not, stop the engine and
check the coolant level(having
let the engine cool down).Call
for the assistance of a Renault
Dealer if necessary.
Oil pressure warning
light
It should go out as soon
as the engine starts; if it lights
up when you are driving, stop
at once, switch off the ignition
and check the oil level. If this is
normal, call for the assistance
of a Renault Dealer.9Battery charge warning
light
It should go out as soon
as the engine starts.
If it lights up when you are
driving, it indicates that the
circuit is overcharging or
discharged. Stop and have the
circuit checked.
Handbrake “on” and
brake circuit incident
warning light.
If it lights up when the brakes
are applied, it indicates that the
fluid level in the circuit is low.
It may be dangerous to
continue driving. Call for the
assistance of a Renault Dealer.10Warning lights relating to the
operation of and/or faults in
the automatic gearbox or
Quickshift 5.
Refer to the information on
automatic gearbox in section 2.
11Variable
power-assisted steering
warning light
It goes out as soon as the engine
starts. If it lights up when you
are driving, this indicates a
fault in the system. Consult
your Renault Dealer as soon as
possible.
Page 62 of 210
1
2
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:45-page62
1.54
REAR VIEW MIRRORS(continued)STEERING WHEEL
Interior rear view mirror
This is adjustable. When driving at
night, to avoid being blinded by the
headlights of a following vehicle,
lower the small lever1located
behind the rear view mirror.
Adjusting the steering wheel
On certain vehicles, the position of
the steering wheel can be adjusted.
Lift lever2and set the steering
wheel in the required position.
Lower the lever to lock the steering
wheel.
For safety reasons, only
adjust the steering
wheel when the vehicle
is stationary.
Page 63 of 210
1
2
13
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:45-page63
1.55
EXTERNAL LIGHTING AND SIGNALS
Side lights
Turn the end of stalk1to
align the symbol opposite the
mark3.
The instrument panel lights up. The
brightness of the lights can be
modified by turning wheel2,ifthis
feature is fitted to the vehicle.
Dipped beam headlights
Automatic operation
With the engine running, vehicles
fitted with alight sensor,the
dipped beam headlights light up
automatically as light begins to
fade; stalk1does not need to be
turned (position 0).
To deactivate or reactivate this
function, move the end of stalk1
twice consecutively from 0 to side
light position, with the engine
stopped and the ignition on.Automatic operation (continued)
A bleep confirms the deactivation of
this function, and two bleeps
confirm its reactivation.
Manual operation
Turn the end of stalk1until the
symbol appears opposite mark3.
An indicator light lights up on the
instrument panel in all cases.
Headlight main beam
When the dipped beam
headlights are on, turn stalk1
towards you (an indicator light
lights up on the instrument panel).
To return to the dipped headlight
position, pull the stalk towards you.
Switching off the lights
Turn the end of stalk1back
to its original position.
Before setting out to drive at night:
check that the electrical equipment is in good condition and adjust the headlight beams (if your vehicle is not
carrying its normal load). Check that the lights are not obscured (by dirt, mud, snow or objects which could
cover them).
Page 64 of 210
45
4
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:46-page64
1.56
EXTERNAL LIGHTING AND SIGNALS(continued)
Front fog lights
Turn the central ring4of
the stalk to align the symbol with
mark5.
Operation of the fog lights depends
on the external lighting selected and
a warning light will light up on the
instrument panel.
Rear fog light
Turn the central ring4
of the stalk to align the symbol with
mark5.
Operation of the rear fog light
depends on the external lighting
selected and a warning light will
light up on the instrument panel.
Remember to turn this light off
when it is no longer needed to avoid
inconveniencing other road users.The front and rear fog lights switch
off when the exterior lights are
switched off.
Special case
The front and rear fog lights do not
operate in automatic mode.
They only come on if the end of
ring1is in position or
.
Lights on warning buzzer
A warning buzzer will sound when
a front door is opened and the lights
are left on after the ignition has been
switched off (to prevent discharge
of the battery).
Page 65 of 210
A
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:46-page65
1.57
ELECTRIC HEADLIGHT BEAM ADJUSTMENT
On vehicles fitted with this
function, the tumblewheelAallows
you to adjust the height of the beams
according to load.
Turn the tumblewheelAdown to
lower the headlights and up to raise
them.Versions
All versions except utility
Utility versionTumblewheel adjustment positionsA
Position 0 or 1:basic setting, luggage
compartment empty with driver
alone or with a front passenger.
Position 2 or 3:vehicle with 5 persons
on board, luggage compartment empty.
Position 3:Vehicle luggage compartment
fully laden and driver only.
Position 4:intermediate position.
Position 0:Basic setting, vehicle unladen
Position 3:Vehicle fully laden
Positions 1, 2, 4:Intermediate positions
Page 67 of 210
1
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:46-page67
1.59
WINDSCREEN WASHER/WIPER(continued)
Windscreen washer,
headlight washers
With the ignition on, pull stalk1
towards you.
A short press triggers one sweep
cycle of the wiper, while a longer
press triggers three cycles.
•Car lights off
You activate the windscreen
washer and wiper.
This will make another sweep
after a few seconds.•Carheadlightson
Press for longer than one second
to activate the windscreen washer
and headlight washer devices
simultaneously.
In frosty weather, make sure that
the wiper blades are not stuck by
ice (risk of motor overheating).
Keep an eye on the condition of
the blades. Change the wiper
blades as soon as they become
less efficient (approximately
once a year).
If you switch off the ignition
before switching off the
windscreen wiper (positionA)
the blades will stop at random on
the windscreen.
Page 69 of 210
1
Q X B I U D B * T [ G 3 D J H
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T1.WIN 4/11/2002 13:46-page69
1.61
DE-ICING
Heated rear screen
With the engine running,
press button1(the warning light
lights up on the instrument panel).
This function ensures the de-icing
and demisting of the rear screen and
the heated external rear-view
mirrors (if the vehicle is fitted with
them).
Thefunctionisstopped:
- automatically after 15 minutes
operation,
- by pressing button1again (the
warning light goes out).
